////  Copyright (c) 2003 Launchbird Design Systems, Inc.//  All rights reserved.//  //  Redistribution and use in source and binary forms, with or without modification, are permitted provided that the following conditions are met://    Redistributions of source code must retain the above copyright notice, this list of conditions and the following disclaimer.//    Redistributions in binary form must reproduce the above copyright notice, this list of conditions and the following disclaimer in the documentation and/or other materials provided with the distribution.//  //  THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES,//  INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.//  IN NO EVENT SHALL THE COPYRIGHT OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY,//  OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS;//  OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT//  (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.//  //  //  Overview://  //    Memory interleavers are often used in DSP for reordering continuous streaming data.//    The interleaver is comprised of two interleaving memories.  One memory loads and//    reorders data, while the other memory dumps the data to the output.//    Once loading and dumping of data are complete, the memories reverse roles.//    The dumping memory continuously cycles though the entire memory starting at address 0.//  //  Interface://  //    Synchronization://      clock_c  : Clock input.//  //    Inputs://      swap_i   : Swap signal to interleave memories.  Pulse occurs one frame before the switch//                 and may coincide with the last input data.//      write_i  : Write enable for input data.//      addr_i   : Address for input data.//      data_i   : Input data.//  //    Outputs://      sync_primary_o    : Output sync plus occurs one frame before data new dump.//      sync_secondary_o  : Secondary sync plus occurs one frame before data at address 0 is dumped.//      data_o            : Output data.//  //  Built In Parameters://  //    Address Width  = 10//    Data Width     = 8//  //  //  //  //  Generated by Confluence 0.6.3  --  Launchbird Design Systems, Inc.  --  www.launchbird.com//  //  Build Date : Fri Aug 22 09:32:58 CDT 2003//  //  Interface//  //    Build Name    : cf_interleaver_10_8//    Clock Domains : clock_c  //    Vector Input  : swap_i(1)//    Vector Input  : write_i(1)//    Vector Input  : addr_i(10)//    Vector Input  : data_i(8)//    Vector Output : sync_primary_o(1)//    Vector Output : sync_secondary_o(1)//    Vector Output : data_o(8)//  //  //  `timescale 1 ns / 1 nsmodule cf_interleaver_10_8 (clock_c, swap_i, write_i, addr_i, data_i, sync_primary_o, sync_secondary_o, data_o);input  clock_c;input  swap_i;input  write_i;input  [9:0] addr_i;input  [7:0] data_i;output sync_primary_o;output sync_secondary_o;output [7:0] data_o;wire   n1;wire   n2;wire   [7:0] n3;cf_interleaver_10_8_1 s1 (clock_c, swap_i, write_i, addr_i, data_i, n1, n2, n3);assign sync_primary_o = n1;assign sync_secondary_o = n2;assign data_o = n3;endmodulemodule cf_interleaver_10_8_1 (clock_c, i1, i2, i3, i4, o1, o2, o3);input  clock_c;input  i1;input  i2;input  [9:0] i3;input  [7:0] i4;output o1;output o2;output [7:0] o3;wire   n1;wire   n2;wire   s3_1;wire   s3_2;wire   [7:0] s3_3;assign n1 = 1'b1;assign n2 = 1'b0;cf_interleaver_10_8_2 s3 (clock_c, n1, n2, i1, i2, i3, i4, s3_1, s3_2, s3_3);assign o3 = s3_3;assign o2 = s3_2;assign o1 = s3_1;endmodulemodule cf_interleaver_10_8_2 (clock_c, i1, i2, i3, i4, i5, i6, o1, o2, o3);input  clock_c;input  i1;input  i2;input  i3;input  i4;input  [9:0] i5;input  [7:0] i6;output o1;output o2;output [7:0] o3;wire   [9:0] n1;wire   [9:0] n2;reg    [9:0] n3;wire   n4;reg    n5;wire   [9:0] n6;wire   n7;wire   n8;wire   [7:0] n9;reg    [9:0] n9a;reg    [7:0] n9m [1023:0];wire   n10;wire   [7:0] n11;reg    [9:0] n11a;reg    [7:0] n11m [1023:0];reg    n12;wire   [7:0] n13;wire   s14_1;assign n1 = 10'b0000000001;assign n2 = n3 + n1;initial n3 = 10'b0000000000;always @ (posedge clock_c)  if (i3 == 1'b1)    n3 <= 10'b0000000000;  else if (i1 == 1'b1)    n3 <= n2;assign n4 = ~s14_1;initial n5 = 1'b0;always @ (posedge clock_c)  if (i2 == 1'b1)    n5 <= 1'b0;  else if (i1 == 1'b1)    n5 <= i3;assign n6 = 10'b0000000000;assign n7 = n3 == n6;assign n8 = i4 & n4;initial n9a = 10'b0000000000;always @ (posedge clock_c)  if (i1 == 1'b1) begin    if (n8 == 1'b1)      n9m[i5] <= i6;    n9a <= n3;  endassign n9 = n9m[n9a];assign n10 = i4 & s14_1;initial n11a = 10'b0000000000;always @ (posedge clock_c)  if (i1 == 1'b1) begin    if (n10 == 1'b1)      n11m[i5] <= i6;    n11a <= n3;  endassign n11 = n11m[n11a];initial n12 = 1'b0;always @ (posedge clock_c)  if (i2 == 1'b1)    n12 <= 1'b0;  else if (i1 == 1'b1)    n12 <= n4;assign n13 = n12 ? n11 : n9;cf_interleaver_10_8_3 s14 (clock_c, i1, i2, i3, s14_1);assign o3 = n13;assign o2 = n7;assign o1 = n5;endmodulemodule cf_interleaver_10_8_3 (clock_c, i1, i2, i3, o1);input  clock_c;input  i1;input  i2;input  i3;output o1;wire   n1;wire   n2;wire   n3;wire   n4;wire   [1:0] n5;reg    n6;wire   s7_1;wire   s8_1;assign n1 = 1'b0;assign n2 = 1'b1;assign n3 = 1'b1;assign n4 = 1'b0;assign n5 = {i3, n6};initial n6 = 1'b0;always @ (posedge clock_c)  if (i2 == 1'b1)    n6 <= 1'b0;  else if (i1 == 1'b1)    n6 <= s7_1;cf_interleaver_10_8_5 s7 (n1, n2, n3, n4, n5, s7_1);cf_interleaver_10_8_4 s8 (n5, s8_1);assign o1 = s8_1;endmodulemodule cf_interleaver_10_8_4 (i1, o1);input  [1:0] i1;output o1;wire   n1;wire   n2;wire   [1:0] n3;wire   [1:0] n4;wire   n5;wire   n6;wire   n7;wire   n8;wire   n9;assign n1 = 1'b0;assign n2 = 1'b0;assign n3 = 2'b00;assign n4 = 2'b10;assign n5 = i1 == n3;assign n6 = i1 == n4;assign n7 = n6 ? n1 : n9;assign n8 = n5 ? n2 : n7;assign n9 = 1'b1;assign o1 = n8;endmodulemodule cf_interleaver_10_8_5 (i1, i2, i3, i4, i5, o1);input  i1;input  i2;input  i3;input  i4;input  [1:0] i5;output o1;wire   [1:0] n1;wire   [1:0] n2;wire   [1:0] n3;wire   n4;wire   n5;wire   n6;wire   n7;wire   n8;wire   n9;assign n1 = 2'b00;assign n2 = 2'b10;assign n3 = 2'b01;assign n4 = i5 == n1;assign n5 = i5 == n2;assign n6 = i5 == n3;assign n7 = n6 ? i2 : i1;assign n8 = n5 ? i3 : n7;assign n9 = n4 ? i4 : n8;assign o1 = n9;endmodule