This document provides practical, common guidelines for incorporating PCI Express interconnect layouts onto Printed Circuit Boards (PCB) ranging from 4-layer desktop baseboard designs to 10- layer or more server baseboard designs. Guidelines and constraints in this document are intended for use on both baseboard and add-in card PCB designs. This includes interconnects between PCI Express devices located on the same baseboard (chip-to-chip routing) and interconnects between a PCI Express device located “down” on the baseboard and a device located “up” on an add-in card attached through a connector. This document is intended to cover all major components of the physical interconnect including design guidelines for the PCB traces, vias and AC coupling capacitors, as well as add-in card edge-finger and connector considerations. The intent of the guidelines and examples is to help ensure that good high-speed signal design practices are used and that the timing/jitter and loss/attenuation budgets can also be met from end-to-end across the PCI Express interconnect. However, while general physical guidelines and suggestions are given, they may not necessarily guarantee adequate performance of the interconnect for all layouts and implementations. Therefore, designers should consider modeling and simulation of the interconnect in order to ensure compliance to all applicable specifications. The document is composed of two main sections. The first section provides an overview of general topology and interconnect guidelines. The second section concentrates on physical layout constraints where bulleted items at the beginning of a topic highlight important constraints, while the narrative that follows offers additional insight.
上傳時間： 2014-01-24
上傳用戶：s363994250
PCI-E是一種高速傳輸總線形式。
上傳時間： 2013-12-18
上傳用戶：宋桃子
PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊PCI-1734快速安裝使用手冊
上傳時間： 2013-10-22
上傳用戶：ssz1990
本文介紹一種基于PCI Express 總線的高速數據采集卡的設計方案及功能實現。給出系統的基本結構及單元組成，重點闡述系統硬件設計的關鍵技術和本地總線的控制邏輯，詳細探討了基于DriverWorks 的設備驅動程序的開發以及上層應用軟件的設計。該系統通過實踐驗證，可用于衛星下行高速數據的接收并可適用于其他高速數據采集與處理系統。關鍵詞：PCI Express 總線 PCIE PEX8311 DMA 板卡驅動 隨著空間科學和空間電子學技術的飛速發展，空間科學實驗的種類和數量以及科學實驗所產生的數據量不斷增加。為了使地面接收處理系統能夠實時處理和顯示科學圖像數據，必須要設計出新的地面數據接收處理系統，實現大量高速數據的正確接收采集、處理以及存儲。為了滿足地面系統的要求，并為以后的計算機系統升級提供更廣闊的空間，本系統擬采用第三代I/O 互連技術PCI Express（簡稱PCI-E）作為本數據采集卡的進機總線形式。本文通過對PCI-E 總線專用接口芯片PLX 公司的PEX8311 性能分析，特別是對突發讀、寫和DMA讀操作的時序研究，設計出本地總線的可編程控制邏輯，并詳細討論了整個PCI-E 高速數據采集卡的硬件設計方案，以及WDM 驅動程序和上層應用程序的設計方法。
上傳時間： 2013-10-28
上傳用戶：tianyi996
瀏覽所有的PCI設備
上傳時間： 2015-01-03
上傳用戶：zsjinju
一個通過PCI卡向LED屏發送股票實時行情的系統
上傳時間： 2015-01-04
上傳用戶：498732662
PCI接口的Verilog源代碼
上傳時間： 2013-12-28
上傳用戶：l254587896
pci驅動程序的源代碼
上傳時間： 2015-01-12
上傳用戶：ljmwh2000
PCI接口的PCMCIA轉界卡的2000驅動，解決2000不支持存儲卡問題
上傳時間： 2014-01-17
上傳用戶：王楚楚
在dos下讀寫pci卡
上傳時間： 2015-01-16
上傳用戶：windwolf2000
