EN 300220-1V2.4.1 Electromagnetic compatibility and Radio spectrum Matters (ERM);Short Range Devices (SRD);Radio equipment to be used in the 25 MHz to 1 000 MHz frequency range with power levels ranging up to 500 mW; Part 1: Technical characteristics and test methods
FFeeaattuurreess ? Input voltage range: 2.2 to 6V ? Programmable LED Current ? Drives LEDs Up to 27V ? Switching Frequency：up to 800KHz ? Wide dimming frequency range: 20KHz~ 360 KHz ? Programmable Overvoltage Protection ? Tiny SOP8/PP Package
Wide 2.2V to 6V Input Voltage Range
? 0.20V FB adjustable LED drive current
? Directly drive 9 Series 1W LED at
VIN>=6V
? Fixed 800KHz Switching Frequency
? Max. 3A Switching Current Capability
? Up to 92% efficiency
? Excellent line and load regulation
? EN PIN TTL shutdown capability
? Internal Optimize Power MOSFET
2.7V to 5.5V input voltage Range? Efficiency up to 96%
? 24V Boost converter with 12A switch
current Limit? 600KHz fixed Switching Frequency? Integrated soft-start? Thermal Shutdown? Under voltage Lockout? Support external LDO auxiliary power
supply? 8-Pin SOP-PP PackageAPPLICATIONSPortable Audio Amplifier Power SupplyPower BankQC 2.0/Type CWireless ChargerPOS Printer Power SupplySmall Motor Power Supply
USB PD3.1正式發布,上述文檔是此標準的詳細內容5月25日，USB-IF協會推出了USB Type-C線纜和接口標準v2.1版本，其中更新了有關供電能力的章節。USB PD3.1規范將原來的USB PD3.0內容歸到標準功率范圍（Standard Power Range，簡稱SPR）里面，最大功率保持100W不變；同時增加了擴展功率范圍（Extended Power Range，簡稱EPR），最大功率由100W擴展到240W。
General Design Specification:1. AC Input Range 180-264Vac, Isolated ac-dc offline, 12LEDS,Output 700mA2. Intelligent wall dimmer detections(Leading-edge dimmer , Trailing-edgedimmer , No-dimmer)3. Multiple dimming control scheme4. Wide dimming range from 1% up to 100%5. No visible flicker6. Resonant control to achieve high efficiency7. High Power Factor, 0.9 without dimmer8. Temperature degrade control to adjust the LED9. Primary-only Sensing eliminates opto-isolator feedback and simplifies design
The PC1099N from Pixelplus is a CMOS Image Sensor with Mega Pixels 0.3 MP, VGA, Supply Voltage Analog: 3.3 V, HVDD: 3.3 V, CVDD: 3.3 V, Frame Rate 50 to 60 fps, Dynamic Range 63.2 dB, SNR 45.3 dB. More details for PC1099N can be seen below.
The PW2606B is a front-end over voltage and over current protection device. It achieves wide inputvoltage range from 2.5VDC to 40VDC. The over voltage threshold can be programmed externally orset to internal default setting. The low resistance of integrated power path nFET switch ensures betterperformance for battery charging system applications. It can deliver up to 1A current to satisfy thebattery supply system. It integrates the over-temperature protection shutdown and auto-recoverycircuit with hysteresis to protect against over current events
The PW2601 is a charger front-end integrated circuit designed to provide protection to Li-ionbatteries from failures of charging circuitry. The device monitors the input voltage, battery voltageand the charging current to make sure all three parameters are operated in normal range. Thedevice will switch off internal MOSFET to disconnect IN to OUT to protect load when any of inputvoltage, output current exceeds the threshold. The Over temperature protection (OTP) functionmonitors chip temperature to protect the device. The PW2601 also can protect the system’sbattery from being over charged by monitors the battery voltage continuously. The deviceoperates like a linear regulator, maintaining a 5.1V output with input voltages up to the input overvoltage threshold.The PW2601 is available in DFN-2x2-8L package. Standard products are Pb-free and Halogenfree
