Flex chip implementation File: UP2FLEX JTAG jumper settings: down, down, up, up Input: Reset - FLEX_PB1 Input n - FLEX_SW switches 1 to 8 Output: Countdown - two 7-segment LEDs. Done light - decimal point on Digit1. Operation: Setup the binary input n number. Press the Reset switch. See the countdown from n down to 0 on the 7-segment LEDs. Done light lit when program terminates.
標簽： down implementation settings UP2FLEX
上傳時間： 2014-01-21
上傳用戶：sclyutian
Multi-Digital Down Converter design.
標簽： Multi-Digital Converter design Down
上傳時間： 2014-01-27
上傳用戶：離殤
Digital Down Converter Design based on FPGA.
標簽： Converter Digital Design based
上傳時間： 2016-12-16
上傳用戶：hanli8870
set（key6） left（key5） right（key4） up（key3） down（key2） OK(key1) 功能一：時鐘 時鐘計時； 按下set（一次）鍵即可調時間，此時時鐘計時停止，按left，right左右移動點，移動到需調的的數碼管， 按up，down進行數字的調節，按OK鍵保存退出。 功能二：整點報時和鬧鐘 當時鐘走到整時時，報時滴滴響四次； 按set（二次）鍵進入調節鬧鐘，此時時鐘繼續走動，按left，right左右移動點，移動到需調的的數碼管， 按up，down進行數字的調節，按OK鍵保存退出，當時鐘走到定時的時間時，蜂鳴器響。 功能三:日歷 由于數碼管有限 ，就做了潤年的日歷，剛好今年也是，左邊四個顯示月份和日，左數第五個顯分隔符“—”， 最后一個顯示星期幾，時鐘滿二十四小時，日歷隨之走動； 按下set（三次）鍵即可調日歷，按left，right左右移動點，移動到需調的的數碼管， 按up，down進行數字的調節，按OK鍵保存退出。
上傳時間： 2013-12-01
上傳用戶：cccole0605
Hello User This is nothing, but a simple program which if kept in start of windows will shut down the system by itself within five minutes of starting. It takes the time from the system & starts its timer to shut down after 5 minutes (not considering seconds). U can use shutdown.exe,once started there is only one exit that u know only. EXIT : DOUBLECLICK TIME TO ENABLE EXIT
標簽： nothing program windows simple
上傳時間： 2016-12-26
上傳用戶：ynwbosss
Hello User This is nothing, but a simple program which if kept in start of windows will shut down the system by itself within five minutes of starting. It takes the time from the system & starts its timer to shut down after 5 minutes (not considering seconds). U can use shutdown.exe,once started there is only one exit that u know only. EXIT : DOUBLECLICK TIME TO ENABLE EXIT
標簽： nothing program windows simple
上傳時間： 2014-12-20
上傳用戶：xinyuzhiqiwuwu
Hello User This is nothing, but a simple program which if kept in start of windows will shut down the system by itself within five minutes of starting. It takes the time from the system & starts its timer to shut down after 5 minutes (not considering seconds). U can use shutdown.exe,once started there is only one exit that u know only. EXIT : DOUBLECLICK TIME TO ENABLE EXIT
標簽： nothing program windows simple
上傳時間： 2016-12-26
上傳用戶：xfbs821
Hello User This is nothing, but a simple program which if kept in start of windows will shut down the system by itself within five minutes of starting. It takes the time from the system & starts its timer to shut down after 5 minutes (not considering seconds). U can use shutdown.exe,once started there is only one exit that u know only. EXIT : DOUBLECLICK TIME TO ENABLE EXIT
標簽： nothing program windows simple
上傳時間： 2016-12-26
上傳用戶：lx9076
Hello User This is nothing, but a simple program which if kept in start of windows will shut down the system by itself within five minutes of starting. It takes the time from the system & starts its timer to shut down after 5 minutes (not considering seconds). U can use shutdown.exe,once started there is only one exit that u know only. EXIT : DOUBLECLICK TIME TO ENABLE EXIT
標簽： nothing program windows simple
上傳時間： 2016-12-26
上傳用戶：yxgi5
Hello User This is nothing, but a simple program which if kept in start of windows will shut down the system by itself within five minutes of starting. It takes the time from the system & starts its timer to shut down after 5 minutes (not considering seconds). U can use shutdown.exe,once started there is only one exit that u know only. EXIT : DOUBLECLICK TIME TO ENABLE EXIT
標簽： nothing program windows simple
上傳時間： 2014-03-06
上傳用戶：ruan2570406
