msp430The LDC1312 and LDC1314 are 2- and 4-channel,
1? Easy-to-use – minimal configuration required
12-bit inductance to digital converters (LDCs) for
? Measure up to 4 sensors with one IC
inductive sensing solutions. With multiple channels ? Multiple channels support environmental and and support for remote sensing, the LDC1312 and aging compensation LDC1314 enable the performance and reliability benefits of inductive sensing to be realized at minimal? Multi-channel remote sensing provides lowest cost and power. The products are easy to use, onlysystem cost requiring that the sensor frequency be within 1 kHz ? Pin-compatible medium and high-resolution and 10 MHz to begin sensing. The wide 1 kHz to 10 options MHz sensor frequency range also enables use of very small PCB coils, further reducing sensing– LDC1312/4: 2/4-ch 12-bit LDC solution cost and size.– LDC1612/4: 2/4-ch 28
The AP2406 is a 1.5Mhz constant frequency, slope compensated current mode PWM step-down converter. The device integrates a main switch and a synchronous rectifier for high efficiency without an external Schottky diode. It is ideal for powering portable equipment that runs from a single cell lithium-Ion (Li+) battery. The AP2406 can supply 600mA of load current from a 2.5V to 5.5V input voltage. The output voltage can be regulated as low as 0.6V. The AP2406 can also run at 100% duty cycle for low dropout operation, extending battery life in portable system. Idle mode operation at light loads provides very low output ripple voltage for noise sensitive applications.
The AP2406 is offered in a low profile (1mm) 5-pin, thin SOT package, and is available in an adjustable version and fixed output voltage of 1.2V, 1.5V and 1.8V
The 4.0 kbit/s speech codec described in this paper is based on a
Frequency Domain Interpolative (FDI) coding technique, which
belongs to the class of prototype waveform Interpolation (PWI)
coding techniques. The codec also has an integrated voice
activity detector (VAD) and a noise reduction capability. The
input signal is subjected to LPC analysis and the prediction
residual is separated into a slowly evolving waveform (SEW) and
a rapidly evolving waveform (REW) components. The SEW
magnitude component is quantized using a hierarchical
predictive vector quantization approach. The REW magnitude is
quantized using a gain and a sub-band based shape. SEW and
REW phases are derived at the decoder using a phase model,
based on a transmitted measure of voice periodicity. The spectral
(LSP) parameters are quantized using a combination of scalar
and vector quantizers. The 4.0 kbits/s coder has an algorithmic
delay of 60 ms and an estimated floating point complexity of
21.5 MIPS. The performance of this coder has been evaluated
using in-house MOS tests under various conditions such as
background noise. channel errors, self-tandem. and DTX mode
of operation, and has been shown to be statistically equivalent to
ITU-T (3.729 8 kbps codec across all conditions tested.
High-Speed, Low-Power
Dual Operational Amplifier
The AD826 features high output current drive capability of
50 mA min per amp, and is able to drive unlimited capacitive
loads. With a low power supply current of 15 mA max for both
amplifiers, the AD826 is a true general purpose operational
amplifier.
The AD826 is ideal for power sensitive applications such as video
cameras and portable instrumentation. The AD826 can operate
from a single +5 V supply, while still achieving 25 MHz of band
width. Furthermore the AD826 is fully specified from a single
+5 V to ±15 V power supplies.
The AD826 excels as an ADC/DAC buffer or active filter in
data acquisition systems and achieves a settling time of 70 ns
to 0.01%, with a low input offset voltage of 2 mV max. The
AD826 is available in small 8-lead plastic mini-DIP and SO
packages.
This book gives a comprehensive overview of the technologies for the advances of
mobile radio access networks. The topics covered include linear transmitters,
superconducting filters and cryogenic radio frequency (RF) front head, radio over
fiber, software radio base stations, mobile terminal positioning, high speed
downlink packet access (HSDPA), multiple antenna systems such as smart
antennas and multiple input and multiple output (MIMO) systems, orthogonal
frequency division multiplexing (OFDM) systems, IP-based radio access networks
(RAN), autonomic networks, and ubiquitous networks.
Traditional modulation methods adopted by space agencies for transmit-
ting telecommand and telemetry data have incorporated subcarriers as a sim-
ple means of separating different data types as well ensuring no overlap
between the radio frequency (RF) carrier and the modulated data’s frequency
spectra.
