計算機的ATX電源脫離主板是需要短接一下20芯接頭上的綠色（power on）和黑色（地）才能啟動的。啟動后把萬用表撥到主流電壓20V檔位，把黑表筆插入4芯D型插頭的黑色接線孔中，用紅表筆分別測量各個端子的電壓。樓上列的是20芯接頭的端子電壓，4芯D型插頭的電壓是黃色＋12V，黑色地，紅色＋5V。 主板電源接口 圖解 20-PIN ATX主板電源接口
上傳時間： 2013-10-28
上傳用戶：蔣清華嗯
Abstract: This application note illustrates an intermediate 8V switching power supply for an automotive radio and infotainment system.The design withstands the complete automotive input voltage range (including cold crank and load dump conditions), assuring a stable8V supply for common subsystems such as a CD driver, LCDs, and a radio module in modern infotainment systems. To avoiddisturbance in the AM and FM bands, the switching power supply runs at a fixed frequency of 2MHz, enabling an ideal solution forradio systems.
上傳時間： 2013-11-20
上傳用戶：feitian920
Abstract: We don't expect manufacturers to produce clothes that in one size that fits everyone. In thesame way, one ESD component can't solve all issues—each application has different ESD requirements.Knowing that "one size fits all" cannot apply to power design, the power designer, or the engineering"super hero," must consider all the potential disruptions to a steady flow of power and thenvarious waysto mitigate them. This tutorial describes voltage- and current-limiting devices and risetime reducers tomanage the power. It also points to free and low-cost software tools to help design lowpass filters, checkcapacitor self-resonance, and simulate circuits.
上傳時間： 2013-11-18
上傳用戶：zhouxuepeng1
Abstract: Impedance mismatches in a radio-frequency (RF) electrical transmission line cause power loss andreflected energy. Voltage standing wave ratio (VSWR) is a way to measure transmission line imperfections. Thistutorial defines VSWR and explains how it is calculated. Finally, an antenna VSWR monitoring system is shown.
上傳時間： 2013-10-19
上傳用戶：yuanwenjiao
Abstract: This document details the Oceanside (MAXREFDES9#) subsystem reference design, a 3.3V to 15V input,±15V (±12V) output, isolated power supply. The Oceanside design includes a high-efficiency step-up controller, a36V H-bridge transformer driver for isolated supplies, a wide input range, and adjustable output low-dropout linearregulator (LDO). Test results and hardware files are included.
上傳時間： 2013-10-12
上傳用戶：jinyao
Abstract: Some power architectures require the power supply sequencer (or system manager) to controldownstream power MOSFETs to allow power to flow into branch circuits. This application note explains howsystem power sequencing and level shifting can be accomplished using a low-voltage system manager
上傳時間： 2013-11-02
上傳用戶：wys0120
兩節鋰電充電IC-ASC8512 ASC8512 為開關型兩節鋰聚合物電池充電管理芯片，非常適合于便攜式設備的充電管理應用。ASC8512 集內置功率MOSFET、高精度電壓和電流調節器、預充、充電狀態指示和充電截止等功能于一體，采用TSSOP-14、SSOP-14兩種封裝形式。ASC8512對電池充電分為三個階段：預充（Pre-charge）、恒流（CC／Constant Current）、恒壓（CV／Constant Voltage）過程，恒流充電電流通過外部電阻決定，最大充電電流為2A.ASC8512 集成電流限制、短路保護，確保充電芯片安全工作。ASC8512 集成NTC 熱敏電阻接口，可以采集、處理電池的溫度信息，保證充電電池的安全工作溫度。 兩節鋰電池充電IC ASC8512特點： 1.充2節鋰離子和鋰聚合物電池 2.開關頻率達400K 3.充電電流最大可做2A 4.輸入電壓9V到18V 5.電池狀態檢測 6.恒壓充電電壓值可通過外接電阻微調 7.千分之五的充電電壓控制精度 5.防反向保護電路可防止電池電流倒灌 6.NTC 熱敏接口監測電池溫度 7.LED充電狀態指示 8.工作環境溫度范圍：-20℃～70℃ 9.TSSOP-14 應用領域：應用 ●手持設備，包括醫療手持設備 ●Portable-DVD，PDA，移動蜂窩電話及智能手機 ●上網本、平板電腦、MID ●自充電電池組
上傳時間： 2013-11-06
上傳用戶：chfanjiang
Abstract: There are many things to consider when designing a power supply for a field-programmablegate array (FPGA). These include (but are not limited to) the high number of voltage rails, and thediffering requirements for both sequencing/tracking and the voltage ripple limits. This application noteexplains these and other power-supply considerations that an engineer must think through whendesigning a power supply for an FPGA.
上傳時間： 2013-11-12
上傳用戶：金苑科技
交流瓦特/瓦特小時，乏爾/乏爾小時轉換器 特點： 精確度0.25%滿刻度 多種輸入,輸出選擇 輸入與輸出絕緣耐壓2仟伏特/1分鐘 沖擊電壓測試5仟伏特(1.2x50us) 突波電壓測試2.5仟伏特(0.25ms/1MHz) (IEC255-4) 尺寸小，穩定性高 主要規格： 精確度: 0.25% F.S. (23 ±5℃) 輸入負載: <0.2VA (Voltage) <0.2VA (Current) 最大過載能力: Current related input:3 x rated continuous 10 x rated 30 sec. ,25 x rated 3sec. 50 x rated 1sec. Voltage related input:maximum 2 x rated continuous 輸出反應速度: < 250ms(0~90%) 輸出負載能力: < 10mA for voltage mode < 10V for current mode 輸出之漣波 : < 0.1% F.S. 脈波輸出型態: Photocouple of open collector (max.30V/40mA) 歸零調整范圍: 0~±5% F.S. 最大值調整范圍: 0~±10% F.S. 溫度系數: 100ppm/℃ (0~50℃) 隔離特性: Input/Output/Power/Case 絕緣阻抗: >100Mohm with 500V DC 絕緣耐壓能力: 2KVac/1 min. (input/output/power/case) 突波測試: ANSI C37.90a/1974,DIN-IEC 255-4 impulse voltage 5KV(1.2x50us) 使用環境條件: -20~60℃(20 to 90% RH non-condensed) 存放環境條件: -30~70℃(20 to 90% RH non-condensed) CE認證: EN 55022:1998/A1:2000 Class A EN 61000-3-2:2000 EN 61000-3-3:1995/A1:2001 EN 55024:1998/A1:2001
上傳時間： 2013-11-11
上傳用戶：wettetw
For power electronic design
上傳時間： 2014-12-24
上傳用戶：1234321@q
