PW2205 develops a high efficiency synchronous step-down DC-DC converter capable of delivering5A output current. PW2205 operates over a wide input voltage range from 4.5V to 30V andintegrates main switch and synchronous switch with very low RDS(ON) to minimize the conductionloss.PW2205 adopts the instant PWM architecture to achieve fast transient responses for high step downapplications and high efficiency at light loads. In addition, it operates at pseudo-constant frequencyof 500kHz under continuous conduction mode to minimize the size of inductor and capacitor
標簽： pw2205
上傳時間： 2022-02-11
上傳用戶：
The PW2163 is a high efficiency 500 kHz synchronous step-down DC-DC converter capable ofdelivering 3A current. The PW2163 operates over a wide input voltage range from 4.5V to 18V andintegrates main switch and synchronous switch with very low RDS(ON) to minimize the conductionloss. Low output voltage ripple and small external inductor and capacitor sizes are achieved with 500kHz switching frequency. It adopts the instant PWM architecture to achieve fast transient responsesfor high step down applications
標簽： pw2163
上傳時間： 2022-02-11
上傳用戶：
The PW2053 is a high-efficiency monolithic synchronous buck regulator using a constantfrequency, current mode architecture. The device is available in an adjustable version. Supply currentwith no load is 40uA and drops to <1uA in shutdown. The 2.5V to 5.5V input voltage range makesthe PW2053 ideally suited for single Li-Ion battery powered applications. 100% duty cycle provideslow dropout operation, extending battery life in portable systems. PWM/PFM mode operationprovides very low output ripple voltage for noise sensitive applications. Switching frequency isinternally set at 1.2MHz, allowing the use of small surface mount inductors and capacitors. Lowoutput voltages are easily supported with the 0.6V feedback reference voltage
標簽： pw2053
上傳時間： 2022-02-14
上傳用戶：jason_vip1
PW1555 is a programmable current limit switch with input voltage range selection and outputvoltage clamping. Extremely low RDS(ON) of the integrated protection N-channel FET helps toreduce power loss during the normal operation. Programmable soft-start time controls the slew rateof the output voltage during the start-up time. Independent enable control allows the complicatedsystem sequencing control. It integrates the over-temperature protection shutdown andautorecovery with hystersis
標簽： pw1555
上傳時間： 2022-02-14
上傳用戶：
The PW8205A6S uses advanced trench technology to provide excellent RDS(ON), low gate chargeand operation with gate voltages as low as 2.5V. This device is suitable for use as a Battery protectionor in other Switching application.
標簽： 8205a6
上傳時間： 2022-02-14
上傳用戶：
ADC模數轉換器件Altium Designer AD原理圖庫元件庫SV text has been written to file : 4.4 - ADC模數轉換器件.csvLibrary Component Count : 29Name Description----------------------------------------------------------------------------------------------------ADC0800 National 8-Bit Analog to Digital ConverterADC0809 ADC0831 ADCADC0832 ADC8 Generic 8-Bit A/D ConverterCLC532 High-Speed 2:1 Analog MultiplexerCS5511 National 16-Bit Analog to Digital ConverterDAC8 Generic 8-Bit D/A ConverterEL1501 Differential line Driver/ReceiverEL2082 Current-Mode MultiplierEL4083 Current Mode Four Quadrant MultiplierEL4089 DC Restored Video AmplifierEL4094 Video Gain Control/FaderEL4095 Video Gain Contol/Fader/MultiplexerICL7106 LMC6953_NSC PCI Local Bus Power SupervisorMAX4147 300MHz, Low-Power, High-Output-Current, Differential Line DriverMAX4158 350MHz 2-Channel Video Multiplexer-AmplifierMAX4159 350MHz 2-Channel Video Multiplexer-AmplifierMAX4258 250MHz, 2-Channel Video Multiplexer-AmplifierMAX4259 250MHz 2-Channel Video Multiplexer-AmplifierMAX951 Ultra-Low-Power, Single-Supply Op Amp + Comparator + ReferenceMAX952 Ultra-Low-Power, Single-Supply Op Amp + Comparator + ReferenceMC1496 Balanced Modulator/DemodulatorPLL100k Generic Phase Locked LoopPLL10k Generic Phase Locked LoopPLL5k Generic Phase Locked LoopPLLx Generic Phase Locked Loop水位計
標簽： adc 模數轉換 altium designer
上傳時間： 2022-03-13
上傳用戶：
本系統采用電動機電樞供電回路串接采樣電阻的方式來實現對小型直流有刷電動機的轉速測量。該系統主要由二階低通濾波電路,小信號放大電路、單片機測量顯示電路、開關穩壓電源電路等組成。同時自制電機測速裝置,用高頻磁環作為載體,用線圈繞制磁環,利用電磁感應原理檢測電機運行時的漏磁,將變化的磁場信號轉化為磁環上的感應電流。用信號處理單元電路將微弱電信號轉化為脈沖信號,送由單片機檢測,從而達到準確測量電機的速度的要求。In this system, the sampling resistance of armature power supply circuit is connected in series to measure the speed of small DC brush motor. The system is mainly composed of second-order low-pass filter circuit, small signal amplifier circuit, single-chip measurement and display circuit, switching regulated power supply circuit and so on. At the same time, the self-made motor speed measuring device uses high frequency magnetic ring as the carrier, coil winding magnetic ring, and electromagnetic induction principle to detect the leakage of magnetic field during the operation of the motor, which converts the changed magnetic field signal into the induced current on the magnetic ring. The weak electric signal is transformed into pulse signal by signal processing unit circuit, which is sent to single chip computer for detection, so as to meet the requirement of accurate measurement of motor speed.
標簽： 直流電動機
上傳時間： 2022-03-26
上傳用戶：
CAN總線是汽車上應用最廣泛的車載網絡總線,具有實時性強、可靠性高、成本低等優點。鑒于此,介紹了一種利用飛思卡爾系列單片機MC9S12XS128作為控制器,利用其內部的MSCAN模塊、CAN收發器TJA1040等外圍元件進行CAN總線通信節點設計。該設計能夠實現CAN總線數據的發送與接收,可應用于汽車及其他各種CAN總線通信系統。CAN bus is the most widely used on-board network bus in automobiles. It has the advantages of realtime, high reliability and low cost. In view of this,this paper introduces the design of CAN bus communication node by using Freescale MC9S12XS128 as controller,using its internal MSCAN module,CAN transceiver TJA1040 and other peripheral components. This design can realize the sending and receiving of CAN bus data,and can be used in automobile and other CAN bus communication systems.
上傳時間： 2022-03-27
上傳用戶：
數字示波器功能強大,使用方便,但是價格相對昂貴。本文以Ti的MSP430F5529為主控器,以Altera公司的EP2C5T144C8 FPGA器件為邏輯控制部件設計數字示波器。模擬信號經程控放大、整形電路后形成方波信號送至FPGA測頻,根據頻率值選擇采用片上及片外高速AD分段采樣。FPGA控制片外AD采樣并將數據輸入到FIFO模塊中緩存,由單片機進行頻譜分析。測試表明:簡易示波器可以實現自動選檔、多采樣率采樣、高精度測頻及頻譜分析等功能。Digital oscilloscope is powerful and easy to use, but also expensive. The research group designed a low-cost digital oscilloscope, the chip of MSP430F5529 of TI is chosen as the main controller and the device of EP2C5T144C8 of Altera company is used as the logic control unit. Analog signal enter the programmable amplifier circuit, shaping circuit and other pre-processing circuit. The shaped rectangular wave signal is sent to FPGA for measure the frequency. According to the frequency value to select AD on-chip or off-chip high-speed AD for sampling. FPGA controls the off-chip AD sampling and buffers AD data by FIFO module. The single chip microcomputer receives the data, and do FFT for spectrum analysis. The test shows that the simple oscilloscope can realize automatic gain selection, sampling at different sampling rates, high precision frequency measurement and spectrum analysis.
上傳時間： 2022-03-27
上傳用戶：
文章提出了一種基于AT89S51單片機的智能家居系統的設計,該系統具有室內煤氣以及煙霧的檢測、家庭室內防盜等功能。文章詳細分析了系統的總體設計,詳盡分析并設計了煤氣傳感器模塊、煙霧傳感器模塊、人體紅外感應傳感器模塊、報警模塊等各硬件部分,并利用PROTUES軟件進行了系統仿真。仿真結果證明:系統具有成本低、效率高、操作方便等優點,達到了預期設計的效果。This paper presents the design of an intelligent home system based on AT89S51 microcontroller.The system has the functions of detecting indoor gas and smoke,guarding against theft in the home,and so on.The overall design of the system is analyzed in detail.The gas sensor module,smoke sensor module,human infrared sensor module,alarm module and other hardware parts are analyzed and designed in detail,and the system simulation is carried out using PROTUES software.The simulation results show that the system has the advantages of low cost,high efficiency,convenient operation and so on,and achieves the expected design effect.
上傳時間： 2022-03-28
上傳用戶：
