bulk endpoint endless source/Sink firmware. EP2OUT will always accept a bulk OUT EP4OUT will always accept a bulk OUT EP6IN will always return a 512 byte packet. The packet contains an incrementing byte starting at 0x02. Since EP6 always returns a 512 byte packet, this endpoint should never be accessed except with a high-speed host controller. EP8IN will continuously return the packet most recently written to EP4OUT
標簽： bulk will endpoint firmware
上傳時間： 2016-01-14
上傳用戶：sk5201314
尋找Sink。 Sink： 7 * 由一些頂點和有向邊組成的一個圖，如果兩個頂點x,y之間有一條路連通，則稱x到y是連通的。 8 * 對于所有頂點集合的一個子集，如果任意兩點之間是連通的，則稱為一個“強連通子集”。 9 * 一個強連通子集，如果沒有任何指向其他頂點的邊（各個頂點有且只有一個輸出方向），則稱為一個“Sink”。
標簽： Sink
上傳時間： 2013-12-20
上傳用戶：woshini123456
Sink節點 This file is part of an OMNeT++/OMNEST simulation example.
標簽： simulation example OMNEST OMNeT
上傳時間： 2013-12-09
上傳用戶：cxl274287265
無線傳感器網絡體系結構與性能標準 WSNs體系結構如圖1所示。它主要由以下部分組 成_2]：傳感器節點、接收發送器(Sink)、Internet或通信衛星、 任務管理節點等部分。傳感器節點分布在感知區域內，采集 與觀察對象相關的數據，并將協同處理后的數據傳送到 Sink。Sink可以通過Internet或通信衛星實現傳感器網絡與 任務管理節點通信。WSNs路由協議的任務是在傳感器節點 和Sink節點之間建立路由，可靠地傳遞數據。
上傳時間： 2014-01-14
上傳用戶：ztj182002
The PCA9670 provides general purpose remote I/O expansion for most microcontrollerfamilies via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plusfamily.The PCA9670 is a drop-in upgrade for the PCF8574 providing higher Fast-mode Plus(Fm+) I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package Sink capacity(200 mA versus 100 mA) that supports having all 25 mA LEDs on at the same time andmore device addresses (64 versus 8) are available to allow many more devices on the buswithout address conflicts.
上傳時間： 2013-10-15
上傳用戶：stella2015
The PCA9671 provides general purpose remote I/O expansion for most microcontrollerfamilies via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plus(Fm+) family.The PCA9671 is a drop in upgrade for the PCF8575 providing higher I2C-bus speeds(1 MHz versus 400 kHz) so that the output can support PWM dimming of LEDs, higherI2C-bus drive (30 mA versus 3 mA) so that many more devices can be on the bus withoutthe need for bus buffers, higher total package Sink capacity (400 mA versus 100 mA) thatsupports having all 25 mA LEDs on at the same time and more device addresses (64versus 8) to allow many more devices on the bus without address conflicts.
上傳時間： 2013-10-12
上傳用戶：laomv123
The PCA9672 provides general purpose remote I/O expansion for most microcontrollerfamilies via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plusfamily.The PCA9672 is a drop-in upgrade for the PCF8574 providing higher Fast-mode Plus(Fm+) I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package Sink capacity(200 mA versus 100 mA) that supports having all LEDs on at the same time and moredevice addresses (16 versus 8) are available to allow many more devices on the buswithout address conflicts.
上傳時間： 2013-10-23
上傳用戶：jasonheung
The PCA9673 provides general purpose remote I/O expansion for most microcontrollerfamilies via the two-line bidirectional bus (I2C-bus) and is a part of the Fast-mode Plusfamily.The PCA9673 is a drop in upgrade for the PCF8575 providing higher Fast-mode Plus(Fm+) I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package Sink capacity(400 mA versus 100 mA) that supports having all 25 mA LEDs on at the same time andmore device addresses (16 versus 8) are available to allow many more devices on the buswithout address conflicts.
上傳時間： 2013-10-29
上傳用戶：wkchong
The PCA9674/74A is a drop-in upgrade for the PCF8574/74A providing higher Fast-modePlus I2C-bus speeds (1 MHz versus 400 kHz) so that the output can support PWMdimming of LEDs, higher I2C-bus drive (30 mA versus 3 mA) so that many more devicescan be on the bus without the need for bus buffers, higher total package Sink capacity(200 mA versus 100 mA) that supports having all LEDs on at the same time and moredevice addresses (64 versus 8) are available to allow many more devices on the buswithout address conflicts.
上傳時間： 2013-10-22
上傳用戶：wwwwwen5
如何生成優化的梯度是傳感器網絡定向擴散中的一個關鍵問題, 本文在分析一種基本梯度生成算法的問題基礎之上,利用興趣包的轉發次數對其進行改進, 設計了一種分布式的最短路徑梯度生成算法. 該算法極大的降低了鄰居節點間建立“平行梯度”和“逆向梯度”的概率, 可構建從源節點到Sink 節點的多條最短路徑. 仿真表明, 改進的算法可建立更為有效的梯度, 從而使得定向擴散中數據報文沿著更短的路徑傳輸, 無線傳感器網絡的能量利用率更高.
上傳時間： 2014-12-29
上傳用戶：han_zh
