可重構計算技術兼具通用處理器(General-Purpose Processor，GPP)和專用集成電路(Application Specific Integr—ated Circuits，ASIC)的特點，既可以提供硬件高速的特性，又具有軟件可以重新配置的特性。而動態部分可重構技術是可重構計算技術的最新進展之一。該技術的要點就是在系統正常工作的情況下，修改部分模塊的功能，而系統其它模塊能夠照常運行，這樣既節約硬件資源，又增強了系統靈活性。 可重構SoC既可以在處理器上進行編程又可以改變FPGA內部的硬件結構，這使得SoC系統既具有處理器善于控制和運算的特點，又具FPGA靈活的重構特點；由于處理器和FPGA硬件是在同一塊硅片上，使得它們之間的通信寬帶大大提高，這種平臺很適合于容錯算法的實現。 本文基于863計劃項目；動態重構計算機的可信實現關鍵技術，重點研究應用于惡劣環境中FPGA自我容錯的體系結構，提出了一套完整的SoC系統的容錯設計方案，并研究其實現技術，設計實現了實現該技術的硬件平臺和軟件算法，并驗證成功。 論文取得了如下的創新性研究成果： 1、設計了實現動態重構技術的硬件平臺，包括高性能的FPGA(內含入式處理器PowcrPC)、PROM、SRAM、FLASH、串口通信等硬件模塊。 2、說明了動態重構技術的設計規范和設計流程，實現動態重構技術。 3、提出了一種基于動態重構實現容錯的方法，不需要外部處理器干預，由嵌入式處理器負責管理整個過程。 4、設計并實現了嵌入式處理器運行時需要的軟件，主要有兩個功能，首先是從CF卡中讀入重構所需的配置文件，并將配置文件寫進FPGA內部的配置存儲器中，改變FPGA內部的功能。其次，是實現容錯技術的算法。
標簽： FPGA 動態 容錯技術
上傳時間： 2013-04-24
上傳用戶：edrtbme
■ High Performance, Low Power AVR? 8-Bit Microcontroller ■ Advanced RISC Architecture –120 Powerful Instructions – Most Single Clock Cycle Execution –32 x 8 General Purpose Working Registers –Fully Static Operation
標簽： Atmel
上傳時間： 2013-06-01
上傳用戶：tccc
The purpose of this note is to present how to use the ST7 PWM/BRM for the generation of a50Hz si
上傳時間： 2013-06-01
上傳用戶：huyanju
The purpose of this application note is to show an example of how a digital potentiometer can be used in thefeedback loop of a step-up DC-DC converter to provide calibration and/or adjustment of the output voltage.The example circuit uses a MAX5025 step-up DC-DC converter (capable of generating up to 36V,120mWmax) in conjunction with a DS1845, 256 position, NV digital potentiometer. For this example, the desiredoutput voltage is 32V, which is generated from an input supply of 5V. The output voltage can be adjusted in35mV increments (near 32V) and span a range wide enough to account for resistance, potentiometer and DCDCconverter tolerances (27.6V to 36.7V).
標簽： DC-DC 數字電位器 升壓型 校準
上傳時間： 2014-12-23
上傳用戶：781354052
Digital-to-analog converters (DACs) are prevalent inindustrial control and automated test applications.General-purpose automated test equipment often requiresmany channels of precisely controlled voltagesthat span several voltage ranges. The LTC2704 is ahighly integrated 16-bit, 4-channel DAC for high-endapplications. It has a wide range of features designed toincrease performance and simplify design.
上傳時間： 2013-11-22
上傳用戶：元宵漢堡包
Linear Technology’s High Frequency Product lineupincludes a variety of RF I/Q modulators. The purpose ofthis application note is to illustrate the circuits requiredto interface these modulators with several popular D/Aconverters. Such circuits typically are required to maximizethe voltage transfer from the DAC to the baseband inputsof the modulator, as well as provide some reconstructionfi ltering.
標簽： DA轉換 接口 射頻 調制
上傳時間： 2013-10-19
上傳用戶：FreeSky
Low power operation of electronic apparatus has becomeincreasingly desirable. Medical, remote data acquisition,power monitoring and other applications are good candidatesfor battery driven, low power operation. Micropoweranalog circuits for transducer-based signal conditioningpresent a special class of problems. Although micropowerICs are available, the interconnection of these devices toform a functioning micropower circuit requires care. (SeeBox Sections, “Some Guidelines for Micropower Designand an Example” and “Parasitic Effects of Test Equipmenton Micropower Circuits.”) In particular, trade-offs betweensignal levels and power dissipation become painful whenperformance in the 10-bit to 12-bit area is desirable.
標簽： 信號調理 微電路
上傳時間： 2013-10-22
上傳用戶：rocketrevenge
PCI ExpressTM is the third generation of PCI (PeripheralComponent Interconnect) technology used to connect I/Operhipheral devices in computer systems. It is intended asa general purpose I/O device interconnect that meets theneeds of a wide variety of computing platforms such asdesktop, mobile, server and communications. It alsospecifies the electrical and mechanical attributes of thebackplane, connectors and removable cards in thesesystems.
上傳時間： 2013-11-17
上傳用戶：squershop
Although recent popular attention is focused on LithiumIon batteries, one must not forget that other batterychemistries, such as Nickel Cadmium (NiCd) and NickelMetal Hydride (NiMH) have advantages in rechargeablepower systems. Nickel-based batteries are robust, capableof high discharge rates, have good cycle life, do notrequire special protection circuitry and are less expensivethan Li-Ion. Among the two, NiMH batteries are rapidlyreplacing NiCd because of their higher capacity (40% to50% more) and the environmental concerns of the toxiccadmium contained in NiCd batteries.
標簽： NiMH NiCd 獨立 電池充電
上傳時間： 2013-11-04
上傳用戶：qq10538412
Occasionally, we are tasked with designing circuitry for aspecific purpose. The request may have customer originsor it may be an in-house requirement. Alternately, a circuitmay be developed because its possibility is simply tooattractive to ignore1. Over time, these circuits accumulate,encompassing a wide and useful body of proven capabilities.They also represent substantial effort. These considerationsmake publication an almost obligatory propositionand, as such, a group of circuits is presented here. This isnot the first time we have displayed such wares and, giventhe encouraging reader response, it will not be the last2.Eighteen circuits are included in this latest effort, roughlyarranged in the categories given in this publication’s title.They appear at the next paragraph.
標簽： 信號源 調節器 電源 電路分析
上傳時間： 2013-11-12
上傳用戶：012345
蟲蟲下載站版權所有 京ICP備2021023401號-1
