Finite state machines are widely used in digital circuit designs. Generally, when designing a state machine using an HDL, the synthesis tools will optimize away all states that cannot be reached and generate a highly optimized circuit. Sometimes, however, the optimization is not acceptable. For example, if the circuit powers up in an invalid state, or the circuit is in an extreme working environment and a glitch sends it into an undesired state, the circuit may never get back to its normal operating condition.
標簽： Creating Machines Mentor State
上傳時間： 2013-10-08
上傳用戶：wangzhen1990
介紹高速電路的設計
標簽： High-speed Digital Design 高速數字
上傳時間： 2013-10-16
上傳用戶：yt1993410
Arduino，是一塊基于開放源代碼的USB接口Simple i/o接口板（包括12通道數字GPIO，4通道PWM輸出，6-8通道10bit ADC輸入通道），并且具有使用類似Java,C語言的IDE集成開發環境。 讓您可以快速使用Arduino語言與Flash或Processing…等軟件，作出互動作品。 Arduino可以使用開發完成的電子元件例如Switch或sensors或其他控制器、LED、步進馬達或其他輸出裝置。Arduino也可以獨立運作成為一個可以跟軟件溝通的接口，例如說：flash、processing、Max/MSP、VVVV 或其他互動軟件…。Arduino開發IDE接口基于開放源代碼原，可以讓您免費下載使用開發出更多令人驚艷的互動作品。 特色： 1、開放源代碼的電路圖設計，程序開發接口免費下載，也可依需求自己修改。 2、使用低價格的微處理控制器(ATMEGA8或ATmega128)。可以采用USB接口供電，不需外接電源。也可以使用外部9VDC輸入 3、Arduino支持ISP在線燒，可以將新的“bootloader”固件燒入ATmega8或ATmega128芯片。有了bootloader之后，可以通過串口或者USB to Rs232線更新固件。 4、可依據官方提供的Eagle格式PCB和SCH電路圖，簡化Arduino模組，完成獨立運作的微處理控制。可簡單地與傳感器，各式各樣的電子元件連接(EX：紅外線,超音波,熱敏電阻,光敏電阻,伺服馬達,…等) 5、支持多種互動程序，如：Flash、Max/Msp、VVVV、PD、C、Processing……等 6、應用方面，利用Arduino，突破以往只能使用鼠標，鍵盤，CCD等輸入的裝置的互動內容，可以更簡單地達成單人或多人游戲互動。
標簽： Arduino
上傳時間： 2013-11-24
上傳用戶：bvdragon
針對TI公司最新發布的TMS320C6678 DSP設計出一種實用有效的電源。采用統一的12 V電源供電，制作出滿足電壓幅值要求與時序要求的開關電源。該設計主要由各類電源轉換電路組成，并通過使用Fusion Digital Power Designer軟件對電源芯片進行編程。仿真結果表明，該電源工作穩定，各方面的參數均符合要求。
上傳時間： 2013-10-12
上傳用戶：asdstation
Abstract: A resistive feedback network is often used to set the output voltage of a power supply. A mechanical potentiometer (pot)conveniently solves the problem of adjusting a power supply. For easier automatic calibration, a mechanical pot can be replaced witha digital pot. This application note presents a calibration solution that uses a digital pot, because digipots are smaller, do not movewith age or vibration, and can be recalibrated remotely. This proposed solution reduces the susceptibility of the system to thetolerance of the digital pot's end-to-end resistance, making the solution optimal fordesigners. This application note also explainssome of the equations required to calculate the resistor chain values and to use a digital pot in this way. A spreadsheet withstandard reisistor values is available for easy calculations.
標簽： 電源供應器 數字電位器 應用筆記 校準
上傳時間： 2013-10-31
上傳用戶：caiguoqing
Abstract: Field-programmable gate arrays (FPGAs) are used in a wide variety of applications and end markets, including digital signalprocessing, medical imaging, and high-performance computing. This application note outlines the issues related to powering FPGAs.It also discusses Maxim's solutions for powering Altera® FPGAs.
上傳時間： 2013-11-02
上傳用戶：zhaoman32
The MAX14885E, a 2:2 VGA switch, connects a VGA source to a VGA monitor. To ease direct connection to graphics controllers orthe ASIC, the MAX14885E has two supplies: VCC, a 5V ±5% supply, drives the VGA side interface; and the VL supply sets the logicswitching thresholds on the digital input pins (EN, S00, S01, S10, S11, SHA, SHB, SVA, and SVB). This application note documentsthe proper sequencing of the VCC and VL power supplies on power-up.
標簽： 14885E 14885 MAX VGA
上傳時間： 2013-10-23
上傳用戶：wuchunzhong
Piezoelectric motors are used in digital cameras for autofocus,zooming and optical image stabilization. Theyare relatively small, lightweight and effi cient, but theyalso require a complicated driving scheme. Traditionally,this challenge has been met with the use ofseparatecircuits, including a step-up converter and an oversizedgeneric full-bridge drive IC. The resulting high componentcount and large board space are especially problematicin the design of cameras for ever shrinking cell phones.The LT®3572 solves these problems by combining astep-up regulator and a dual full-bridge driver in a 4mm× 4mm QFN package. Figure 1 shows a typical LT3572Piezo motor drive circuit. A step-up converter is usedto generate 30V from a low voltage power source suchas a Li-Ion battery or any input power source within thepart’s wide input voltage range of 2.7V to 10V. The highoutput voltage of the step-up converter, adjustable upto 40V, is available for the drivers at the VOUT pin. Thedrivers operate in a full-bridge fashion, where the OUTAand OUTB pins are the same polarity as the PWMA andPWMB pins, respectively, and the OUTA and OUTB pinsare inverted from PWMA and PWMB, respectively. Thestep-up converter and both Piezo drivers have their ownshutdown control. Figure 2 shows a typical layout
上傳時間： 2013-11-18
上傳用戶：hulee
In predominantly digital systems it is often necessaryto include linear circuit functions. Traditionally, separatepower supplies have been used to run the linear components(see Box, “Linear Power Supplies—Past, Present,and Future”).
標簽： Designing Operation Circuits Linear
上傳時間： 2013-11-04
上傳用戶：sdq_123
鎖定放大是微弱信號檢測的重要手段。基于相關檢測理論，利用開關電容的開關實現鎖定放大器中乘法器的功能，提出開關電容和積分器相結合以實現相關檢測的方法，并設計出一種鎖定放大器。該鎖定放大器將微弱信號轉化為與之相關的方波，通過后續電路得到正比于被測信號的直流電平，為后續采集處理提供方便。測量數據表明鎖定放大器前級可將10-6 A的電流轉換為10-1 V的電壓，后級通過帶通濾波器級聯可將信號放大1×105倍。該方法在降低噪聲的同時，可對微弱信號進行放大，線性度較高、穩定性較好。 Abstract: Lock-in Amplifying（LIA）is one of important means for weak signal detection. Based on cross-correlation detection theory， switch in the swithched capacitor was used as multiplier of LIA， and a new method of correlation detection was proposed combining swithched capacitor with integrator. A kind of LIA was designed which can convert the weak signal to square-wave， then DC proportional to measured signal was obtained through follow-up conditioning circuit， providing convenience for signal acquisition and processing. The measured data shows that the electric current（10-6 A） can be changed into voltage（10-1 V） by LIA， and the signal is magnified 1×105 times by cascade band-pass filter. The noise is suppressed and the weak signal is amplified. It has the advantages of good linearity and stability.
標簽： 開關電容 鎖定放大器
上傳時間： 2013-11-29
上傳用戶：黑漆漆
蟲蟲下載站版權所有 京ICP備2021023401號-1
