The PW2163D is a high frequency, synchronous, rectified, step-down, switch-mode converter withinternal powerMOSFETs. It offers a very compact solution to provide a 3A continuous current over awide input supply range,with excellent load and line regulation.The PW2163D requires a minimal number of readily available, external components and is availablein a spacesaving SOT23-6 package
本系統采用電動機電樞供電回路串接采樣電阻的方式來實現對小型直流有刷電動機的轉速測量。該系統主要由二階低通濾波電路,小信號放大電路、單片機測量顯示電路、開關穩壓電源電路等組成。同時自制電機測速裝置,用高頻磁環作為載體,用線圈繞制磁環,利用電磁感應原理檢測電機運行時的漏磁,將變化的磁場信號轉化為磁環上的感應電流。用信號處理單元電路將微弱電信號轉化為脈沖信號,送由單片機檢測,從而達到準確測量電機的速度的要求。In this system, the sampling resistance of armature power supply circuit is connected in series to measure the speed of small DC brush motor. The system is mainly composed of second-order low-pass filter circuit, small signal amplifier circuit, single-chip measurement and display circuit, switching regulated power supply circuit and so on. At the same time, the self-made motor speed measuring device uses high frequency magnetic ring as the carrier, coil winding magnetic ring, and electromagnetic induction principle to detect the leakage of magnetic field during the operation of the motor, which converts the changed magnetic field signal into the induced current on the magnetic ring. The weak electric signal is transformed into pulse signal by signal processing unit circuit, which is sent to single chip computer for detection, so as to meet the requirement of accurate measurement of motor speed.
The LM158 series consists of two independent, high gain,
internally frequency compensated operational amplifiers
which were designed specifically to operate from a single
power supply over a wide range of voltages. Operation from
split power supplies is also possible and the low power
supply current drain is independent of the magnitude of the
power supply voltage.
High volume USB 2.0 devices will be designed using ASIC technology with embedded USB 2.0 support.
For full-speed USB devices the operating frequency was low enough to allow data recovery to be handled
in a vendors VHDL code, with the ASIC vendor providing only a simple level translator to meet the USB
signaling requirements. Today s gate arrays operate comfortably between 30 and 60 MHz. With USB 2.0
signaling running at hundreds of MHz, the existing design methodology must change.
High volume USB 2.0 devices will be designed using ASIC technology with embedded USB 2.0 support.
For full-speed USB devices the operating frequency was low enough to allow data recovery to be handled
in a vendors VHDL code, with the ASIC vendor providing only a simple level translator to meet the USB
signaling requirements. Today s gate arrays operate comfortably between 30 and 60 MHz. With USB 2.0
signaling running at hundreds of MHz, the existing design methodology must change.
Image enhancement in frequency domain using Fourier center frequency, Gaussian lowpass filter, Low pass filter, high pass filter. Image restoration using medean filter, weiner filter with noise generator such as Gaussian noise, Salt and Pepper noise
