激情欧美一区二区三区中文字幕,亚洲精品中文字幕乱码,日本精品久久久久影院

Verification-A

HT47R20A-1中A/D轉換的使用

HT47R20A-1中A/D轉換的使用本文主要介紹 HT47R20A-1 單片機A/D 轉換器的應用及注意事項。(附帶實例)

標簽： HT 47 20 轉換

上傳時間： 2013-10-08

上傳用戶：mhp0114
基于HT56R678的A/D功能使用

基于HT56R678的A/D功能使用 HT56R678微控制器內建8通道,12位解析度的A/D轉換器.本篇應用范例將介紹如何使用HT56R678微控制器的A/D功能。

標簽： R678 56R 678 HT

上傳時間： 2013-12-09

上傳用戶：zhyfjj
基于HT46R46E/HT46C46E經濟A/D型八位單片機

基于HT46R46E/HT46C46E經濟A/D型八位單片機 HT46R46E/HT46C46E 是8 位高性能精簡指令集單片機，專門為需要A/D 轉換的產品而設計，例如傳感器信號輸入。掩膜版本HT46C46E 與OTP 版本HT46R46E 引腳和功能完全相同。在HT46R46E/HT46C46E 封裝片里包含兩顆芯片：一顆是HT46R46E/HT46C46E 單片機，另一顆是作為通用數據存儲器的128×8 位的EEPROM。這兩顆芯片邦定在一起封裝為HT46R46E/HT46C46E。

標簽： 46 HT 經濟位單片機

上傳時間： 2013-10-31

上傳用戶：fdfadfs
A Single-Chip Pulsoximeter Des

This application report discusses the design of non-invasive optical plethysmographyalso called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). Thepulsoximeter consists of a peripheral probe combined with the MCU displaying theoxygen saturation and pulse rate on a LCD glass. The same sensor is used for bothheart-rate detection and pulsoximetering in this application. The probe is placed on aperipheral point of the body such as a finger tip, ear lobe or the nose. The probeincludes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) andthe other in the infrared spectrum (940nm). The percentage of oxygen in the body isworked by measuring the intensity from each frequency of light after it transmitsthrough the body and then calculating the ratio between these two intensities.

標簽： Pulsoximeter Single-Chip Des

上傳時間： 2013-10-27

上傳用戶：黑漆漆
MCS-51單片機與D/A轉換器的接口和應用

DAC0832是一個8位D/A轉換器芯片，單電源供電，從+5V～+15V均可正常工作，基準電壓的范圍為±10V，電流建立時間為1μs，CMOS工藝，低功耗20mW。其內部結構如圖9.1所示，它由1個8位輸入寄存器、1個8位DAC寄存器和1個8位D/A轉換器組成和引腳排列如圖1所示。 • DAC0832工作方式• ADC0809工作方式要求掌握：• MCS-51單片機與D/A轉換器的接口連接• MCS-51單片機與A/D轉換器的接口連接• 初始化編程及應用了解：• 典型D/A轉換器芯片DAC0832的管腳功能• 典型A/D轉換器芯片ADC0809的管腳功能

標簽： MCS 51 單片機轉換器

上傳時間： 2014-01-14

上傳用戶：zl520l
ADC0809 A/D轉換器基本應用技術

ADC0809是帶有8位A/D轉換器、8路多路開關以及微處理機兼容的控制邏輯的CMOS組件。它是逐次逼近式A/D轉換器，可以和單片機直接接口。 adc0809 datasheet

標簽： 0809 ADC 轉換器應用技術

上傳時間： 2013-10-11

上傳用戶：kz_zank
DTMF Decoding with a PIC16xxx

This application note describes how to decode standard DTMF tones using the minimum number of external discrete components and a PIC. The two examples use a PIC which has an 8 bit timer and either a comparator or an ADC, although it can be modified for use on a PIC which has only digital I/O. The Appendices have example code for the 16C662 (with comparator) and 16F877 (using the ADC). As the majority of the Digital Signal Processing is done in software, little is required in the way of external signal conditioning. Software techniques are used to model the individual elements of a DTMF Decoder IC.

標簽： Decoding DTMF with PIC

上傳時間： 2013-11-21

上傳用戶：zhaoke2005
用PIC16C73 單片機實現十二位A/D轉換器

介紹用PIC16C73 自帶的八位A/D 轉換器擴展為十二位A/D 轉換器，給出了具體的設計方案和程序流程。它是用以 PIC16C73 為MCU 構成的海水有機磷測控儀A/D 轉換部分的一種解決方案。為監測海洋生態環境，研制了用于海水有機磷農藥現場監測的生物傳感器。為測定生物傳感器的信號，使傳感器可用于船載及臺站的海洋生態環境現場自動監測，需要對整個的采樣和排液裝置進行控制以及對傳感器來的信號進行實時采集處理，形成有機磷的濃度傳給上位機。為此，開發了以PIC16C73 單片機為核心的小型測控儀器，很好的完成了上述功能。PIC1673 單片機自帶8 位的A/D 轉換器，但不能滿足系統對精度的要求，本設計在單片機自帶8 位A/D 基礎上加少量的硬件和軟件開銷，使其擴展為十二位A/D 轉換器，滿足了系統的要求。

標簽： PIC 16C C73 16

上傳時間： 2013-10-30

上傳用戶：a296386173
新穎實用的單片機雙積分A/D轉換電路和軟件

新穎實用的單片機雙積分A/D轉換電路和軟件:摘　要: 通過對雙積分A/ D 轉換過程及其原理的分析,結合8031 單片機定時計數器的特點,設計出一種新的A/ D 轉換電路. 詳細介紹了這種轉換電路的硬件原理及工作過程,給出了實用的硬件電路與軟件設計框圖. 通過比較分析,可以看出這種A/ D 轉換電路性能價格比較高,軟件編程簡單,并且轉換速度和精度優于一般的A/ D 轉換電路. 這種設計思路為數模轉換器(A/ D) 的升級提高指出一個明確的方向.關鍵詞:單片機; 定時/ 計數器; A/ D 轉換; 雙積分　雙積分A/ D 及定時計數器原理:我們先分析雙積分A/ D 轉換的工作原理. 如圖1 所示,積分器先以固定時間T 對待測的輸入模擬電壓Vi 進行正向積分,積分電容C 積累的電荷為

標簽： 單片機雙積分轉換電路軟件

上傳時間： 2014-01-18

上傳用戶：hewenzhi
Emulating a synchronous serial

The C500 microcontroller family usually provides only one on-chip synchronous serialchannel (SSC). If a second SSC is required, an emulation of the missing interface mayhelp to avoid an external hardware solution with additional electronic components.The solution presented in this paper and in the attached source files emulates the mostimportant SSC functions by using optimized SW routines with a performance up to 25KBaud in Slave Mode with half duplex transmission and an overhead less than 60% atSAB C513 with 12 MHz. Due to the implementation in C this performance is not the limitof the chip. A pure implementation in assembler will result in a strong reduction of theCPU load and therefore increase the maximum speed of the interface. In addition,microcontrollers like the SAB C505 will speed up the interface by a factor of two becauseof an optimized architecture compared with the SAB C513.Moreover, this solution lays stress on using as few on-chip hardware resources aspossible. A more excessive consumption of those resources will result in a highermaximum speed of the emulated interface.Due to the restricted performance of an 8 bit microcontroller a pin compatible solution isprovided only; the internal register based programming interface is replaced by a set ofsubroutine calls.The attached source files also contain a test shell, which demonstrates how to exchangeinformation between an on-chip HW-SSC and the emulated SW-SSC via 5 external wiresin different operation modes. It is based on the SAB C513 (Siemens 8 bit microcontroller).A table with load measurements is presented to give an indication for the fraction of CPUperformance required by software for emulating the SSC.

標簽： synchronous Emulating serial

上傳時間： 2014-01-31

上傳用戶：z1191176801