the handbook of antenna design backmatter
上傳時間： 2016-10-18
上傳用戶：see_it
the handbook of antenna design chapter1
上傳時間： 2016-10-18
上傳用戶：see_it
the handbook of antenna design chapter2
標簽： handbook antenna design the of
上傳時間： 2016-10-18
上傳用戶：see_it
對于超寬帶情況下的rake接收機，進行了詳細的介紹。
上傳時間： 2017-10-26
上傳用戶：靜靜dou
The rapid growth in mobile communications has led to an increasing demand for wide- band high data rate communications services. In recent years, Distributed Antenna Systems (DAS) has emerged as a promising candidate for future (beyond 3G or 4G) mobile communications, as illustrated by projects such as FRAMES and FuTURE. The architecture of DAS inherits and develops the concepts of pico- or micro-cell systems, where multiple distributed antennas or access points (AP) are connected to and con- trolled by a central unit.
標簽： Distributed Antenna Systems
上傳時間： 2020-05-27
上傳用戶：shancjb
To meet the future demand for huge traffic volume of wireless data service, the research on the fifth generation (5G) mobile communication systems has been undertaken in recent years. It is expected that the spectral and energy efficiencies in 5G mobile communication systems should be ten-fold higher than the ones in the fourth generation (4G) mobile communication systems. Therefore, it is important to further exploit the potential of spatial multiplexing of multiple antennas. In the last twenty years, multiple-input multiple-output (MIMO) antenna techniques have been considered as the key techniques to increase the capacity of wireless communication systems. When a large-scale antenna array (which is also called massive MIMO) is equipped in a base-station, or a large number of distributed antennas (which is also called large-scale distributed MIMO) are deployed, the spectral and energy efficiencies can be further improved by using spatial domain multiple access. This paper provides an overview of massive MIMO and large-scale distributed MIMO systems, including spectral efficiency analysis, channel state information (CSI) acquisition, wireless transmission technology, and resource allocation.
標簽： Large-scale Antenna Systems
上傳時間： 2020-05-27
上傳用戶：shancjb
Design of Dual Band MIMO Antenna for 5G Smartphone Application
上傳時間： 2022-02-26
上傳用戶：xsr1983
Designers of signal receiver systems often need to performcascaded chain analysis of system performancefrom the antenna all the way to the ADC. Noise is a criticalparameter in the chain analysis because it limits theoverall sensitivity of the receiver. An application’s noiserequirement has a signifi cant infl uence on the systemtopology, since the choice of topology strives to optimizethe overall signal-to-noise ratio, dynamic range andseveral other parameters. One problem in noise calculationsis translating between the various units used by thecomponents in the chain: namely the RF, IF/baseband,and digital (ADC) sections of the circuit.
上傳時間： 2014-12-05
上傳用戶：cylnpy
Abstract: Impedance mismatches in a radio-frequency (RF) electrical transmission line cause power loss andreflected energy. Voltage standing wave ratio (VSWR) is a way to measure transmission line imperfections. Thistutorial defines VSWR and explains how it is calculated. Finally, an antenna VSWR monitoring system is shown.
上傳時間： 2013-10-19
上傳用戶：yuanwenjiao
Designing read/write device (RWD) units for industrial RF-Identification applications is strongly facilitated by the NXP Semiconductors HITAG Reader Chip HTRC110. All needed function blocks, like the antenna driver, modulator demodulator and antenna diagnosis unit, are integrated in the HTRC110. Therefore only a minimum number of additional passive components are required for a complete RWD. This Application Note describes how to design an industrial RF-Identification system with the HTRC110. The major focus is dimensioning of the antenna, all other external components including clock and power supply, as well as the demodulation principle and its implementatio
上傳時間： 2013-10-22
上傳用戶：zhengjian
