Abstract: With its small size and large load (10W) capability, the MAX13256 H-bridge transformer driver is an attractive solution forcharging supercapacitors (supercaps). However, a large capacitance on the output of the circuit can force the driver into fault modeat startup, due to the high initial charge current. This application note presents a solution that allows users to charge a largecapacitance without going into fault.
Abstract: This document details the Lakewood (MAXREFDES7#) subsystem reference design, a 3.3V input, ±12V (±15V) output, isolated power supply. The Lakewood reference design includes a 3W primary-side transformer H-bridge driver for isolated supplies, and two wide input range and adjustable output low-dropout linear regulators (LDOs). Test results and hardware files are included.
Abstract: This document details the Riverside (MAXREFDES8#) subsystem reference design, a 3.3V input, 12V (15V) output, isolated power supply. The Riverside reference design includes a 3W primary-side transformer H-bridge driver for isolated supplies, and one wide input range and adjustable output low-dropout linear regulator (LDO). Test results and hardware files are included.
Abstract: This document details the Oceanside (MAXREFDES9#) subsystem reference design, a 3.3V to 15V input,±15V (±12V) output, isolated power supply. The Oceanside design includes a high-efficiency step-up controller, a36V H-bridge transformer driver for isolated supplies, a wide input range, and adjustable output low-dropout linearregulator (LDO). Test results and hardware files are included.
AEC-Q100 qualified
? 12 V and 24 V battery systems compliance
? 3.3 V and 5 V logic compatible I/O
? 8-channel configurable MOSFET pre-driver
– High-side (N-channel and P-channel MOS)
– Low-side (N-channel MOS)
– H-bridge (up to 2 H-bridge)
– Peak & Hold (2 loads)
? Operating battery supply voltage 3.8 V to 36 V
? Operating VDD supply voltage 4.5 V to 5.5 V
? All device pins, except the ground pins, withstand at least 40 V
? Programmable gate charge/discharge currents for improving EMI behavior
在半導體制冷技術的工作性能及其優缺點研究的基礎上,設計了以單片機為核心控制元件,以TEC1-12706為執行元件的半導體制冷溫度控制系統。采用高精度分段式PID控制算法配合PWM輸出控制的方法實現溫度控制;選擇數字傳感器DS18B20為溫度檢測元件,還包含1602液晶顯示模塊、按鍵調整輸入模塊和H橋驅動模塊等。實際測試表明,該系統結構簡單易行,操作方便,工作性能優良,同時針對該系統專門設計的溫控算法,使半導體制冷器能更好地適應不同工況而充分發揮其制冷制熱工作特性。Based on the study of the performance and advantages and disadvantages of thermoelectric cooler(TEC)technology,a thermoelectric cooling temperature control system with single-chip microcomputer as the core control element and TEC1-12706 as the executive element was designed. High precision piecewise PID control algorithm combined with PWM output control method is adopted to realize temperature control. The digital sensor DS18B20 is selected as the temperature detection element. It also includes 1602 LCD module,key adjustment input module and H bridge drive module. The actual test shows that the system has simple structure,convenient operation and excellent performance. Meanwhile,the temperature control algorithm specially designed for the system can make the semiconductor cooler better adapt to different working conditions and give full play to its refrigeration and heating characteristics.
