Linear CDMA receivers Like Decorrelator MMSE and Matched filters efficien and fast code
標簽： Decorrelator receivers and efficien
上傳時間： 2014-11-06
上傳用戶：Yukiseop
This ZIP folder contains IEEE papers related to MIMO-OFDM receivers for IQ Imbalance cancellation
標簽： cancellation MIMO-OFDM Imbalance receivers
上傳時間： 2017-05-22
上傳用戶：wanghui2438
This document provides a good knowledge on how GPS receivers work
標簽： knowledge receivers document provides
上傳時間： 2014-01-15
上傳用戶：924484786
STi7100 Datasheet for receivers
標簽： Datasheet receivers 7100 STi
上傳時間： 2013-12-31
上傳用戶：小草123
Documentation for Silabs Si470x family FM Radio receivers.
標簽： Documentation receivers Silabs family
上傳時間： 2013-11-30
上傳用戶：hgy9473
This a source code for ambiguity resolution in GPS receivers that run in matlab software
標簽： resolution receivers ambiguity software
上傳時間： 2017-08-17
上傳用戶：bjgaofei
Many applications have required the positioning accuracy of a Global Navigation Satellite System (GNSS). Some applications exist in environments that attenuate GNSS signals, and, consequently, the received GNSS signals become very weak. Examplesofsuchapplicationsarewirelessdevicepositioning,positioninginsensor networks that detect natural disasters, and orbit determination of geostationary and high earth orbit (HEO) satellites. Conventional GNSS receivers are not designed to work with weak signals. This book presents novel GNSS receiver algorithms that are designed to work with very weak signals.
標簽： receivers Signals GNSS Weak for
上傳時間： 2020-06-09
上傳用戶：shancjb
The SN65LBC170 and SN75LBC170 aremonolithic integrated circuits designed forbidirectional data communication on multipointbus-transmission lines. Potential applicationsinclude serial or parallel data transmission, cabledperipheral buses with twin axial, ribbon, ortwisted-pair cabling. These devices are suitablefor FAST-20 SCSI and can transmit or receivedata pulses as short as 25 ns, with skew lessthan 3 ns.These devices combine three 3-state differentialline drivers and three differential input linereceivers, all of which operate from a single 5-Vpower supply.The driver differential outputs and the receiverdifferential inputs are connected internally to formthree differential input/output (I/O) bus ports thatare designed to offer minimum loading to the buswhenever the driver is disabled or VCC = 0. Theseports feature a wide common-mode voltage rangemaking the device suitable for party-lineapplications over long cable runs.
上傳時間： 2013-10-13
上傳用戶：ytulpx
The MAX3243E device consists of three line drivers, five line receivers, and a dual charge-pump circuit with±15-kV ESD (HBM and IEC61000-4-2, Air-Gap Discharge) and ±8-kV ESD (IEC61000-4-2, Contact Discharge)protection on serial-port connection pins. The device meets the requirements of TIA/EIA-232-F and provides theelectrical interface between an asynchronous communication controller and the serial-port connector. Thiscombination of drivers and receivers matches that needed for the typical serial port used in an IBM PC/AT, orcompatible. The charge pump and four small external capacitors allow operation from a single 3-V to 5.5-Vsupply. In addition, the device includes an always-active noninverting output (ROUT2B), which allowsapplications using the ring indicator to transmit data while the device is powered down. The device operates atdata signaling rates up to 250 kbit/s and a maximum of 30-V/ms driver output slew rate.
標簽： MULTICHANNEL 5.5 TO RS
上傳時間： 2013-10-19
上傳用戶：ddddddd
Abstract: High-performance base-station (BTS) receivers must meet half-IF spurious requirements, whichcan be achieved by using the proper RF mixer. To help engineers, this application note illustrates the
上傳時間： 2013-10-17
上傳用戶：daoxiang126
