頻繁INduced子樹聚類算法FREQT，很好的
上傳時間： 2016-07-04
上傳用戶：stvnash
隨著系統設計復雜性和集成度的大規模提高，電子系統設計師們正在從事100MHZ以上的電路設計，總線的工作頻率也已經達到或者超過50MHZ，有一大部分甚至超過100MHZ。目前約80% 的設計的時鐘頻率超過50MHz，將近50% 以上的設計主頻超過120MHz，有20%甚至超過500M。當系統工作在50MHz時，將產生傳輸線效應和信號的完整性問題；而當系統時鐘達到120MHz時，除非使用高速電路設計知識，否則基于傳統方法設計的PCB將無法工作。因此，高速電路信號質量仿真已經成為電子系統設計師必須采取的設計手段。只有通過高速電路仿真和先進的物理設計軟件，才能實現設計過程的可控性。傳輸線效應基于上述定義的傳輸線模型，歸納起來，傳輸線會對整個電路設計帶來以下效應。 · 反射信號Reflected signals · 延時和時序錯誤Delay & Timing errors · 過沖(上沖/下沖)Overshoot/Undershoot · 串擾INduced Noise (or crosstalk) · 電磁輻射EMI radiation
上傳時間： 2013-11-16
上傳用戶：lx9076
隨著系統設計復雜性和集成度的大規模提高，電子系統設計師們正在從事100MHZ以上的電路設計，總線的工作頻率也已經達到或者超過50MHZ，有一大部分甚至超過100MHZ。目前約80% 的設計的時鐘頻率超過50MHz，將近50% 以上的設計主頻超過120MHz，有20%甚至超過500M。當系統工作在50MHz時，將產生傳輸線效應和信號的完整性問題；而當系統時鐘達到120MHz時，除非使用高速電路設計知識，否則基于傳統方法設計的PCB將無法工作。因此，高速電路信號質量仿真已經成為電子系統設計師必須采取的設計手段。只有通過高速電路仿真和先進的物理設計軟件，才能實現設計過程的可控性。傳輸線效應基于上述定義的傳輸線模型，歸納起來，傳輸線會對整個電路設計帶來以下效應。 · 反射信號Reflected signals · 延時和時序錯誤Delay & Timing errors · 過沖(上沖/下沖)Overshoot/Undershoot · 串擾INduced Noise (or crosstalk) · 電磁輻射EMI radiation
上傳時間： 2013-11-05
上傳用戶：tzrdcaabb
Programs to induce a naive possibilistic classifier (a possibilistic analog of the naive Bayes classifier) and to classify new data with an INduced naive possibilistic classifier.
標簽： possibilistic naive classifier Programs
上傳時間： 2015-07-12
上傳用戶：蟲蟲蟲蟲蟲蟲
The algorithm ID3 (Quinlan) uses the method top-down induction of decision trees. Given a set of classified examples a decision tree is INduced, biased by the information gain measure, which heuristically leads to small trees. The examples are given in attribute-value representation. The set of possible classes is finite. Only tests, that split the set of instances of the underlying example languages depending on the value of a single attribute are supported.
標簽： algorithm induction decision top-down
上傳時間： 2017-08-20
上傳用戶：hzy5825468
Device-to-device(D2D) communications are now considered as an integral part of future 5G networks which will enable direct communication between user equipment (UE) without unnecessary routing via the network infrastructure. This architecture will result in higher throughputs than conventional cellular networks, but with the increased potential for co-channel interference INduced by randomly located cellular and D2D UEs.
標簽： Device-to-Device Communications Analysis of
上傳時間： 2020-05-26
上傳用戶：shancjb
It is commonly accepted today that optical fiber communications have revolutionized telecommunications. Indeed, dramatic changes have been INduced in the way we interact with our relatives, friends, and colleagues: we retrieve information, we entertain and educate ourselves, we buy and sell, we organize our activities, and so on, in a long list of activities. Optical fiber systems initially allowed for a significant curb in the cost of transmission and later on they sparked the process of a major rethinking regarding some, generation-old, telecommunication concepts like the (OSI)-layer definition, the lack of cross-layer dependency, the oversegmentation and overfragmentation of telecommunica- tions networks, and so on.
上傳時間： 2020-05-27
上傳用戶：shancjb
Smart antennas involve processing of signals INduced on an array of sensors such as antennas, microphones, and hydrophones. They have applications in the areas of radar, sonar, medical imaging, and communications.
上傳時間： 2020-06-01
上傳用戶：shancjb
本系統采用電動機電樞供電回路串接采樣電阻的方式來實現對小型直流有刷電動機的轉速測量。該系統主要由二階低通濾波電路,小信號放大電路、單片機測量顯示電路、開關穩壓電源電路等組成。同時自制電機測速裝置,用高頻磁環作為載體,用線圈繞制磁環,利用電磁感應原理檢測電機運行時的漏磁,將變化的磁場信號轉化為磁環上的感應電流。用信號處理單元電路將微弱電信號轉化為脈沖信號,送由單片機檢測,從而達到準確測量電機的速度的要求。In this system, the sampling resistance of armature power supply circuit is connected in series to measure the speed of small DC brush motor. The system is mainly composed of second-order low-pass filter circuit, small signal amplifier circuit, single-chip measurement and display circuit, switching regulated power supply circuit and so on. At the same time, the self-made motor speed measuring device uses high frequency magnetic ring as the carrier, coil winding magnetic ring, and electromagnetic induction principle to detect the leakage of magnetic field during the operation of the motor, which converts the changed magnetic field signal into the INduced current on the magnetic ring. The weak electric signal is transformed into pulse signal by signal processing unit circuit, which is sent to single chip computer for detection, so as to meet the requirement of accurate measurement of motor speed.
標簽： 直流電動機
上傳時間： 2022-03-26
上傳用戶：
