介紹基于ATmega8型單片機的溫度測量及加熱控制系統。分析系統的工作原理，詳盡討論系統的硬件電路和軟件流程。實驗證明，該系統工作可靠，穩定性高。 Abstract: The new temperature measuring and heating control system based on ATmega8 MCU is introduced.The system’s working principles is analyzed.The design principles of hardware and software are also discussed in detail.This system has been testified and it works steady and reliably.
上傳時間： 2013-11-21
上傳用戶：caiguoqing
利用Atmel公司的ATmega168微處理器，采用A/D轉換方式來實現按摩椅控制器的鍵盤接口，通過在硬件電路中巧妙地選擇電阻，在軟件設計中采用數字濾波、二分法和區間鑒定等方法，靈敏可靠地實現了按摩椅中30個按鍵的處理。給出了硬件電路設計和軟件設計思想以及部分匯編代碼。 Abstract: This paper chooses A/D conversion method to realize the keyboard interface of the controller by using ATmega168 microchip from Atmel Company.It accomplishes 30-key dealing sensitively and reliably in massage chair through skillfully selecting resistors in hardware circuit and using digital filter,dichotomy and area-judging method in software design.The hardware design circuit, software design idea and partly assembles code are presented mainly.
上傳時間： 2014-01-10
上傳用戶：咔樂塢
利用AT89C51型單片機定時和中斷功能，配以LM386型音頻功率放大器，構成了作息號音自動播放器，為學校和機關管理提供方便。 Abstract: Using timing and interrupt function of the AT89C51 single-chip microcomputer and the LM386 audio power amplifier.It is constituted the automatic bugle player.This player facilitates the institution and the school daily management.
上傳時間： 2013-10-10
上傳用戶：wivai
對于瀝青混凝土攤鋪機自動找平控制系統來說，數字式控制系統的研制是目前的一個方向。介紹了一種基于CAN總線的數字式自動找平控制系統。該系統以CAN總線作為通信方式，PWM控制信號通過C8051F040單片機內部PCA可編程計數器陣列產生，并具有結構簡單、信號穩定、實時性強、易擴展的特點。通過硬件實現和系統運行達到了比較理想的控制效果，驗證了系統的可行性。 Abstract: A digital auto-leveling control system based on CAN Bus is introduced.It uses CAN Bus as the method of communication and creates PWM signals by programmable counter array in C8051F040 microcontroller. The system is simple, stable, real-time and expansive.
上傳時間： 2013-10-09
上傳用戶：ligi201200
介紹以P87LPC764型單片機為核心的延時型漏電繼電器設計方案。該方案可供用戶選擇實現額定動作電流和5倍額定動作電流下不同的延時動作時間，并有重合閘設定選擇功能。解決了以往傳統分立元件帶來的延時時間離散性大且不易實現的弊端。 Abstract: In this paper, the delay leakage relay based on P87LPC764 is introduced in detail. This system provides different relay times at rating current and 5× rating current for users and also offers superposition brake set selection function. So that it resolves many traditional problems.
上傳時間： 2013-11-08
上傳用戶：zhaiye
介紹了CAN總線和P87C591單片機的特點，給出了基于P87C591單片機的信號采集節點的軟、硬件設計，指出了硬件電路設計中應注意的問題，在軟件設計中重點介紹了節點初始化、報文發送和報文接收等子程序。 Abstract: The features of CAN Bus and the microcontroller P87C591 are introduced, and the design of hardware circuit and soft configuration of the signals collection node based on P87C591 are presented. The problems in designing hardware circuit are discussed.Initialization subprogram, transmiting subprogram and receiving subprogram are emphasized in soft configuration.
上傳時間： 2013-11-03
上傳用戶：BIBI
以S3C825A為例介紹三星公司SAM8系列單片機的內部結構及其軟件開發環境，詳細描述采用混合編程法來對SAM8系列單片機進行軟件設計的一般方法，最后給出用混合編程法對S3C825A進行軟件設計的具體應用實例。 Abstract: With S3C825A,this paper firstly introduces the SAM8 series single-chip microcontrollers and their software development environment, then introduces mixed programming technology for SAM8 series single-chip microcontrollers. In the end, the application program is also given.
上傳時間： 2013-12-09
上傳用戶：ZZJ886
基于幅移鍵控技術ASK（Amplitude-Shift Keying），以C8051F340單片機作為監測終端控制器，C8051F330D單片機作為探測節點控制器，采用半雙工的通信方式，通過監控終端和探測節點的無線收發電路，實現數據的雙向無線傳輸。收發電路采用直徑為0.8 mm的漆包線自行繞制成圓形空心線圈天線，天線直徑為（3.4±0.3）cm。試驗表明，探測節點與監測終端的通信距離為24 cm，通過橋接方式，節點收發功率為102 mW時，節點間的通信距離可達20 cm。與傳統無線收發模塊相比，該無線收發電路在受體積、功耗、成本限制的場合有廣闊的應用前景。 Abstract: Based on ASK technology and with the C8051F340 and C8051F330D MCU as the controller， using half-duplex communication mode， this paper achieves bi-directional data transfer. Transceiver circuit constituted by enameled wire which diameter is 0.8mm and wound into a diameter （3.4±0.3） cm circular hollow coil antenna. Tests show that the communication distance between detection and monitoring of the terminal is 24cm，the distance is up to 20cm between two nodes when using the manner of bridging and the node transceiver power is 102mW. Compared with the conventional wireless transceiver modules， the circuit has wide application prospect in small size， low cost and low power consumption and other characteristics.
上傳時間： 2013-10-19
上傳用戶：xz85592677
以ＦＰＧＡ為數字邏輯平臺，借助繼電器矩陣和多路模擬開關，以ＡＤＳ１２１１為核心，在單片機控制下，聯合實現手持式虛擬／智能存儲示波表中數字多用表功能，實驗表明該設計是行之有效的。文中介紹了數字多用表的系統結構，重點討論了其測量電路和智能控制方案。 Abstract: Ｔｈｅ ｄｉｇｉｔａｌ ｍｕｌｔｉｍｅｔｅｒ ｉｎ ｖｉｒｔｕａｌ／ｉｎｔｅｌｌｅｃｔ ｄｉｇｉｔａｌ－ｏｓｃｉｌｌｏｒｇａｐｈ ｗａｓ ｆｕｌｆｉｌｌｅｄ, ｗｈｉｃｈ ｗａｓ ｃｏｎｔｒｏｌｌｅｄ ｂｙ ｓｉｎｇｌｅｃｈｉｐ ｃｏｍｐｕｔｅｒ ｂｙ ｒｅｌａｙ ｍａｔｒｉｘ ａｎｄ ａｎａｌｏｇｕｅ ｓｗｉｔｃｈｅｓ,ｉｎ ｗｈｉｃｈ ＦＰＧＡ ｗａｓ ｕｓｅｄ ｆｏｒ ｄｉｇｉｔａｌ ｌｏｇｉｃａｌ ｐｌｏｔ-ｆｏｒｍ, ＡＤＳ１２１１ ｆｏｒ ｋｅｒｎｅｌ ｃｈｉｐ, ｔｈｅ ｅｘｐｅｒｉｍｅｎｔ ｓｈｏｗｅｄ ｔｈｅ ｄｅｓｉｇｎ ｗａｓ ｆｅａｓｉｂｌｅ, ｔｈｅ ｓｙｓｔｅｍ ｓｔｒｕｃｔｉｏｎ ｗａｓ ｐｒｅｓｅｎｔ-ｅｄ ｉｎ ｔｈｅ ｐａｐｅｒ, ｍｅａｓｕｒｅ ｃｉｒｃｕｉｔ ａｎｄ ｉｎｔｅｌｌｅｃｔ ｃｏｎｔｒｏｌ ｐｌａｎ ｏｆ ｄｉｇｉｔａｌ ｍｕｌｔｉｍｅｔｅｒ ｗｅｒｅ ｍａｉｎｌｙ ｇｉｖｅｎ．
上傳時間： 2013-11-02
上傳用戶：瓦力瓦力hong
在需要實時大量輸入漢字的顯示控制處理應用中，利用傳統單片機實現顯示控制的設計方法是較難實現的。帶漢字字庫的液晶模塊的使用使得小容量ROM單片機的大量漢字信息輸入與顯示成為可能。提出了針對漢字字庫編碼的二級索引拼音輸入檢索方法,介紹了以ST7920作為控制器的帶漢字字庫的液晶顯示模塊的接口方法及漢字顯示和控制原理，給出了通用計算機鍵盤在單片機中的串行接口，采用該技術可大大增強單片機的漢字輸入功能。為小容量ROM單片機的大批量漢字信息處理提供了一種漢字輸入解決方案。 Abstract: It is difficult to realize Chinese characters input method based on the embedded system by using the traditional design method of display control. It is possible to input and display Chinese characters based on the embedded system with the ROM of small content by using the LCD module with Chinese characters.Chinese characters input method of the quadric index recall in allusion to Chinese characters code is brought forward.The interface and the principle of Chinese characters display control based on the LCD module controlled with the ST7920 is introduced too.The serial interface of the computer keyboard in common use and the embedded system is given at the same time. It can enhance the embedded system function of Chinese characters input by using this technology, and provide a kind of Chinese characters input scheme for the embedded system with small capacity ROM.
上傳時間： 2013-11-19
上傳用戶：jhksyghr
