亚洲欧美第一页_禁久久精品乱码_粉嫩av一区二区三区免费野_久草精品视频

蟲蟲首頁| 資源下載| 資源專輯| 精品軟件
登錄| 注冊

SLOPE

  • 邊坡穩定分析小程序SLOPE相當不錯的

    邊坡穩定分析小程序SLOPE相當不錯的

    標簽: SLOPE 程序

    上傳時間: 2015-08-27

    上傳用戶:aa17807091

  • 實現對InSAR復相位信號進行基于局部頻率估計的“斜坡自適應(SLOPE-adapt)濾波” 此濾波方法特別適用于InSAR相位圖濾波

    實現對InSAR復相位信號進行基于局部頻率估計的“斜坡自適應(SLOPE-adapt)濾波” 此濾波方法特別適用于InSAR相位圖濾波,能在最大限度保持有用信息的條件下濾除各種噪聲。

    標簽: InSAR SLOPE-adapt 濾波 相位信號

    上傳時間: 2014-01-25

    上傳用戶:mpquest

  • DAC技術用語 (D/A Converters Defini

    Differential Nonlinearity: Ideally, any two adjacent digitalcodes correspond to output analog voltages that are exactlyone LSB apart. Differential non-linearity is a measure of theworst case deviation from the ideal 1 LSB step. For example,a DAC with a 1.5 LSB output change for a 1 LSB digital codechange exhibits 1⁄2 LSB differential non-linearity. Differentialnon-linearity may be expressed in fractional bits or as a percentageof full scale. A differential non-linearity greater than1 LSB will lead to a non-monotonic transfer function in aDAC.Gain Error (Full Scale Error): The difference between theoutput voltage (or current) with full scale input code and theideal voltage (or current) that should exist with a full scale inputcode.Gain Temperature Coefficient (Full Scale TemperatureCoefficient): Change in gain error divided by change in temperature.Usually expressed in parts per million per degreeCelsius (ppm/°C).Integral Nonlinearity (Linearity Error): Worst case deviationfrom the line between the endpoints (zero and full scale).Can be expressed as a percentage of full scale or in fractionof an LSB.LSB (Lease-Significant Bit): In a binary coded system thisis the bit that carries the smallest value or weight. Its value isthe full scale voltage (or current) divided by 2n, where n is theresolution of the converter.Monotonicity: A monotonic function has a SLOPE whose signdoes not change. A monotonic DAC has an output thatchanges in the same direction (or remains constant) for eachincrease in the input code. the converse is true for decreasing codes.

    標簽: Converters Defini DAC

    上傳時間: 2013-10-30

    上傳用戶:stvnash

  • WDT

    WDT ,F(xiàn)lash ,F(xiàn)LL+ ,Timer,Comp_A SLOPE ADC to Detect Tempclockworked

    標簽: WDT

    上傳時間: 2014-12-20

    上傳用戶:asasasas

  • MSP430超低功耗微處理器是TI公司推出的一種新型單片機。它具有16位精簡指令結構

    MSP430超低功耗微處理器是TI公司推出的一種新型單片機。它具有16位精簡指令結構,內含12位快速ADC/SLOPE ADC,內含60K字節FLASH ROM,2K字節RAM,片內資源豐富,有ADC、PWM、若干TIME、串行口、WATCHDOG、比較器、模擬信號,有多種省電模式,功耗特別小,一顆電池可工作10年。開發簡單,仿真器價格低廉,不需昂貴的編程器。

    標簽: MSP 430 超低功耗 微處理器

    上傳時間: 2014-12-22

    上傳用戶:731140412

  • AP2406技術手冊

    The AP2406 is a 1.5Mhz constant frequency, SLOPE compensated current mode PWM step-down converter. The device integrates a main switch and a synchronous rectifier for high efficiency without an external Schottky diode. It is ideal for powering portable equipment that runs from a single cell lithium-Ion (Li+) battery. The AP2406 can supply 600mA of load current from a 2.5V to 5.5V input voltage. The output voltage can be regulated as low as 0.6V. The AP2406 can also run at 100% duty cycle for low dropout operation, extending battery life in portable system. Idle mode operation at light loads provides very low output ripple voltage for noise sensitive applications. The AP2406 is offered in a low profile (1mm) 5-pin, thin SOT package, and is available in an adjustable version and fixed output voltage of 1.2V, 1.5V and 1.8V

    標簽: 2406 AP 技術手冊

    上傳時間: 2017-02-23

    上傳用戶:w124141

  • 基于通用MCU的智能SFP光模塊設計

    1、引言SFP光模塊的數字診斷監測主要是對光模塊的供電電壓、模塊溫度、偏置電流、接收光功率、發射光功率等5個模擬參量和各種監控信號實時監測。通過分析數字化測量結果判斷光模塊的通信工作狀況,這有利于光通信鏈路的維護目前大部分設計方案是采用MAXIM公司的DS1859,該芯片完全兼容SFF-8472協議,功能齊全,軟件編程簡便,但是該芯片價格比較貴,同樣很多空間已固定,不靈活,擴展性不好,對于以后版本的升級不方便。本方案采用一片MCU,EEPROM,數字控制電位器(DCP)替代DS1859,使用軟件編程達到滿足SFF-8472協議要求,用FLASH存儲A2H地址內容以及內外部校準相結合的新校準思想,具有性價比高,可靠性好,擴展性好,校準快速簡便等優點本文首先介紹五個模擬量的一種新校準原理,接若分析DDM系統的控制器MCU、限幅放大器、激光驅動器、存儲單元、DCP的原理與作用,然后給出軟件的設計思路和實現方案,最后通過實驗數據驗證該方案的可行性。2、參量校準原理根據SFF-8472協議,光模塊的供電電壓等五個模擬參量有內部校準和外部校準兩種方式,內部校準的參數固化在程序里面,雖然可以通過外部界面設置改變,但是不同型號激光器PD響應度不一樣,內部校準就很不靈活。外部校準,克服了內部校準的缺點,但是,由于要測量SLOPE和offet兩個參數,需人工手調,在批量生產的情況下,測量效率低下。而使用內外部校準相結合的校準方式可以克服上述的缺點

    標簽: mcu 光模塊

    上傳時間: 2022-06-26

    上傳用戶:

主站蜘蛛池模板: 隆回县| 新丰县| 淮安市| 留坝县| 佛山市| 乾安县| 云南省| 曲靖市| 秭归县| 房产| 太仆寺旗| 汝阳县| 抚顺县| 南宁市| 枣庄市| 泽库县| 子洲县| 福建省| 长沙市| 甘孜| 平武县| 石柱| 汽车| 胶南市| 安远县| 许昌县| 枞阳县| 九龙县| 诸城市| 新余市| 清水河县| 东台市| 息烽县| 尼木县| 界首市| 邛崃市| 阜新| 鄢陵县| 石渠县| 太原市| 寿宁县|