Abstract: Perfection is relative and application specific. The perfect race car is not the car we use to commute to work. We need products for everyday use that are high quality, affordable, and solidly reliable. There will be times when we must use components that are not perfect, and this is when calibration becomes important. Calibration techniques reduce tolerances in imperfect manufacturing equipment while maintaining affordability.
標簽： 校準
上傳時間： 2013-10-09
上傳用戶：哈哈hah
Recently a new technology for high voltage Power MOSFETshas been introduced – the CoolMOS™ . Based on thenew device concept of charge compensation the RDS(on) areaproduct for e.g. 600V transistors has been reduced by afactor of 5. The devices show no bipolar current contributionlike the well known tail current observed during the turn-offphase of IGBTs. CoolMOS™ virtually combines the lowswitching losses of a MOSFET with the on-state losses of anIGBT.
標簽： COOLMOS
上傳時間： 2013-11-14
上傳用戶：zhyiroy
Abstract: This application note presents an overview of the operational characteristics of accurate I²C real-time clocks (RTCs),including the DS3231, DS3231M, and DS3232. It focuses on general application guidelines that facilitate use of device resources forpower management, I²C communication circuit configurations, and I²C characteristics relative to device power-up sequences andinitializations. Additional discussions on decoupling are provided to support developing strategies for mitigating power-supply pushingof device frequency.
上傳時間： 2013-11-23
上傳用戶：WMC_geophy
基于數字微鏡器件（Digital Micro-mirror Device，DMD）的哈達瑪變換光譜技術是一種新型的光譜成像技術，在國內很少有專門的文獻介紹[1-3]。文中先介紹了本實驗采用的哈達瑪光譜儀樣機的原理以及哈達瑪成像光譜儀優于傳統模板的獨特之處，即獲得多通道高能量高信噪比的光譜數據，然后描述對采集到的數據做高信噪比，高分辨率壓縮處理，最后說明此方法實時性強、圖像失真小、實用價值高、應用范圍廣。
標簽： 哈達 變換光譜儀 壓縮系統
上傳時間： 2013-11-25
上傳用戶：eastimage
Who has never experienced oscillations issues when using an operational amplifier? Opampsare often used in a simple voltage follower configuration. However, this is not the bestconfiguration in terms of capacitive loading and potential risk of oscillations.Capacitive loads have a big impact on the stability of operational amplifier-basedapplications. Several compensation methods exist to stabilize a standard op-amp. Thisapplication note describes the most common ones, which can be used in most cases.The general theory of each compensation method is explained, and based on this, specific
上傳時間： 2013-10-28
上傳用戶：chenbhdt
The STM32F10xxx microcontroller family embeds up to three advanced 12-bit ADCs (depending on the device) with a conversion time down to 1 μs. A self-calibration feature is provided to enhance ADC accuracy versus environmental condition changes.
上傳時間： 2014-12-23
上傳用戶：eastimage
The Reactor design pattern handles service requests that are delivered concurrently to an application by one or more clients. Each service in an application may consist of serveral methods and is represented by a separate event handler that is responsible for dispatching service-specific requests.
上傳時間： 2013-10-15
上傳用戶：libinxny
The MAX2691 low-noise amplifier (LNA) is designed forGPS L2 applications. Designed in Maxim’s advancedSiGe process, the device achieves high gain andlow noise figure while maximizing the input-referred 1dBcompression point and the 3rd-order intercept point. TheMAX2691 provides a high gain of 17.5dB and sub 1dBnoise figure.
標簽： Amplifier Low-Noise 2691 Band
上傳時間： 2014-12-04
上傳用戶：zaocan888
Radio Frequency Integrated Circuit Design I enjoyed reading this book for a number of reasons. One reason is that itaddresses high-speed analog design in the context of microwave issues. This isan advanced-level book, which should follow courses in basic circuits andtransmission lines. Most analog integrated circuit designers in the past workedon applications at low enough frequency that microwave issues did not arise.As a consequence, they were adept at lumped parameter circuits and often notcomfortable with circuits where waves travel in space. However, in order todesign radio frequency (RF) communications integrated circuits (IC) in thegigahertz range, one must deal with transmission lines at chip interfaces andwhere interconnections on chip are far apart. Also, impedance matching isaddressed, which is a topic that arises most often in microwave circuits. In mycareer, there has been a gap in comprehension between analog low-frequencydesigners and microwave designers. Often, similar issues were dealt with in twodifferent languages. Although this book is more firmly based in lumped-elementanalog circuit design, it is nice to see that microwave knowledge is brought inwhere necessary.Too many analog circuit books in the past have concentrated first on thecircuit side rather than on basic theory behind their application in communications.The circuits usually used have evolved through experience, without asatisfying intellectual theme in describing them. Why a given circuit works bestcan be subtle, and often these circuits are chosen only through experience. Forthis reason, I am happy that the book begins first with topics that require anintellectual approach—noise, linearity and filtering, and technology issues. Iam particularly happy with how linearity is introduced (power series). In therest of the book it is then shown, with specific circuits and numerical examples,how linearity and noise issues arise.
上傳時間： 2014-12-23
上傳用戶：han_zh
模擬集成電路的設計與其說是一門技術，還不如說是一門藝術。它比數字集成電路設計需要更嚴格的分析和更豐富的直覺。嚴謹堅實的理論無疑是嚴格分析能力的基石，而設計者的實踐經驗無疑是誕生豐富直覺的源泉。這也正足初學者對學習模擬集成電路設計感到困惑并難以駕馭的根本原因。.美國加州大學洛杉機分校(UCLA)Razavi教授憑借著他在美國多所著名大學執教多年的豐富教學經驗和在世界知名頂級公司(AT&T，Bell Lab，HP)卓著的研究經歷為我們提供了這本優秀的教材。本書自2000午出版以來得到了國內外讀者的好評和青睞，被許多國際知名大學選為教科書。同時，由于原著者在世界知名頂級公司的豐富研究經歷，使本書也非常適合作為CMOS模擬集成電路設計或相關領域的研究人員和工程技術人員的參考書。... 本書介紹模擬CMOS集成電路的分析與設計。從直觀和嚴密的角度闡述了各種模擬電路的基本原理和概念，同時還闡述了在SOC中模擬電路設計遇到的新問題及電路技術的新發展。本書由淺入深，理論與實際結合，提供了大量現代工業中的設計實例。全書共18章。前10章介紹各種基本模塊和運放及其頻率響應和噪聲。第11章至第13章介紹帶隙基準、開關電容電路以及電路的非線性和失配的影響，第14、15章介紹振蕩器和鎖相環。第16章至18章介紹MOS器件的高階效應及其模型、CMOS制造工藝和混合信號電路的版圖與封裝。 1 Introduction to Analog Design 2 Basic MOS Device Physics 3 Single-Stage Amplifiers 4 Differential Amplifiers 5 Passive and Active Current Mirrors 6 Frequency Response of Amplifiers 7 Noise 8 Feedback 9 Operational Amplifiers 10 Stability and Frequency Compensation 11 Bandgap References 12 Introduction to Switched-Capacitor Circuits 13 Nonlinearity and Mismatch 14 Oscillators 15 Phase-Locked Loops 16 Short-Channel Effects and Device Models 17 CMOS Processing Technology 18 Layout and Packaging
上傳時間： 2014-12-23
上傳用戶：杜瑩12345
