在現代通信系統中,電話語音的頻帶被限制在300 Hz~4 kHz的范圍內,帶來了語音可懂度和自然度的降低。為了在不增加額外成本的前提下提高語音的可懂度和自然度,進行了電話語音頻帶擴展的研究。提出了一種改進的基于碼本映射的語音帶寬擴展算法:在碼本映射的過程中,使用加權系數來得到映射碼本。客觀測試結果表明,用此算法得到的寬帶語音的譜失真度比用一般的碼本映射降低至少2%。主觀測試結果表明,用此算法得到的寬帶語音具有更好的可懂度和自然度。 Abstract: In modern communication systems, the bandwidth of telephone speech is limited from 300Hz to 4 kHz, which reduces the intelligibility and naturalness of speech. Telephone speech bandwidth extension is researched to get wideband speech and to improve its intelligibility and naturalness, without increasing extra costs. This paper put forward an improved algorithm of speech bandwidth extension based on codebook mapping. In the process of codebook mapping, weighted coefficients were used to get mapping codebook. Objective tests show that spectral distortion of wideband speech obtained by this algorithm reduces at least 2%, comparing to conditional codebook mapping. Subjective tests show that the wideband speech obtained by this algorithm has better intelligibility and naturalness.
上傳時間: 2014-12-29
上傳用戶:15501536189
稀疏表示分類算法(Sparse Representation-based Classification,SRC)在人臉數據庫上有很高的識別性能。然而,對于姿態變化,SRC的識別效果并不理想。針對SRC算法不能解決測試樣本與訓練樣本存在偏移誤差的問題,本文提出了基于SRC的改進算法。該算法將每一類的訓練樣本單獨作為訓練字典,利用迭代校正和基于金字塔分層機構的運動偏移估計方法得到最終的偏移量,最后對校正后的測試樣本使用SRC算法實現分類。實驗結果表明該方法對于有偏移誤差的人臉圖像具有較好的魯棒性及識別率。
上傳時間: 2013-11-15
上傳用戶:haiya2000
Abstract: The 1-Wire product family includes numerous devices that can be easily evaluated using a Windows®-based
上傳時間: 2013-10-12
上傳用戶:fudong911
This is the Xilinx Dual Processor Reference Designs suite. The designs illustrate a few differentdual-core architectures based on the MicroBlaze™ and PowerPC™ processors. The designsillustrate various concepts described in the Xilinx White Paper WP262 titled, “DesigningMultiprocessor Systems in Platform Studio”. There are simple software applications includedwith the reference designs that show various forms of interaction between the two processors.
上傳時間: 2013-10-29
上傳用戶:旭521
The LPC2292/2294 microcontrollers are based on a 16/32-bit ARM7TDMI-S CPU with real-time emulation and embedded trace support, together with 256 kB of embedded high-speed flash memory. A 128-bit wide memory interface and a unique accelerator architecture enable 32-bit code execution at the maximum clock rate. For critical code size applications, the alternative 16-bit Thumb mode reduces code by more than 30 pct with minimal performance penalty. With their 144-pin package, low power consumption, various 32-bit timers, 8-channel 10-bit ADC, 2/4 (LPC2294) advanced CAN channels, PWM channels and up to nine external interrupt pins these microcontrollers are particularly suitable for automotive and industrial control applications as well as medical systems and fault-tolerant maintenance buses. The number of available fast GPIOs ranges from 76 (with external memory) through 112 (single-chip). With a wide range of additional serial communications interfaces, they are also suited for communication gateways and protocol converters as well as many other general-purpose applications. Remark: Throughout the data sheet, the term LPC2292/2294 will apply to devices with and without the /00 or /01 suffix. The suffixes /00 and /01 will be used to differentiate from other devices only when necessary.
上傳時間: 2014-12-30
上傳用戶:aysyzxzm
The main objective of this book is to present all the relevant informationrequired for RF and micro-wave power amplifier design includingwell-known and novel theoretical approaches and practical design techniquesas well as to suggest optimum design approaches effectively combininganalytical calculations and computer-aided design. This bookcan also be very useful for lecturing to promote the analytical way ofthinking with practical verification by making a bridge between theoryand practice of RF and microwave engineering. As it often happens, anew result is the well-forgotten old one. Therefore, the demonstrationof not only new results based on new technologies or circuit schematicsis given, but some sufficiently old ideas or approaches are also introduced,that could be very useful in modern practice or could contributeto appearance of new ideas or schematic techniques.
標簽: Amplifier Microwave Design Power
上傳時間: 2013-12-22
上傳用戶:vodssv
Abstract: This article discusses the benefits of a G3-PLC-based automation system and presents a real-world example of a systemfor reducing energy usage and lowering maintenance costs in tunnels. The basic system design is explained and key performance
上傳時間: 2013-10-29
上傳用戶:康郎
Abstract: Engineers often wish that radio susceptibility (RS) or radio immunity could be cured with an antibiotic, a vaccine, or someform of cure-all. Unfortunately, solving the RS problem is not that easy. Indeed, the laws of physics apply. In this article we discusssources of RS. We also offer tips and hints to protect systems, power supplies, printed circuit boards (PCBs), and electroniccomponents from radio frequency interference.
標簽: Susceptibility Radio 無線電干擾
上傳時間: 2014-12-30
上傳用戶:旗魚旗魚
在研究傳統家用燃氣報警器的基礎上,以ZigBee協議為平臺,構建mesh網狀網絡實現網絡化的智能語音報警系統。由于傳感器本身的溫度和實際環境溫度的影響,傳感器標定后采用軟件補償方法。為了減少系統費用,前端節點采用半功能節點設備,路由器和協調器采用全功能節點設備,構建mesh網絡所形成的家庭內部報警系統,通過通用的電話接口連接到外部的公用電話網絡,啟動語音模塊進行報警。實驗結果表明,在2.4 GHz頻率下傳輸,有墻等障礙物的情況下,節點的傳輸距離大約為35 m,能夠滿足家庭需要,且系統工作穩定,但在功耗方面仍需進一步改善。 Abstract: On the basis of studying traditional household gas alarm system, this paper proposed the platform for the ZigBee protocol,and constructed mesh network to achieve network-based intelligent voice alarm system. Because of the sensor temperature and the actual environment temperature, this system design used software compensation after calibrating sensor. In order to reduce system cost, semi-functional node devices were used as front-end node, however, full-function devices were used as routers and coordinator,constructed alarm system within the family by building mesh network,connected to the external public telephone network through the common telephone interface, started the voice alarm module. The results indicate that nodes transmit about 35m in the distance in case of walls and other obstacles by 2.4GHz frequency transmission, this is able to meet family needs and work steadily, but still needs further improvement in power consumption.
上傳時間: 2013-10-30
上傳用戶:swaylong
為滿足無線網絡技術具有低功耗、節點體積小、網絡容量大、網絡傳輸可靠等技術要求,設計了一種以MSP430單片機和CC2420射頻收發器組成的無線傳感節點。通過分析其節點組成,提出了ZigBee技術中的幾種網絡拓撲形式,并研究了ZigBee路由算法。針對不同的傳輸要求形式選用不同的網絡拓撲形式可以盡大可能地減少系統成本。同時針對不同網絡選用正確的ZigBee路由算法有效地減少了網絡能量消耗,提高了系統的可靠性。應用試驗表明,采用ZigBee方式通信可以提高傳輸速率且覆蓋范圍大,與傳統的有線通信方式相比可以節約40%左右的成本。 Abstract: To improve the proposed technical requirements such as low-ower, small nodes, large capacity and reliable network transmission, wireless sensor nodes based on MSP430 MCU and CC2420 RF transceiver were designed. This paper provided network topology of ZigBee technology by analysing the component of the nodes and researched ZigBee routing algorithm. Aiming at different requirements of transmission mode to choose the different network topologies form can most likely reduce the system cost. And aiming at different network to choose the correct ZigBee routing algorithm can effectively reduced the network energy consumption and improved the reliability of the system. Results show that the communication which used ZigBee mode can improve the transmission rate, cover more area and reduce 40% cost compared with traditional wired communications mode.
上傳時間: 2013-10-09
上傳用戶:robter