The MAX3243E device consists of three line drivers, five line receivers, and a dual charge-pump circuit with±15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ±8-kV ESD (IEC61000-4-2, Contact Discharge)protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides theelectrical interface between an asynchronous communication controller and the serial-port connector. Thiscombination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, orcompatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-Vsupply. In addition, the device includes an always-active noninverting output (ROUT2B), which allowsapplications using the ring indicator to transmit data while the device is powered down. The device operates atdata signaling rates up to 250 kbit/s and a maximum of 30-V/ms driver output slew rate.
標簽： MULTICHANNEL 5.5 TO RS
上傳時間： 2013-10-19
上傳用戶：ddddddd
Internal Interrupts are used to respond to asynchronous requests from a certain part of themicrocontroller that needs to be serviced. Each peripheral in the TriCore as well as theBus Control Unit, the Debug Unit, the Peripheral Control Processor (PCP) and the CPUitself can generate an Interrupt Request.So what is an external Interrupt?An external Interrupt is something alike as the internal Interrupt. The difference is that anexternal Interrupt request is caused by an external event. Normally this would be a pulseon Port0 or Port1, but it can be even a signal from the input buffer of the SSC, indicatingthat a service is requested.The User’s Manual does not explain this aspect in detail so this ApNote will explain themost common form of an external Interrupt request. This ApNote will show that there is aneasy way to react on a pulse on Port0 or Port1 and to create with this impulse an InterruptService Request. Later in the second part of the document, you can find hints on how todebounce impulses to enable the use of a simple switch as the input device.Note: You will find additional information on how to setup the Interrupt System in theApNote “First steps through the TriCore Interrupt System” (AP3222xx)1. It would gobeyond the scope of this document to explain this here, but you will find selfexplanatoryexamples later on.
上傳時間： 2013-10-27
上傳用戶：zhangyigenius
The PL2303 USB to Serial adapter is your smart and convenient accessory forconnecting RS-232 serial devices to your USB-equipped Windows host computer. Itprovides a bridge connection with a standard DB 9-pin male serial port connector inone end and a standard Type-A USB plug connector on the other end. You simplyattach the serial device onto the serial port of the cable and plug the USB connectorinto your PC USB port. It allows a simple and easy way of adding serial connectionsto your PC without having to go thru inserting a serial card and traditional portconfiguration.This USB to Serial adapter is ideal for connecting modems, cellular phones, PDAs,digital cameras, card readers and other serial devices to your computer. It providesserial connections up to 1Mbps of data transfer rate. And since USB does not requireany IRQ resource, more devices can be attached to the system without the previoushassles of device and resource conflicts.Finally, the PL-2303 USB to Serial adapter is a fully USB Specification compliantdevice and therefore supports advanced power management such as suspend andresume operations as well as remote wakeup. The PL-2303 USB Serial cable adapteris designed to work on all Windows operating systems.
上傳時間： 2013-11-01
上傳用戶：ghostparker
基于ZedBoard和linux的應用程序HelloWorld的實現（完整工程）獲取Zedboard可運行的linux Digilent官網給出Zedboard的可運行linux設計ZedBoard_OOB_Design包，可從http://www.digilentinc.com/Data/Documents/Other/ZedBoard_OOB_Design.zip獲取，下載后解壓，可以看到包的結構和內容
標簽： HelloWorld ZedBoard linux 應用程序
上傳時間： 2013-11-03
上傳用戶：lvzhr
為了提高Linux操作系統的網絡安全性，對Linux系統的安全機制、網絡安全問題、主要攻擊方式進行了詳細分析，提出了基于Linux系統用戶管理、文件管理、預防攻擊、數據備份等切實可行的網絡安全策略，增強了Linux系統的網絡安全性，達到了較好的效果。
上傳時間： 2013-12-18
上傳用戶：weiwolkt
Linux網絡編程
上傳時間： 2013-11-11
上傳用戶：13188549192
《Linux標準學習教程》
上傳時間： 2014-12-29
上傳用戶：qq1604324866
《嵌入式Linux C語言應用程序設計》
上傳時間： 2013-12-24
上傳用戶：hanhanhan
提出Linux用戶空間下的一種高性能定時器池的實現方法。主要基于時間輪、紅黑樹及Linux內核提供了一種利于管理的定時器句柄Timerfd。結合紅黑樹、位圖、時間輪等技術，設計一種高性能級定時器池。池中定時器的粒度可達到40 ms，滿足用戶空間低延時的應用需求，同時又可以方便地管理一定數量的定時器。
上傳時間： 2014-12-29
上傳用戶：lht618
linux網絡管理員手冊
上傳時間： 2014-01-03
上傳用戶：jokey075
