As mentioned, most computers include a serial port. The only hardware setup required is connecting the serial cable to the serial port on the PC and the serial port on the instrument. The serial instrument may include some hardware drivers or software utilities for communication, and should include documentation on the baud rate, packet size, stop bits, and parity bits that the instrument will use. Additionally, check the National Instruments Instrument Driver Network to see if LabVIEW drivers already exist for yout instrument, as
C/C++ implementation of the Levenberg-Marquardt non-linear
least squares algorithm. levmar includes double and single precision LM versions, both
with analytic and finite difference approximated jacobians
Design and test a category called Rectangle rectangular, rectangular attribute to the lower left corner of the upper-right corner and the coordinates of two points, to calculate the size of rectangular
中南賽區(qū)ACM競賽題
Description
Given a two-dimensional array of positive and negative integers, a sub-rectangle is any contiguous sub-array of size 1*1 or greater located within the whole array. The sum of a rectangle is the sum of all the elements in that rectangle. In this problem the sub-rectangle with the largest sum is referred to as the maximal sub-rectangle.
Make Text-Overflow work on both IE and Firefox
If the text inside each line exceed the width of each line, then you will see "..." (ellipsis) shows up at the end of each line.
Try to resize the window or change the font size to see if "..." (ellipsis) will show up or disappear.
Demo - Listing
This is the source for a C compiler that generates 386 or
m68K code. Code generation is fairly good although the optimizer is
a little naive... the code itself should be highly portable although
there are some issues involved with porting from MSDOS that have to
be resolved for example the size of LONG on unix machines is so big
some of the code generated gets messed up.
Code generation requires TASM to assemble the compiler output
you can use the borland TLINK to produce executables, or the
Watcom WLINK can also be used. PMODE systems written by TRAN are used
for the DPMI interface.
NIST Net – A Linux-based Network Emulation Tool, It is a raw IP packet filter with many controllable channel parameters such as packet loss ratio, jitter, bandwidth variation, delay, and network buffer size. To simulate different network environments
D169 Demo - DMA0 Repeated Burst to-from RAM, Software Trigger
Description A 32 byte block from 220h-240h is transfered to 240h-260h
using DMA0 in a burst block using software DMAREQ trigger.
After each transfer, source, destination and DMA size are
reset to inital software setting because DMA transfer mode 5 is used.
P1.0 is toggled durring DMA transfer only for demonstration purposes.
** RAM location 0x220 - 0x260 used - always make sure no compiler conflict **
ACLK= n/a, MCLK= SMCLK= default DCO ~ 800k
