the jakes improved channel implemented by MATLAB
標簽： implemented improved channel MATLAB
上傳時間： 2017-08-10
上傳用戶：waitingfy
This is a paper describing Pulse Compression technique implemented in the Weather Radar system. This paper presents data examples from the radars and contrasts the use of pulse compression waveforms with more traditional non-modulated pulsed waveforms.
標簽： This Compression implemented describing
上傳時間： 2017-08-25
上傳用戶：問題問題
PIC to PIC communication using i2c bus. Multi-master implemented on pic24.
標簽： communication Multi-master implemented PIC
上傳時間： 2017-09-03
上傳用戶：84425894
A sparse variant of the Levenberg-Marquardt algorithm implemented by levmar has been applied to bundle adjustment, a computer vision/photogrammetry problem that typically involves several thousand variables
標簽： Levenberg-Marquardt implemented algorithm applied
上傳時間： 2013-12-23
上傳用戶：wqxstar
This is the source code of a digital clock implemented using Atmel 8 bit AVR Controller(ATMega16). To fully understand it look at the hardware implementation shown in attached photo(pdf).
標簽： implemented Controller digital ATMega
上傳時間： 2014-08-18
上傳用戶：moshushi0009
Resolution of heat equation using Crank Nicholson method. implemented in matlab language.
標簽： implemented Resolution Nicholson equation
上傳時間： 2013-12-18
上傳用戶：sk5201314
Stereovision reconstruction using Triangulation and "Mire" Calibration. implemented in Matlab language
標簽： reconstruction Triangulation Stereovision Calibration
上傳時間： 2014-01-14
上傳用戶：wangdean1101
為提高溫度測量效率，降低系統的成本，擴展傳輸距離，設計出一種新型溫度采集系統。單片機通過控制具有單總線方式的溫度傳感器DS18B20實現對溫度的測量，同時單片機通過控制具有單總線方式300～450MHz頻率范圍內的MAX7044與MAX7033無線發射與接收芯片實現溫度數據的無線傳輸。與傳統溫度采集系統相比，該系統利用單總線方式連接，采用無線傳輸方式實現遠距離通信，易于系統的集成與擴展。實驗結果表明，該系統結構簡單、方便移植，能夠同時實現多達上百點溫度的測量與500m范圍的傳輸。 Abstract: To improve the temperature measurement efficiency and reduce system cost,expansion of transmission distance,a new type of temperature acquisition system is designed.Microcontroller controlled temperature sensor DS18B20which has a single-bus achieves temperature measurement,while microcontroller by controlled the MAX7044and MAX7033chip with a single-bus and having300~450MHz radiofrequency to achieve the wireless transmission of temperature data.Compared with conventional temperature acquisition system,the system uses single-bus connected,and uses wireless transmission means to achieve long-distance communications,easy-to-system integration and expansion.The experimental results show that the system is simple,convenient transplantation,and can be implemented in as many as a hundred-point temperature measure-ment and the transmission range of500meters.
上傳時間： 2013-10-29
上傳用戶：515414293
介紹了電力操作電源與智能電池巡檢系統的特點，給出了一種基于超低功耗單片機MSP430 F149針對中小型變電站自動化運行的專用設備的基本設計原理及實現方法，最后給出了詳細硬件構成和軟件實現。該系統能滿足中小型變電站安全、可靠、自動運行的要求，并通過與上位機的串行通信實現變電站的遠程管理和控制。 Abstract: The characters of the intelligent battery data logging system of the electric operation power are introduced.The basic design principle and the implemented methods of the special equipment which only designed for the middle or small transformer substation based on MSP430F149 are prescribed. Finally, the hardware block diagram and the software flow chart are also given. The function that the system finally needs to realize can basically meet with the middle or small transformer substation’s satisfy, reliably,and automatic running.And it can also realize the transformer substation long-distance management and control by serial communicating with the host computer.
上傳時間： 2013-11-25
上傳用戶：黃華強
The Controller Area Network (CAN) is a serial, asynchronous, multi-master communication protocol forconnecting electronic control modules, sensors and actuators in automotive and industrial applications.With the SJA1000, Philips Semiconductors provides a stand-alone CAN controller which is more than a simpleeplacement of the PCA82C200.Attractive features are implemented for a wide range of applications, supporting system optimization, diagnosisand maintenance.
標簽： Stand-alone contro 1000 SJA
上傳時間： 2013-11-18
上傳用戶：yxgi5
