A language monitor provides a full Duplex communications path between the print spooler and bi-directional printers that are capable of providing software-accessible status information and adds printer control information, such as commands defined by a printer job language, to the data stream s.
標簽： communications language bi-direc provides
上傳時間： 2015-03-29
上傳用戶：comua
A software Duplex UART for 8xc751 & 8cc752
標簽： software Duplex UART 8xc
上傳時間： 2014-10-30
上傳用戶：linlin
Duplex UART Routines for the 8xC751 and 8xC752 Microcontrollers
標簽： Microcontrollers 8xC Routines Duplex
上傳時間： 2013-12-12
上傳用戶：yangbo69
MSP-FET430P140 Demo - USART1, SPI Full-Duplex 3-Wire Master P1.x Exchange
標簽： Full-Duplex Exchange MSP-FET Master
上傳時間： 2013-12-26
上傳用戶：nairui21
Implementing a Quad 1200 baud Full-Duplex software UART with Salvo au1200的資料
標簽： 1200 Implementing Full-Duplex software
上傳時間： 2014-06-20
上傳用戶：李彥東
Description: This program demonstrates a half-Duplex 9600-baud UART using // Timer_A3 using no XTAL and an external resistor for DCO ROSC. DCO used for // TACLK UART baud generation. The program will wait in LPM4, echoing back // a received character using 8N1 protocol. On valid RX character, the // character is echoed back. // Using a 100k resistor on ROSC, with default DCO setting, set DCOCLK ~ 2MHz. // ACLK = n/a, MCLK = SMCLK ~2MHz DCOCLK
標簽： using demonstrates Description half-Duplex
上傳時間： 2014-01-14
上傳用戶：cuiyashuo
本例展示了如何實現2個SPI之間的在全雙工（full-Duplex）模式下通信，通過NSS軟件管理，實現了由主向從，接著又從向主發送數據。 在本例程中，設置SPI1和SPI2為8bit數據幀，9Mbit/s傳輸速率。 在第一階段，由主SPI1把SPI1_Buffer_Tx發送到SPI2，由從SPI2把SPI2_Buffer_Tx發送到SPI1。傳輸完成后，通過比較判斷傳輸是否正確。 由于NSS管腳由軟件管理，因此，可以在不改變硬件配置的情況下使SPI1由主變從，而SPI2由從變主。在第二階段，由從SPI1把SPI1_Buffer_Tx發送到SPI2，由主SPI2把SPI2_Buffer_Tx發送到SPI1。傳輸完成后，通過比較判斷傳輸是否正確。 在STM3210B-LK1上，如果以上4個傳輸都正確，則亮起LED1（LD4），否則亮起LED2（LD3）。
標簽： full-Duplex SPI 全雙工 模式
上傳時間： 2017-01-31
上傳用戶：lz4v4
pic full Duplex uart pic full Duplex uart pic full Duplex uart
標簽： Duplex full uart pic
上傳時間： 2013-12-05
上傳用戶：jcljkh
Software uart using a general purpose io and an external interrupt pin of an atmel uc. half Duplex operation, adjustable baud rate
標簽： interrupt Software external general
上傳時間： 2013-12-31
上傳用戶：zhangyigenius
The recent developments in full Duplex (FD) commu- nication promise doubling the capacity of cellular networks using self interference cancellation (SIC) techniques. FD small cells with device-to-device (D2D) communication links could achieve the expected capacity of the future cellular networks (5G). In this work, we consider joint scheduling and dynamic power algorithm (DPA) for a single cell FD small cell network with D2D links (D2DLs). We formulate the optimal user selection and power control as a non-linear programming (NLP) optimization problem to get the optimal user scheduling and transmission power in a given TTI. Our numerical results show that using DPA gives better overall throughput performance than full power transmission algorithm (FPA). Also, simultaneous transmissions (combination of uplink (UL), downlink (DL), and D2D occur 80% of the time thereby increasing the spectral efficiency and network capacity
標簽： Full-Duplex Cells Small
上傳時間： 2020-05-27
上傳用戶：shancjb
蟲蟲下載站版權所有 京ICP備2021023401號-1
