The PCA9518 is a BiCMOS integrated circuit intended forapplication in I2C and SMBus systems.While retaining all the operating modes and features of the I2Csystem, it permits extension of the I2C-bus by buffering both thedata (SDA) and the clock (SCL) Lines, thus enabling virtuallyunlimited buses of 400 pF.
標簽: Expandable 5channel 9518 PCA
上傳時間: 2013-10-23
上傳用戶:dumplin9
The PCA9519 is a 4-channel level translating I2C-bus/SMBus repeater that enables theprocessor low voltage 2-wire serial bus to interface with standard I2C-bus or SMBus I/O.While retaining all the operating modes and features of the I2C-bus system during thelevel shifts, it also permits extension of the I2C-bus by providing bidirectional buffering forboth the data (SDA) and the clock (SCL) Lines, thus enabling the I2C-bus or SMBusmaximum capacitance of 400 pF on the higher voltage side. The SDA and SCL pins areover-voltage tolerant and are high-impedance when the PCA9519 is unpowered.
標簽: 4channel transla level 9519
上傳時間: 2013-11-19
上傳用戶:jisiwole
The MC68HC05K0 is a low cost, low pin countsingle chip microcomputer with 504 bytes of userROM and 32 bytes of RAM. The MC68HC05K0 isa member of the 68HC05K series of devices whichare available in 16-pin DIL or SOIC packages.It uses the same CPU as the other devices in the68HC05 family and has the same instructions andregisters. Additionally, the device has a 15-stagemulti-function timer and 10 general purposebi-directional I/0 Lines. A mask option is availablefor software programmable pull-downs on all ofthe I/O pins and four of the pins are capable ofgenerating interrupts.The device is ideally suited for remote-controlkeyboard applications because the pull-downs andthe interrupt drivers on the port pins allowkeyboards to be built without any externalcomponents except the keys themselves. There isno need for external pull-up or pull-down resistors,or diodes for wired-OR interrupts, as these featuresare already designed into the device.
上傳時間: 2014-01-24
上傳用戶:zl5712176
The 87C576 includes two separate methods of programming theEPROM array, the traditional modified Quick-Pulse method, and anew On-Board Programming technique (OBP).Quick Pulse programming is a method using a number of devicepins in parallel (see Figure 1) and is the traditional way in which87C51 family members have been programmed. The Quick-Pulsemethod supports the following programming functions:– program USER EPROM– verify USER EPROM– program KEY EPROM– program security bits– verify security bits– read signature bytesThe Quick-Pulse method is quite easily suited to standardprogramming equipment as evidenced by the numerous vendors of87C51 compatible programmers on the market today. Onedisadvantage is that this method is not well suited to programming inthe embedded application because of the large number of signalLines that must be isolated from the application. In addition, parallelsignals from a programmer would need to be cabled to theapplication’s circuit board, or the application circuit board wouldneed to have logic built-in to perform the programming functions.These requirements have generally made in-circuit programmingusing the modified Quick Pulse method impractical in almost all87C51 family applications.
上傳時間: 2013-10-21
上傳用戶:xiaozhiqban
C++在幾乎所有的計算環境中都非常普及,而且可以用于幾乎所有的應用程序。C++從C中繼承了過程化編程的高效性,并集成了面向對象編程的功能。C++在其標準庫中提供了大量的功能。有許多商業C++庫支持數量眾多的操作系統環境和專業應用程序。但因為它的內容太多了,所以掌握C++并不十分容易。本書詳述了C++語言的各個方面,包括數據類型、程序控制、函數、指針、調試、類、重載、繼承、多態性、模板、異常和輸入輸出等內容。每一章都以前述內容為基礎,每個關鍵點都用具體的示例進行詳細的講解。本書基本不需要讀者具備任何C++知識,書中包含了理解C++的所有必要知識,讀者可以從頭開始編寫自己的C++程序。本書也適合于具備另一種語言編程經驗但希望全面掌握C++語言的讀者。 I created all the files under Microsoft Windows so Lines are terminated by CR/LF. In addition to this "ReadMe" file you will find three zip archives in the primary archive, so you need to unzip each of these to get at the code. 為PDG格式,這有pdg閱讀器下載|pdg文件閱讀器下載
標簽: 源代碼
上傳時間: 2013-11-18
上傳用戶:gaoqinwu
第一章 傳輸線理論一 傳輸線原理二 微帶傳輸線三 微帶傳輸線之不連續分析第二章 被動組件之電感設計與分析一 電感原理二 電感結構與分析三 電感設計與模擬四 電感分析與量測傳輸線理論與傳統電路學之最大不同,主要在于組件之尺寸與傳導電波之波長的比值。當組件尺寸遠小于傳輸線之電波波長時,傳統的電路學理論才可以使用,一般以傳輸波長(Guide wavelength)的二十分之ㄧ(λ/20)為最大尺寸,稱為集總組件(Lumped elements);反之,若組件的尺寸接近傳輸波長,由于組件上不同位置之電壓或電流的大小與相位均可能不相同,因而稱為散布式組件(Distributed elements)。 由于通訊應用的頻率越來越高,相對的傳輸波長也越來越小,要使電路之設計完全由集總組件所構成變得越來越難以實現,因此,運用散布式組件設計電路也成為無法避免的選擇。 當然,科技的進步已經使得集總組件的制作變得越來越小,例如運用半導體制程、高介電材質之低溫共燒陶瓷(LTCC)、微機電(MicroElectroMechanical Systems, MEMS)等技術制作集總組件,然而,其中電路之分析與設計能不乏運用到散布式傳輸線的理論,如微帶線(Microstrip Lines)、夾心帶線(Strip Lines)等的理論。因此,本章以討論散布式傳輸線的理論開始,進而以微帶傳輸線為例介紹其理論與公式,并討論微帶傳輸線之各種不連續之電路,以作為后續章節之被動組件的運用。
標簽: 傳輸線
上傳時間: 2013-11-10
上傳用戶:瀟湘書客
Calculation of the Differential Impedance of Tracks on FR4 substrates There is a discrepancy between calculated and measured values of impedance for differential transmission Lineson FR4. This is especially noticeable in the case of surface microstrip configurations. The anomaly is shown tobe due to the nature of the substrate material. This needs to be considered as a layered structure of epoxy resinand glass fibre. Calculations, using Boundary Element field methods, show that the distribution of the electricfield within this layered structure determines the apparent dielectric constant and therefore affects theimpedance. Thus FR4 cannot be considered to be uniform dielectric when calculating differential impedance.
上傳時間: 2013-10-18
上傳用戶:masochism
給出了一種運動人體區域的檢測及其對應的二維關鍵點的提取方法。首先運用幀差法構建一個自適應的背景模型以達到背景初始化和背景更新的目的。接著用減背景法實現二維運動人體區域的檢測。最后將檢測到的運動人體區域,通過運用APAR(anti-paralle Lines)區域法實現對運動人體關鍵點的提取。
上傳時間: 2013-10-25
上傳用戶:lz4v4
The high defi nition multimedia interface (HDMI) is fastbecoming the de facto standard for passing digitalaudio and video data in home entertainment systems.This standard includes an I2C type bus called a displaydata channel (DDC) that is used to pass extended digitalinterface data (EDID) from the sinkdevice (such as adigital TV) to the source device (such as a digital A/Vreceiver). EDID includes vital information on the digitaldata formats that the sink device can accept. The HDMIspecifi cation requires that devices have less than 50pFof input capacitance on their DDC bus Lines, which canbe very diffi cult to meet. The LTC®4300A’s capacitancebuffering feature allows devices to pass the HDMI DDCinput capacitance compliance test with ease.
上傳時間: 2013-11-21
上傳用戶:tian126vip
Tug of War(A tug of war is to be arranged at the local office picnic. For the tug of war, the picnickers must be divided into two teams. Each person must be on one team or the other the number of people on the two teams must not differ by more than 1 the total weight of the people on each team should be as nearly equal as possible. The first line of input contains n the number of people at the picnic. n Lines follow. The first line gives the weight of person 1 the second the weight of person 2 and so on. Each weight is an integer between 1 and 450. There are at most 100 people at the picnic. Your output will be a single line containing 2 numbers: the total weight of the people on one team, and the total weight of the people on the other team. If these numbers differ, give the lesser first. )
上傳時間: 2014-01-07
上傳用戶:離殤