This document describes part number speciÞc changes to recommended operating conditions and revised electrical speciÞcations,as applicable, from those described in the generalMPC7400 Hardware SpeciÞcations.SpeciÞcations provided in this Part Number SpeciÞcation supersede those in theMPC7400 Hardware SpeciÞcationsdated 9/99(order #: MPC7400EC/D) for these part numbers only; speciÞcations not addressed herein are unchanged. This document isfrequently updated, refer to the website at http://www.mot.com/SPS/PowerPC/ for the latest version.Note that headings and table numbers in this data sheet are not consecutively numbered. They are intended to correspond to theheading or table affected in the general hardware speciÞcation.Part numbers addressed in this document are listed in Table A. For more detailed ordering information see Table B.
上傳時間： 2013-11-19
上傳用戶：qiaoyue
微型計算機課程設計論文—通用微機發聲程序的匯編設計 本文講述了在微型計算機中利用可編程時間間隔定時器的通用發聲程序設計，重點講述了程序的發聲原理，節拍的產生，按節拍改變的動畫程序原理，并以設計一個簡單的樂曲評分程序為引子，分析程序設計的細節。關鍵字：微機 8253 通用發聲程序 動畫技術 直接寫屏 1. 可編程時間間隔定時器8253在通用個人計算機中，有一個可編程時間間隔定時器8253，它能夠根據程序提供的計數值和工作方式,產生各種形狀和各種頻率的計數/定時脈沖,提供給系統各個部件使用。本設計是利用計算機控制發聲的原理,編寫演奏樂曲的程序。 在8253/54定時器內部有3個獨立工作的計數器:計數器0,計數器1和計數器2,每個計數器都分配有一個斷口地址,分別為40H,41H和42H.8253/54內部還有一個公用的控制寄存器,端地址為43H.端口地址輸入到8253/54的CS,AL,A0端,分別對3個計數器和控制器尋址. 對8353/54編程時,先要設定控制字,以選擇計數器,確定工作方式和計數值的格式.每計數器由三個引腳與外部聯系,見教材第320頁圖9-1.CLK為時鐘輸入端,GATE為門控信號輸入端,OUT為計數/定時信號輸入端.每個計數器中包含一個16位計數寄存器,這個計數器時以倒計數的方式計數的,也就是說,從計數初值逐次減1,直到減為0為止. 8253/54的三個計數器是分別編程的,在對任一個計數器編程時,必須首先講控制字節寫入控制寄存器.控制字的作用是告訴8253/54選擇哪個計數器工作,要求輸出什么樣的脈沖波形.另外,對8253/54的初始化工作還包括,向選定的計數器輸入一個計數初值,因為這個計數值可以是8為的,也可以是16為的,而8253/5的數據總線是8位的,所以要用兩條輸出指令來寫入初值.下面給出8253/54初始化程序段的一個例子,將計數器2設定為方式3,(關于計數器的工作方式參閱教材第325—330頁)計數初值為65536. MOV AL,10110110B ;選擇計數器2,按方式3工作,計數值是二進制格式 OUT 43H,AL ; j將控制字送入控制寄存器 MOV AL,0 ;計數初值為0 OUT 42H,AL ;將計數初值的低字節送入計數器2 OUT 42H,AL ;將計數初值的高字節送入計數器2 在IBM PC中8253/54的三個時鐘端CLK0,CLK1和CLK2的輸入頻率都是1.1931817MHZ. PC機上的大多數I/O都是由主板上的8255(或8255A)可編程序外圍接口芯片(PPI)管理的.關于8255A的結構和工作原理及應用舉例參閱教材第340—373頁.教材第364頁的”PC/XT機中的揚聲器接口電路”一節介紹了揚聲器的驅動原理,并給出了通用發聲程序.本設計正是基于這個原理,通過編程,控制加到揚聲器上的信號的頻率,奏出樂曲的.2．發聲程序的設計下面是能產生頻率為f的通用發聲程序:MOV AL, 10110110B ;8253控制字:通道2,先寫低字節,后寫高字節 ;方式3,二進制計數OUT 43H, AL ;寫入控制字MOV DX, 0012H ;被除數高位MOV AX, 35DEH ;被除數低位 DIV ID ;求計數初值n,結果在AX中OUT 42H, AL ;送出低8位MOV AL, AHOUT 42H,AL ;送出高8位IN AL, 61H ;讀入8255A端口B的內容MOV AH, AL ;保護B口的原狀態OR AL, 03H ;使B口后兩位置1,其余位保留OUT 61H,AL ;接通揚聲器,使它發聲
上傳時間： 2013-10-17
上傳用戶：sunjet
The RT9018A/B is a high performance positive voltage regulator designed for use in applications requining very low Input voltage and very low dropout voltage at up to 3A(peak).
上傳時間： 2013-10-10
上傳用戶：geshaowei
電子發燒友網：本資料是關于單片機及接口技術這門課程的期末考試試卷及答案的詳解。 8.當需要從MCS-51單片機程序存儲器取數據時，采用的指令為( )。 a)MOV A, @R1 b)MOVC A, @A + DPTR c)MOVX A, @ R0 d)MOVX A, @ DPTR 二、填空題(每空1分，共30分) 1.一個完整的微機系統由 和 兩大部分組成。 2.8051 的引腳RST是____(IN腳還是OUT腳)，當其端出現____電平時,8051進入復位狀態。8051一直維持這個值，直到RST腳收到____電平，8051才脫離復位狀態，進入程序運行狀態，從ROM H單元開始取指令并翻譯和執行。 3.半導體存儲器分成兩大類 和 ，其中 具有易失性，常用于存儲 。
上傳時間： 2015-01-03
上傳用戶：wfl_yy
介紹了以PLC為控制單元，變頻器為執行單元的控制系統及其在煙支輸送儲存系統中的應用，并給出了系統的組成、硬件的配置及具體的實現方法。關鍵詞 : PLC 變頻器輸送儲存系統 Ab str ac t;T hisp aperi ntroducest hec ontrols ystem whichc onsistso fP LCa ndf requencyc onvertera ndi ts application in the buffer conveyor for cigarettes. The system constitute, hardware disposal and realization method are also presented in detail.Keywords:PLC f requencyc onverter b ufferc onveyor
上傳時間： 2013-10-22
上傳用戶：ouyang426
最新的支持向量機工具箱，有了它會很方便 1. Find time to write a proper list of things to do! 2. Documentation. 3. Support Vector Regression. 4. Automated model selection. REFERENCES ========== [1] V.N. Vapnik, "The Nature of Statistical Learning Theory", Springer-Verlag, New York, ISBN 0-387-94559-8, 1995. [2] J. C. Platt, "Fast training of support vector machines using sequential minimal optimization", in Advances in Kernel Methods - Support Vector Learning, (Eds) B. Scholkopf, C. Burges, and A. J. Smola, MIT Press, Cambridge, Massachusetts, chapter 12, pp 185-208, 1999. [3] T. Joachims, "Estimating the Generalization Performance of a SVM Efficiently", LS-8 Report 25, Universitat Dortmund, Fachbereich Informatik, 1999.
上傳時間： 2013-12-16
上傳用戶：亞亞娟娟123
The Kannel Open Source WAP and SMS gateway works as both an SMS gateway, for implementing keyword based services via GSM text messages, and a WAP gateway, via UDP. The SMS part is fairly mature, the WAP part is early in its development. In this release, the GET request for WML pages and WMLScript files via HTTP works, including compilation for WML and WMLScript to binary forms. Only the data call bearer (UDP) is supported, not SMS.
標簽： gateway implementing SMS keyword
上傳時間： 2014-01-11
上傳用戶：2525775
算法ebook(10部算法經典著作的合集) 算法ebook> 10部算法經典著作的合集 chm格式 (1)Fundamentals of Data Structures by Ellis Horowitz and Sartaj Sahni (2)Data Structures, Algorithms and Program Style Using C by James F. Korsh and Leonard J. Garrett (3)Data Structures and Algorithm Analysis in C by Mark Allen Weiss (4)Data Structures: From Arrays to Priority Queues by Wayne Amsbury (5)Information Retrieval: Data Structures & Algorithms edited by William B. Frakes and Ricardo Baeza-Yates (6)Introduction to Algorithms by Thomas H. Cormen, Charles E. Leiserson, and Ronald L. Rivest (7)Practical Data Structures in C++ by Bryan Flamig (8)Reliable Data Structures in C by Thomas Plum (9)Data Structures and Algorithms Alfred V. Aho, Bell Laboratories, Murray Hill, New Jersey John E. Hopcroft, Cornell University, Ithaca, New York Jeffrey D. Ullman, Stanford University, Stanford, California (10)DDJ Algorithms and Data Structures Articles
標簽： ebook Fundamentals Structures Ellis
上傳時間： 2015-04-04
上傳用戶：tfyt
mp3設計程序資料，采用c語言編寫。 README file for yampp-3 source code 2001-05-27 This is the current state of the yampp-3 source code, 2001-05-27. This code is intended to run on Rev. B of the yampp-3 PCB, but can ofcourse be used on compatible systems as well. It still uses the "old" song selection system as the yampp-2. However, the disk handling routines has improved a lot and the obviosly, the new VS1001 handling has been put in. The codesize is almost at it s maximum at 1F40 bytes. A .ROM file is included if you don t have the compiler set up. For now, the documentation is in the code
上傳時間： 2015-04-13
上傳用戶：小碼農lz
十部經典算法合集 .chm Fundamentals of Data Structures by Ellis Horowitz and Sartaj Sahni PREFACE CHAPTER 1: INTRODUCTION CHAPTER 2: ARRAYS CHAPTER 3: STACKS AND QUEUES CHAPTER 4: LINKED LISTS CHAPTER 5: TREES CHAPTER 6: GRAPHS CHAPTER 7: INTERNAL SORTING CHAPTER 8: EXTERNAL SORTING CHAPTER 9: SYMBOL TABLES CHAPTER 10: FILES APPENDIX A: SPARKS APPENDIX B: ETHICAL CODE IN INFORMATION PROCESSING APPENDIX C: ALGORITHM INDEX BY CHAPTER
標簽： Fundamentals Structures Horowitz PREFACE
上傳時間： 2015-05-19
上傳用戶：維子哥哥
