his project was built and tested with WinAVR-20060125.
Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!!
To build the code, just install WinAVR and run "make" from the console in echomaster and
echoslave subdirs.
"make program" will program the device if you have a AVRISP attached.
Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock
from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST!
Otherwise you wont get any clock signal to the AVR and then you can t program it or reset
the fuses!
The MC1319x has default clock output of 32kHz so you will have to set your programmer to
a very low frequency (<=32kHz/4) to be able to program it while it is running on that!
A fast customizable function for locating and measuring the peaks in noisy time-series signals. Adjustable parameters allow discrimination of "real" signal peaks from noise and background.
A fast customizable function for locating and measuring the peaks in noisy time-series signals. Adjustable parameters allow discrimination of "real" signal peaks from noise and background. Determines the position, height, and width of each peak by least-squares curve-fitting.
This code was used for making the practical measurements in section 2.3 of my thesis. This Matlab code allows an OFDM signal to be generated based on an input data file. The data can be random data, a grey scale image, a wave file, or any type of file. The generated OFDM signal is stored as a windows wave file, allowing it to be viewed, listened to and manipulated in other programs. The modified wave file can then be decoded by the receiver software to extract the original data. This code was developed for the experiments that I performed in my honours thesis, and thus has not been fully debugged.
This is the original code developed for the thesis and so has several problems with it. The BER performance given by the simulations is infact Symbol Error Rate.
用Fourier變換求取信號的功率譜---周期圖法
用Fourier變換求取信號的功率譜---分段周期圖法
用Fourier變換求取信號的功率譜---welch方法
功率譜估計----多窗口法（multitaper method ,MTM法）
功率譜估計----最大熵法（maxmum entmpy method,MEM法）
功率譜估計----多信號分類法（multiple signal classification,music法）Fourier transform to strike a signal to the power spectrum - the cycle of plans
Fourier transform to strike a signal to the power spectrum - Sub-cycle Method
Fourier transform to strike a signal to the power spectrum --- welch method
Power spectrum estimated more than window ---- Law (multitaper method, MTM)
---- Power spectrum estimate of maximum entropy (maxmum entmpy method, MEM)
---- More than the estimated power spectrum signal classification (multiple signal classification, music)
漢諾塔！！！
Simulate the movement of the Towers of Hanoi puzzle Bonus is possible for using animation
eg. if n = 2 A→B A→C B→C
if n = 3 A→C A→B C→B A→C B→A B→C A→C
This file include the normalized LMS algorithm and subband LMS algorithm. all of them are in m.file
This file can be used to echo noise cancellation, and active noise control
