The Original USB 2.0 specification released on April 27, 2000
Errata to the USB 2.0 specification as of December 7, 2000
Mini-B connector Engineering Change Notice to the USB 2.0 specification.
Pull-up/pull-down Resistors Engineering Change Notice to the USB 2.0 specification.
Errata to the USB 2.0 specification as of May 28, 2002
Interface Association Descriptor Engineering Change Notice to the USB 2.0 specification.
Rounded Chamfer Engineering Change Notice to the USB 2.0 specification as of October 8, 2003
Unicode Engineering Change Notice to the USB 2.0 specification as of February 21, 2005
Inter-Chip USB Supplement Revision 1.0 as of March 13, 2006
Revision 1.3 of the USB On-The-Go Supplement as of December 5, 2006
Revision 1.01 of the Micro-USB Cables and Connectors Specification as of April 4, 2007
USB 2.0 Link Power Management Addendum Engineering Change Notice to the USB 2.0 specification as of July 16, 2007.
標簽：
specification
2.0
USB
Original
上傳時間：
2013-12-31
上傳用戶：familiarsmile
基于OFDM的無線寬帶系統仿真It contains mainly two parts, i.e. link-level simulator and system-level simulator.
Link-level simulator focus on a single-cell single-user scenario, where signal is transmitted from tx, and estimated at rx. Comparing the difference in tx/rx signal, the error rate can be found out. The output of the link-level simulator is the BLER/BER vs. SNR mapping table, that can be used for the system-level simulation.
System-level simulator focus on a multi-cell multi-user scenario. For the sake of simplicity, it takes the mapping table aquired in the link-level simulation, measure the actural SNR, and finds the corresponding error rate.
標簽：
simulator
i.e.
system-level
link-level
上傳時間：
2016-03-15
上傳用戶：xsnjzljj
