This section contains a brief introduction to the C language. It is intended as a tutorial on the language, and aims at getting a reader new to C started as quickly as possible. It is certainly not intended as a substitute for any of the numerous textbooks on C. 2. write a recursive function FIB (n) to find out the nth element in theFibanocci sequence number which is 1,1,2,3,5,8,13,21,34,55,…3. write the prefix and postfix form of the following infix expressiona + b – c / d + e * f – g * h / i ^ j4. write a function to count the number of nodes in a binary tr
The Window Design Method
The basic idea behind the design of linear-phase FIR filters using the window
method is to choose a proper ideal frequency-selective filter [which always has
a noncausal, infinite duration impulse response] and then truncate its impulse
response hd[n] to obtain a linear-phase and causal FIR filter h[n]. To truncate the
impulse response of the ideal filter a time window w[n] is used. Available windows
in Matlab are rectangular [or boxcar in Matlab], bartlett, hamming, hanning
Embest S3C44B0X Evaluation Board
RTC Test Example
RTC Check(Y/N)? y
Set Default Time at 2004-12-31 FRI 23:59:59
Set Alarm Time at 2005-01-01 00:00:01
... RTC Alarm Interrupt O.K. ...
Current Time is 2005-01-01 SAT
00:00:01
RTC Working now. To set date(Y/N)? y
Current date is (2005,01,01, SAT). input new date (yy-mm-dd w): 5-2-23 3
Current date is: 2005-02-23 WED
RTC Working now. To set time(Y/N)? y
Current time is (00:00:21). To set time(hh:mm:ss): 19:32:5
Current Time is 2005-02-23 WED
19:32:
Routine mampres: To obtain amplitude response from h(exp(jw)).
input parameters:
h :n dimensioned complex array. the frequency response is stored
in h(0) to h(n-1).
n :the dimension of h and amp.
fs :sampling frequency (Hz).
iamp:If iamp=0: The Amplitude Res. amp(k)=abs(h(k))
If iamp=1: The Amplitude Res. amp(k)=20.*alog10(abs(h(k))).
output parameters:
amp :n dimensioned real array. the amplitude-frequency response is
stored in amp(0) to amp(n-1).
Note:
this program will generate a data file "filename.dat" .
in chapter 2
工程計算MATLAB code to calculate the reorthogonalized sine tapers
input: N = the length of the time series data to be tapered
p = the number of tapers requested
I = the gap structure a vector of length N
I(t) = 1 if there is data at time t, t=1, ..., N
I(t) = 0 if there is a gap at time t
output: X = N-by-p vector of the reorthogonalized sine taper