//============================================================================
//
//        Title     : UART BAUT_INC.H 
//        Author    : JP LIU
//
//=============================================================================


// Receiver state definition

parameter	R_START 	= 3'b001,
          	R_CENTER	= 3'b010,
          	R_WAIT  	= 3'b011,
          	R_SAMPLE	= 3'b100,
		R_STOP  	= 3'b101;


// Xmitter state definition

parameter	x_IDLE		= 3'b000,
		x_START		= 3'b010,
		x_WAIT		= 3'b011,
		x_SHIFT		= 3'b100,
		x_STOP		= 3'b101;


parameter       x_STARTbit  = 2'b00,
		x_STOPbit   = 2'b01,
		x_ShiftReg  = 2'b10;


// Common parameter Definition

parameter	LO 		= 1'b0,
          	HI		= 1'b1,		
		X		= 1'bx;


//////////////////////////////////////////////
//
// Receiver Configuration
//
//////////////////////////////////////////////

// Word length.  
// This defines the number of bits in a "word". 
// Typcially 8.min=0, max=8

parameter	WORD_LEN = 8;


// The xtal-osc clock freq

//parameter XTAL_CLK = 25175000;
parameter XTAL_CLK = 53125000;


// The desired baud rate

parameter BAUD = 2400;

parameter CLK_DIV = XTAL_CLK / (BAUD * 16 * 2);


// CW >= log2(CLK_DIV)

parameter CW   = 10;


// If defined,this UART design becomes a loop-back.
// That is, whatever the UART receives,it send it back

`define DEBUG


// UART register address map definition
parameter  SEL_XMIT_DAT     = 3'b000,
	   SEL_REC_DAT      = 3'b000,
	   SEL_BAUD_REG_LO  = 3'b001,
           SEL_BAUD_REG_HI  = 3'b010,
           SEL_STAT_REG     = 3'b011,
           SEL_INT_STAT_REG = 3'b100,
           SEL_INT_ENA_REG  = 3'b101;