8位MCU升級至32位MCU的設計方案 目前的MCU市場分為三個部分， 8位、16位和32位內核（4位內核MCU現在已相當少用，故在本次比較中將其忽略）。對于這三個部分中的每一個，其規模大體相同。傳統上8位內核占最大的市場份額。根據一些分析人士報告，可能32位內核市場占有率已經超過了8位內核。即使目前尚未超過，時間也不會太長。32位內核市場份額是迄今為止增長最快的。8位內核和16位內核仍在增長，但在速度方面遠不如32位內核（8位內核的增長速度仍快于16位內核）在很長的一段時間內， 很多人相信16位MCU可能會被8位MCU和32位MCU取代。目前的32位MCU器件采用最新技術制造（與8位內核和16為內核相比）。
上傳時間： 2014-01-21
上傳用戶：13033095779
The PCA9534 is a 16-pin CMOS device that provide 8 bits of General Purpose parallel Input/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. The improvements include higher drive capability, 5 V I/O tolerance, lower supply current, individual I/O configuration, 400 kHz clock frequency, and smaller packaging. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
上傳時間： 2013-11-17
上傳用戶：vodssv
NEC 8位MCU參考手冊
上傳時間： 2013-11-17
上傳用戶：swz13842860183
PCA9634是一款通過I2C總線控制的8位LED驅動器，該驅動器特別為紅/綠/藍/琥珀（RGBA）色的混合應用進行了優化。每個LED輸出都有自己的8位分辨率（256級）固定頻率的獨立PWM控制器，該控制器運行在97KHz的頻率下，占空比可由0%到99.6%可調，用以將LED設置到一個特定的亮度值。除此之外，該驅動器還有一個8位分辨率（256級）的組PWM控制器，該控制器的工作頻率可以為固定的190Hz，也可以在24Hz和每10.73秒一次（約0.093Hz）之間調整，其占空比為0%到99.6%可調，用于使所有LED以同樣的值模糊（dim）或者閃爍。
上傳時間： 2013-12-20
上傳用戶：liaofamous
PCA9624是一款帶I2C總線的8位LED的電壓開關優化的LED驅動器，它主要應用于電流為100mA 的紅/綠/藍/琥珀（RGBA）的LED的亮度和閃爍的控制。每個LED輸出均有獨立的8位分辨率（256個梯度）且輸出頻率固定為97KHz的PWM控制器它可以在0%到99.6%的范圍內對LED的亮度進行調整，使發光二極管被設置為一個特定的亮度值。額外的8位分辨率（256個梯度）PWM控制器組既有固定的190Hz的頻率又可以在24Hz和每10.73秒的固定周期內對LED燈亮度從0％至99.6％的范圍內調整，使它們保持同樣的亮度或閃爍速度。
上傳時間： 2013-11-24
上傳用戶：38553903210
PCA9624是一款帶I2C總線的8位LED的電壓開關優化的LED驅動器，它主要應用于電流為100mA 的紅/綠/藍/琥珀（RGBA）的LED的亮度和閃爍的控制。每個LED輸出均有獨立的8位分辨率（256個梯度）且輸出頻率固定為97KHz的PWM控制器它可以在0%到99.6%的范圍內對LED的亮度進行調整，使發光二極管被設置為一個特定的亮度值。額外的8位分辨率（256個梯度）PWM控制器組既有固定的190Hz的頻率又可以在24Hz和每10.73秒的固定周期內對LED燈亮度從0％至99.6％的范圍內調整，使它們保持同樣的亮度或閃爍速度。
上傳時間： 2014-12-27
上傳用戶：zhangliming420
<Almost since the introduction of microcontrollers as electronic components there always has been an oscillatorcircuit on the device to make it work. From application point of view only some external components wererequired to make it work. However, to make sure that it will always work required more effort. This report is basedon feedback from the market from customers applying 8-bit mircrocontrollers.>
標簽： oscillators X-tal bit mic
上傳時間： 2013-11-12
上傳用戶：穿著衣服的大衛
The PCA9670 provides general purpose remote I/O expansion for most microcontrollerfamilies via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plusfamily.The PCA9670 is a drop-in upgrade for the PCF8574 providing higher Fast-mode Plus(Fm+) I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package sink capacity(200 mA versus 100 mA) that supports having all 25 mA LEDs on at the same time andmore device addresses (64 versus 8) are available to allow many more devices on the buswithout address conflicts.
上傳時間： 2013-10-15
上傳用戶：stella2015
The PCA9672 provides general purpose remote I/O expansion for most microcontrollerfamilies via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plusfamily.The PCA9672 is a drop-in upgrade for the PCF8574 providing higher Fast-mode Plus(Fm+) I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package sink capacity(200 mA versus 100 mA) that supports having all LEDs on at the same time and moredevice addresses (16 versus 8) are available to allow many more devices on the buswithout address conflicts.
上傳時間： 2013-10-23
上傳用戶：jasonheung
The PCA9674/74A is a drop-in upgrade for the PCF8574/74A providing higher Fast-modePlus I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package sink capacity(200 mA versus 100 mA) that supports having all LEDs on at the same time and moredevice addresses (64 versus 8) are available to allow many more devices on the buswithout address conflicts.
上傳時間： 2013-10-22
上傳用戶：wwwwwen5
<sub id="pktwo"><tr id="pktwo"></tr></sub>
