When the P89LPC90x is in programming mode all pins that are not used for programming are tri-stated. During programming mode the reset pin has a weak pull-up resistor.
標簽： programming tri-stated are When
上傳時間： 2015-11-03
上傳用戶：集美慧
This book has been written to support a practically oriented course in programming language translation for senior undergraduates in Computer Science. More specifically, it is aimed at students who are probably quite competent in the art of imperative programming (for example, in C++, Pascal, or Modula-2), but whose mathematics may be a little weak students who require only a solid introduction to the subject, so as to provide them with insight into areas of language design and implementation, rather than a deluge of theory which they will probably never use again students who will enjoy fairly extensive case studies of translators for the sorts of languages with which they are most familiar students who need to be made aware of compiler writing tools, and to come to appreciate and know how to use them. It will hopefully also appeal to a certain class of hobbyist who wishes to know more about how translators work.
標簽： practically programming oriented language
上傳時間： 2013-12-10
上傳用戶：我干你啊
本系統采用電動機電樞供電回路串接采樣電阻的方式來實現對小型直流有刷電動機的轉速測量。該系統主要由二階低通濾波電路,小信號放大電路、單片機測量顯示電路、開關穩壓電源電路等組成。同時自制電機測速裝置,用高頻磁環作為載體,用線圈繞制磁環,利用電磁感應原理檢測電機運行時的漏磁,將變化的磁場信號轉化為磁環上的感應電流。用信號處理單元電路將微弱電信號轉化為脈沖信號,送由單片機檢測,從而達到準確測量電機的速度的要求。In this system, the sampling resistance of armature power supply circuit is connected in series to measure the speed of small DC brush motor. The system is mainly composed of second-order low-pass filter circuit, small signal amplifier circuit, single-chip measurement and display circuit, switching regulated power supply circuit and so on. At the same time, the self-made motor speed measuring device uses high frequency magnetic ring as the carrier, coil winding magnetic ring, and electromagnetic induction principle to detect the leakage of magnetic field during the operation of the motor, which converts the changed magnetic field signal into the induced current on the magnetic ring. The weak electric signal is transformed into pulse signal by signal processing unit circuit, which is sent to single chip computer for detection, so as to meet the requirement of accurate measurement of motor speed.
標簽： 直流電動機
上傳時間： 2022-03-26
上傳用戶：
微弱信號檢測的目的是從噪聲中提取有用信號，或用一些新技術和新方法來提高檢測系統輸出信號的信噪比。本文簡要分析了常用的微弱信號檢測理論，對小波變換的微弱信號檢測原理進行了進一步的分析。然后提出了微弱信號檢測系統的軟硬件設計，在闡述了系統的整體設計的基礎上，對電路所選芯片的結構和性能進行了簡單的介紹，選用了具有14位分辨率的4路并行A/D轉換器AD7865作為模數轉換器，且選用Xilinx公司的Spartan-3系列FPGA邏輯器件作為控制器，控制整個系統的各功能模塊。同時，利用FPGA設計了先入先出存儲器，充分利用系統資源，降低了外圍電路的復雜度，為電路調試及制板帶來了極大的方便，且提升了系統的采集速度和集成度。系統的軟件設計采用Verilog HDL語言編程，在Xilinx ISE軟件開發平臺上完成編譯和綜合，并選用ModelSim SE 6.0完成了波形仿真。關鍵詞：微弱信號檢測；信號調理：FPGA：AD7865；Verilog HDL信息時代需要獲取許多有用的信息，多數科學研究及工程應用技術所需的信息都是通過檢測的方法來獲取的。若被檢測的信號非常微弱，就很容易被噪聲湮沒，那么很難有效的從噪聲中檢測出有用信號。微弱信號在絕對意義上是指信號本身非常微弱，而在相對意義上是指信號相對于強背景噪聲而言的非常微弱，也就是指信噪比極低。人們進行長期的研究工作來檢測被噪聲所覆蓋的微弱信號，分析噪聲產生的原因以及規律，且研究被測信號的特點、相關性以及噪聲統計特性，從而研究出從背景噪聲中檢測有用信號的方法。1微弱信號檢測（weak Signal Detection）技術2.3.41主要是提高信號的信噪比，從噪聲中檢測出有用的微弱信號。對于這些微弱的被測量（如：微振動、微流量、微壓力、微溫差、弱光、弱磁、小位移、小電容等），大多數都是利用相應的傳感器將微弱信號轉換為微弱電流或者低電壓，再經過放大器將其幅度放大到預期被測量的大小。
標簽： 微弱信號檢測
上傳時間： 2022-06-18
上傳用戶：canderile
蟲蟲下載站版權所有 京ICP備2021023401號-1
