欧美日韩国产亚洲一区,日韩午夜精品电影,交100部在线观看

I<b>AR</b> FOR AVR

PCA9537 4bit I2C bus and SMBus

The PCA9537 is a 10-pin CMOS device that provides 4 bits of General Purpose parallelInput/Output (GPIO) expansion with interrupt and reset for I2C-bus/SMBus applicationsand was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders.I/O expanders provide a simple solution when additional I/O is needed for ACPI powerswitches, sensors, push-buttons, LEDs, fans, etc.

標簽： SMBus 9537 4bit PCA

上傳時間： 2013-10-14

上傳用戶：wuchunzhong
PCA9538 8bit I2C bus and SMBus

The PCA9538 is a 16-pin CMOS device that provides 8 bits of General Purpose parallelInput/Output (GPIO) expansion with interrupt and reset for I2C-bus/SMBus applicationsand was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders.I/O expanders provide a simple solution when additional I/O is needed for ACPI powerswitches, sensors, push-buttons, LEDs, fans, etc.

標簽： SMBus 9538 8bit PCA

上傳時間： 2014-01-24

上傳用戶：youmo81
PCA9539 PCA9539R 16-bit I2C-bu

The PCA9539; PCA9539R is a 24-pin CMOS device that provides 16 bits of GeneralPurpose parallel Input/Output (GPIO) expansion with interrupt and reset forI2C-bus/SMBus applications and was developed to enhance the NXP Semiconductorsfamily of I2C-bus I/O expanders. I/O expanders provide a simple solution when additionalI/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.

標簽： 9539 PCA 9539R C-bu

上傳時間： 2013-11-10

上傳用戶：ewtrwrtwe
PCA9555 16bit I2C-bus and SMBu

The PCA9555 is a 24-pin CMOS device that provides 16 bits of General Purpose parallelInput/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed toenhance the NXP Semiconductors family of I2C-bus I/O expanders. The improvementsinclude higher drive capability, 5 V I/O tolerance, lower supply current, individual I/Oconfiguration, and smaller packaging. I/O expanders provide a simple solution whenadditional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.The PCA9555 consists of two 8-bit Configuration (Input or Output selection); Input, Outputand Polarity Inversion (active HIGH or active LOW operation) registers. The systemmaster can enable the I/Os as either inputs or outputs by writing to the I/O configurationbits. The data for each Input or Output is kept in the corresponding Input or Outputregister. The polarity of the read register can be inverted with the Polarity Inversionregister. All registers can be read by the system master. Although pin-to-pin and I2C-busaddress compatible with the PCF8575, software changes are required due to theenhancements, and are discussed in Application Note AN469.

標簽： C-bus 9555 SMBu PCA

上傳時間： 2013-11-13

上傳用戶：fredguo
DS1820 C51 子程序 (一線數據傳輸)

//芯片資料請到www.elecfans.com查找 //DS1820 C51 子程序//這里以11.0592M晶體為例，不同的晶體速度可能需要調整延時的時間//sbit DQ =P2^1;//根據實際情況定義端口 typedef unsigned char byte;typedef unsigned int word; //延時void delay(word useconds){ for(;useconds>0;useconds--);} //復位byte ow_reset(void){ byte presence; DQ = 0; //pull DQ line low delay(29); // leave it low for 480us DQ = 1; // allow line to return high delay(3); // wait for presence presence = DQ; // get presence signal delay(25); // wait for end of timeslot return(presence); // presence signal returned} // 0=presence, 1 = no part //從 1-wire 總線上讀取一個字節byte read_byte(void){ byte i; byte value = 0; for (i=8;i>0;i--) { value>>=1; DQ = 0; // pull DQ low to start timeslot DQ = 1; // then return high delay(1); //for (i=0; i<3; i++); if(DQ)value|=0x80; delay(6); // wait for rest of timeslot } return(value);} //向 1-WIRE 總線上寫一個字節void write_byte(char val){ byte i; for (i=8; i>0; i--) // writes byte, one bit at a time { DQ = 0; // pull DQ low to start timeslot DQ = val&0x01; delay(5); // hold value for remainder of timeslot DQ = 1; val=val/2; } delay(5);} //讀取溫度char Read_Temperature(void){ union{ byte c[2]; int x; }temp; ow_reset(); write_byte(0xCC); // Skip ROM write_byte(0xBE); // Read Scratch Pad temp.c[1]=read_byte(); temp.c[0]=read_byte(); ow_reset(); write_byte(0xCC); //Skip ROM write_byte(0x44); // Start Conversion return temp.x/2;}

標簽： 1820 C51 DS 程序

上傳時間： 2013-11-03

上傳用戶：hongmo
題目：利用條件運算符的嵌套來完成此題：學習成績>=90分的同學用A表示

題目：利用條件運算符的嵌套來完成此題：學習成績>=90分的同學用A表示，60-89分之間的用B表示，60分以下的用C表示。 1.程序分析：(a>b)?a:b這是條件運算符的基本例子。

標簽： gt 90 運算符嵌套

上傳時間： 2015-01-08

上傳用戶：lifangyuan12
RSA算法 :首先, 找出三個數, p, q, r, 其中 p, q 是兩個相異的質數, r 是與 (p-1)(q-1) 互質的數...... p, q, r 這三個數便是 person_key

RSA算法 :首先, 找出三個數, p, q, r, 其中 p, q 是兩個相異的質數, r 是與 (p-1)(q-1) 互質的數...... p, q, r 這三個數便是 person_key，接著, 找出 m, 使得 r^m == 1 mod (p-1)(q-1)..... 這個 m 一定存在, 因為 r 與 (p-1)(q-1) 互質, 用輾轉相除法就可以得到了..... 再來, 計算 n = pq....... m, n 這兩個數便是 public_key ，編碼過程是, 若資料為 a, 將其看成是一個大整數, 假設 a < n.... 如果 a >= n 的話, 就將 a 表成 s 進位 (s

標簽： person_key RSA 算法

上傳時間： 2013-12-14

上傳用戶：zhuyibin
隨機性發生器、冒泡分類和混洗一組12張牌的演示程序。 Demonstrates the use of a randomizer, bubble-sort and an array to "shuff

隨機性發生器、冒泡分類和混洗一組12張牌的演示程序。 Demonstrates the use of a randomizer, bubble-sort and an array to "shuffle" a deck of 12 cards. I put it here for those of you who are trying to figure out how to shuffle with a randomizer without having the same card appear two-or-more times.

標簽： Demonstrates bubble-sort randomizer array

上傳時間： 2014-01-16

上傳用戶：zhanditian
源代碼用動態規劃算法計算序列關系個數用關系"<"和"="將3個數a

源代碼\用動態規劃算法計算序列關系個數用關系"<"和"="將3個數a，b，c依次序排列時，有13種不同的序列關系： a=b=c,a=b<c,a<b=v,a<b<c,a<c<b a=c<b,b<a=c,b<a<c,b<c<a,b=c<a c<a=b,c<a<b,c<b<a 若要將n個數依序列，設計一個動態規劃算法，計算出有多少種不同的序列關系，要求算法只占用O(n),只耗時O(n*n).

標簽： lt 源代碼動態規劃序列

上傳時間： 2013-12-26

上傳用戶：siguazgb
電力系統在臺穩定計算式電力系統不正常運行方式的一種計算。它的任務是已知電力系統某一正常運行狀態和受到某種擾動

電力系統在臺穩定計算式電力系統不正常運行方式的一種計算。它的任務是已知電力系統某一正常運行狀態和受到某種擾動，計算電力系統所有發電機能否同步運行 1運行說明：請輸入初始功率S0，形如a+bi 請輸入無限大系統母線電壓V0 請輸入系統等值電抗矩陣B 矩陣B有以下元素組成的行矩陣 1正常運行時的系統直軸等值電抗Xd 2故障運行時的系統直軸等值電抗X d 3故障切除后的系統直軸等值電抗請輸入慣性時間常數Tj 請輸入時段數N 請輸入哪個時段發生故障Ni 請輸入每時段間隔的時間dt

標簽： 電力系統正計算運行

上傳時間： 2015-06-13

上傳用戶：it男一枚