介紹一種以MSP430單片機為基礎的智能頻率測量系統，采用硬件邏輯與軟件指令相結合的方式控制閘門，實現0 MHz~10 MHz范圍內無檔切換的等精度測量。 Abstract: An intelligent frequency measurement system based on MSP430 singlechip is introduced. The system uses a way that can combine hardware logic and software instructions to contronl the strobe ,and completes the functions of equal precision in the range of 0MHz~10MHz without shifting
上傳時間： 2013-10-28
上傳用戶：dbs012280
The PCA9534 is a 16-pin CMOS device that provide 8 bits of General Purpose parallel Input/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. The improvements include higher drive capability, 5 V I/O tolerance, lower supply current, individual I/O configuration, 400 kHz clock frequency, and smaller packaging. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
上傳時間： 2013-11-17
上傳用戶：vodssv
This application report discusses the design of non-invasive optical plethysmographyalso called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). Thepulsoximeter consists of a peripheral probe combined with the MCU displaying theoxygen saturation and pulse rate on a LCD glass. The same sensor is used for bothheart-rate detection and pulsoximetering in this application. The probe is placed on aperipheral point of the body such as a finger tip, ear lobe or the nose. The probeincludes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) andthe other in the infrared spectrum (940nm). The percentage of oxygen in the body isworked by measuring the intensity from each frequency of light after it transmitsthrough the body and then calculating the ratio between these two intensities.
標簽： Pulsoximeter Single-Chip Des
上傳時間： 2013-10-27
上傳用戶：黑漆漆
用戶程序示例教程 The Blinky project is a simple program for the LPC2138using Keil MCB2130 Microcontroller Board. It blinks the LEDs at speed according to the Potentiometer setting and prints the current seting to the Serial Port 1.In addition it generates a sine wave with an adjustable frequency on the speaker of the board.
上傳時間： 2014-12-27
上傳用戶：hongmo
The XL6003 regulator is fixed frequency PWM Boost (step-up) DC/DC converter, capable ofdriving 1050mA load current with excellent line and load regulation. The regulator is simple to use because it includes internal frequency compensation and a fixed-frequency oscillator so that it requires a minimum number of external components to work. The XL6003 could directly drive 5~10 3W LED units at VIN=12V.
上傳時間： 2013-11-07
上傳用戶：xy@1314
The PCA9534 is a 16-pin CMOS device that provide 8 bits of General Purpose parallel Input/Output (GPIO) expansion for I2C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I2C-bus I/O expanders. The improvements include higher drive capability, 5 V I/O tolerance, lower supply current, individual I/O configuration, 400 kHz clock frequency, and smaller packaging. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.
標簽： interru SMBus power 9534
上傳時間： 2013-10-10
上傳用戶：inwins
PCA9511, PCA9512, PCA9513, PCA9514, PCA9515, PCA9516, PCA9518,P82B96, P82B715Abstract - Philips Semiconductors family of Repeaters, Hubs and Expanders are detailed in this application notethat discusses device operation, maximum cable length and frequency calculations and typical applications.
標簽： REPEATERS SMBus 255 AN
上傳時間： 2013-11-21
上傳用戶：wlcaption
Microchip ZigBee協議棧:ZigBee™ 是專為低速率傳感器和控制網絡設計的無線網絡協議。有許多應用可從ZigBee 協議受益，其中可能的一些應用有：建筑自動化網絡、住宅安防系統、工業控制網絡、遠程抄表以及PC 外設。與其他無線協議相比， ZigBee 無線協議提供了低復雜性、縮減的資源要求，最重要的是它提供了一組標準的規范。它還提供了三個工作頻帶，以及一些網絡配置和可選的安全功能。如果您正在尋求現有的控制網絡技術（例如RS-422、RS-485）或?qū)Ｓ袩o線協議的替代方案， ZigBee 協議可能是您所需的解決方案。此應用筆記旨在幫助您在應用中采用ZigBee 協議。 可以使用在應用筆記中提供的Microchip ZigBee 協議?？焖俚貥?gòu)建應用。為了說明該協議棧的用法，本文包含了兩個有效的演示應用程序?？蓪⑦@兩個演示程序作為參考或者根據您的需求經過簡單修改來采用它們。此應用筆記中提供的協議棧函數庫實現了一個與物理層無關的應用程序接口。 因此，無需做重大修改就可以輕松地在射頻（Radio Frequency，RF）收發器之間移植應用程序。在此文檔末尾的“常見問題解答”中提供了有關Microchip 協議棧和用法的一些常見問題及其答案。
標簽： Microchip ZigBee 協議棧
上傳時間： 2013-10-08
上傳用戶：u789u789u789
基于變頻調速的水平連鑄機拉坯輥速度控制系統Frequency Inverter Based Drawing RollerS peedC ontrolSy stem ofHorizontal Continuous Casting MachineA 偉劉沖旅巴(南 華 大 學電氣工程學院，衡陽421001)摘要拉坯輥速度控制是水平連鑄工藝的關鍵技術之一，采用變頻器實現水平連鑄機拉坯輥速度程序控制，由信號發生裝置給變頻器提供程控信號?，F(xiàn)場應用表明該控制系統速度響應快，控制精度高，滿足了水平連鑄生產的需要。關鍵詞水平連鑄拉坯輥速度程序控制變頻器Absh'act Speedc ontorlof dr awingor leris on eo fth ek eyte chnologiesfo rho rizontalco ntinuousca stingm achine.Fo rth ispu rpose,fr equencyco nverterisad optedfo rdr awingor lersp eedp rogrammablec ontorlof ho rizontalco ntinuousca stingm achine,th ep rogrammableco ntorlsi gnalto fr equencyc onverteris provided場a signal generator. The results of application show that the response of system is rapid and the control accuracy is high enough to meet thedemand of production of horizontal continuous casting.Keywords Horizontalco ntinuousc asting Drawingor ler Speedp rogrammablec ontrol Ferquencyin verter 隨著 現 代 化工業生產對鋼材需求量的日益增加，連鑄生產能力已經成為衡量一個國家冶金工業發展水平的重要指標之一。近十幾年來，水平連鑄由于具有投資少、鑄坯直、見效快等多方面的優點，國內許多鋼鐵企業利用水平連鑄機來澆鑄特種合金鋼，發揮了其獨特的優勢并取得了較好的經濟效益〔1,2)0采用 水 平 連鑄機澆鑄特種合金鋼時，由于拉坯機是水平連鑄系統中的關鍵設備之一，拉坯機及其控制性能的好壞直接影響著連鑄坯的質量，因此，連鑄的拉坯技術便成為整個水平連鑄技術的核心。由于鋼的冶煉過程是在高溫下進行的，鋼水溫度的變化又容易影響鑄坯的質量和成材率，因此，如何能在高溫環境下控制好與鑄坯速度相關的參數(拉、推程量，中停時間和拉坯頻率等)對于確保連鑄作業的進一步高效化，延長系統的連續作業時間十分關鍵。因此，拉坯輥速度控制技術是連鑄生產過程控制領域中的關鍵技術之- [31
標簽： 變頻調速 水平連鑄機 速度控制
上傳時間： 2013-10-12
上傳用戶：gxy670166755
選擇映射法（SLM）和概率類算法都可以降低OFDM （Orthogonal Frequency Division Multiplexing）系統的PAPR（Peak to Average Power Ratio），傳統SLM算法自身較為復雜，但由于其優良的性能，棄之可惜。研究表明，SLM算法和限幅類算法在性能上具有一定的互補性。任何一個算法未必能達到抑制PAPR的理想效果，在深入研究了兩個算法的基礎上，將其優點聯合起來，以達到降低OFDM系統PAPR的目的。最后對聯合改進算法進行了分析與仿真，并驗證了聯合改進算法的有效性和可行性
上傳時間： 2013-11-22
上傳用戶：xinhaoshan2016
蟲蟲下載站版權所有 京ICP備2021023401號-1
