The cart with an inverted pendulum, shown below, is "bumped" with an impulse force, F. Determine the dynamic equations of motion for the system, and lin earize about the pendulum s angle, theta = Pi (in other words, assume that p endulum does not move more than a few degrees away from the vertical, chosen to be at an angle of Pi). Find a controller to satisfy all of the design re quirements given below.
標簽： F. with Determine inverted
上傳時間： 2014-01-17
上傳用戶：miaochun888
An introduction to UWB: impulse Radio for Radar and Wireless Communications
標簽： Communications introduction Wireless impulse
上傳時間： 2015-06-18
上傳用戶：chenjjer
％realize overlapped-save method ％y:output sequence ％x:input seqence ％h:filter impulse response sequence ％N:length of each segment ％重疊保留法實現分段卷積
標簽： overlapped-save sequence response realize
上傳時間： 2015-07-22
上傳用戶：chenbhdt
impulse Response in Rayleigh Fading channel, and Doppler Shift is in it.
標簽： Response Rayleigh impulse Doppler
上傳時間： 2013-12-25
上傳用戶：colinal
Algorithms for the estimation of a channel whose impulse response is characterized by a large number of zero tap coefficients are developed and compared.
標簽： characterized Algorithms estimation response
上傳時間： 2013-12-26
上傳用戶：manking0408
Squaring circuits are an important building block for impulse-radio UWB non-coherent receivers. This work proposes a squarer, based on the quadratic law of saturated transistors. Such a circuit has already been proposed for lower frequency applications, therefore this work focuses on the extension to ultra wide bandwidth, with particular care to the consequences related to the deviation from the ideal quadratic law of 0.18μm CMOS transistors.
標簽： impulse-radio non-coherent important receivers
上傳時間： 2013-12-24
上傳用戶：kikye
ScopeFIR designs Finite impulse Response [FIR] filters using the Parks-McClellan algorithm.
標簽： Parks-McClellan algorithm ScopeFIR Response
上傳時間： 2017-03-18
上傳用戶：kernaling
ScopeFIR designs Finite impulse Response [FIR] filters using the Parks-McClellan algorithm.
標簽： Parks-McClellan algorithm ScopeFIR Response
上傳時間： 2013-12-21
上傳用戶：黃華強
用impulse c編寫的18x18位的乘法器。
上傳時間： 2014-01-14
上傳用戶：jiahao131
This is the matlab source codes. It will generate the unit step sequnce and unit impulse sequence.
標簽： unit the generate sequence
上傳時間： 2017-04-24
上傳用戶：cccole0605
