PRINCIPLE: The UVE algorithm detects and eliminates from a PLS model (including from 1 to A components) those variables that do not carry any relevant information to model Y. The criterion used to trace the un-informative variables is the reliability of the regression coefficients: c_j=mean(b_j)/std(b_j), obtained by jackknifing. The cutoff level, below which c_j is considered to be too small, indicating that the variable j should be removed, is estimated using a matrix of random variables.The predictive power of PLS models built on the retained variables only is evaluated over all 1-a dimensions =(yielding RMSECVnew).
標簽： from eliminates PRINCIPLE algorithm
上傳時間： 2016-11-27
上傳用戶：凌云御清風
The Graham scan examines the points one by one and eliminates the points which cause reflexive angles
標簽： points eliminates one reflexive
上傳時間： 2017-02-17
上傳用戶：jing911003
Abstract: This application note describes the essential workings of an electrocardiogram (ECG). It discussesfactors that disrupt the ECG signals and make reliable, highly-accurate electrical characterization difficult. Theindustry-standard solution for ECG electrical characterization, which uses an analog front-end and ADCcombination, is explained. The article then introduces the MAX11040 simultaneous-sampling, sigma-deltaADC as a compelling, highly integrated solution that eliminates the need for the AFE, and saves both spaceand cost for the application.
上傳時間： 2013-12-23
上傳用戶：sssl
Portable, battery-powered operation of electronic apparatushas become increasingly desirable. Medical, remotedata acquisition, power monitoring and other applicationsare good candidates for battery operation. In some circumstances,due to space, power or reliability considerations,it is preferable to operate the circuitry from a single 1.5Vcell. Unfortunately, a 1.5V supply eliminates almost alllinear ICs as design candidates. In fact, the LM10 opamp-reference and the LT®1017/LT1018 comparators arethe only IC gain blocks fully specifi ed for 1.5V operation.Further complications are presented by the 600mV dropof silicon transistors and diodes. This limitation consumesa substantial portion of available supply range, makingcircuit design diffi cult. Additionally, any circuit designedfor 1.5V operation must function at end-of-life batteryvoltage, typically 1.3V. (See Box Section, “Componentsfor 1.5V Operation.”)
標簽： Circuitry Operation Single 1017
上傳時間： 2013-12-20
上傳用戶：Wwill
The CN3052A is a complete constant-current /constant voltage linear charger for single cell Li-ion and Li Polymer rechargeable batteries. The device contains an on-chip power MOSFET and eliminates the need for the external sense resistor and blocking diode.
上傳時間： 2013-11-10
上傳用戶：子虛烏有
Portable, battery-powered operation of electronic apparatushas become increasingly desirable. Medical, remotedata acquisition, power monitoring and other applicationsare good candidates for batteryoperation. In some circumstances,due to space, power or reliability considerations,it is preferable to operate the circuitry from a single 1.5Vcell. Unfortunately, a 1.5V supply eliminates almost alllinear ICs as design candidates. In fact, the LM10 opamp-reference and the LT®1017/LT1018 comparators arethe only IC gain blocks fully specifi ed for 1.5V operation.Further complications are presented by the 600mV dropof silicon transistors and diodes. This limitation consumesa substantial portion of available supply range, makingcircuit design diffi cult. Additionally, any circuit designedfor 1.5V operation mustfunction at end-of-life batteryvoltage, typically 1.3V. (See Box Section, “Componentsfor 1.5V Operation.”)
標簽： Circuitry Operation Single Cell
上傳時間： 2013-10-30
上傳用戶：hz07104032
應用 APPLICATIONS·電視機、錄像機、音頻設備、顯示器、復印機、打印裝置、游戲機及計算機等。·用于開關電源線性濾波器?！は鞒?TV、VTR、VCR及監聽器泄漏雜音?！び糜贠A 設備、通信設備和其它器件。·TV set, recorder, sound-frequency equipment, show-scope, photocopy-scope, typewrite equipment, recreation-scope, computer etc.·For line filters of switching power supplies.·eliminates incoming/leaking noise of TVs, VTRs/VCRs and audio equipment .·For OA equipment, communications equipment and other electronic devices.
上傳時間： 2013-10-23
上傳用戶：shizhanincc
The PMSM FOC is made of several C modules, compatible with the free-of-charge IAR EWARM KickStart edition toolchain version 4.42. It is used to quickly evaluate both the MCU and the available tools. In addition, when used together with the STM32F103xx motor control starter kit (STM3210B-MCKIT) and PM motor, a motor can be made to run in a very short time. It also eliminates the need for time-consuming development of FOC and speed regulation algorithms by providing ready-to-use functions that let the user concentrate on the application layer. Moreover, it is possible to get rid of any speed sensor thanks to the sensorless algorithm for rotor position reconstruction.
標簽： free-of-charge compatible KickStart modules
上傳時間： 2014-01-09
上傳用戶：498732662
The System Management BIOS Reference Specification addresses how motherboard and system vendors present management information about their products in a standard format by extending the BIOS interface on Intel architecture systems. The information is intended to allow generic instrumentation to deliver this data to management applications that use CIM (the WBEM data model) or direct access and eliminates the need for error prone operations like probing system hardware for presence detection.
標簽： Specification motherboard Management Reference
上傳時間： 2013-12-10
上傳用戶：鳳臨西北
This control is another extension to the now standard and widely used ListView control. I have included some of the more common features: shaded columns, column sorting (with data type), but the real addition is the FILTERBAR features of the header. This implementation eliminates all of the work of dealing with the filter messages and item filtering by incorporating it into the control. This could have been implemented as delegates, but we create controls to do the work for us, don t we? I would like to thank Carlos H. Perez since a lot of the implementation came from examples he set with his ListViewEx control.
標簽： control extension ListView standard
上傳時間： 2013-12-05
上傳用戶：royzhangsz
