This application note describes how to decode standard DTMF tones using the minimum number of external discrete components and a PIC. The two examples use a PIC which has an 8 bit timer and either a comparator or an ADC, although it can be modified for use on a PIC which has only digital I/O. The Appendices have example code for the 16C662 (with comparator) and 16F877 (using the ADC). As the majority of the Digital Signal Processing is done in software, little is required in the way of external signal conditioning. Software techniques are used to model the individual elements of a DTMF Decoder IC.
上傳時間： 2013-11-21
上傳用戶：zhaoke2005
The PCA82C250 and PCA82C251 are advanced transceiver products for use in automotive and general industrialapplications with transfer rates up to 1 Mbit/s. They support the differential bus signal representation beingdescribed in the international standard for in-vehicle CAN high-speed applications (ISO 11898). Controller AreaNetwork (CAN) is a serial bus protocol being primarily intended for transmission of control related data between anumber of bus nodes.
上傳時間： 2013-11-24
上傳用戶：Alick
The PCA9519 is a 4-channel level translating I2C-bus/SMBus repeater that enables theprocessor low voltage 2-wire serial bus to interface with standard I2C-bus or SMBus I/O.While retaining all the operating modes and features of the I2C-bus system during thelevel shifts, it also permits extension of the I2C-bus by providing bidirectional buffering forboth the data (SDA) and the clock (SCL) lines, thus enabling the I2C-bus or SMBusmaximum capacitance of 400 pF on the higher voltage side. The SDA and SCL pins areover-voltage tolerant and are high-impedance when the PCA9519 is unpowered.
標簽： 4channel transla level 9519
上傳時間： 2013-11-19
上傳用戶：jisiwole
The TL2575 and TL2575HV represent superior alternatives to popular three-terminal linear regulators. Due totheir high efficiency, the devices significantly reduce the size of the heatsink and, in many cases, no heatsink isrequired. Optimized for use with standard series of inductors available from several different manufacturers, theTL2575 and TL2575HV greatly simplify the design of switch-mode power supplies by requiring a minimaladdition of only four to six external components for operation.
標簽： STEP-DOWN SWITCHING SIMPLE 1A
上傳時間： 2013-11-20
上傳用戶：jelenecheung
本文依據集成電路設計方法學，探討了一種基于標準Intel 8086 微處理器的單芯片計算機平臺的架構。研究了其與SDRAM，8255 并行接口等外圍IP 的集成，并在對AMBA協議和8086 CPU分析的基礎上，采用遵從AMBA傳輸協議的系統總線代替傳統的8086 CPU三總線結構，搭建了基于8086 IP 軟核的單芯片計算機系統，并實現了FPGA 功能演示。關鍵詞：微處理器； SoC；單芯片計算機；AMBA 協議 Design of 8086 CPU Based Computer-on-a-chip System（School of Electrical Engineering and Automation, Heifei University of Technology, Hefei, 230009,China）Abstract: According to the IC design methodology, this paper discusses the design of one kind of Computer-on-a-chip system architecture, which is based on the standard Intel8086 microprocessor,investigates how to integrate the 8086 CPU and peripheral IP such as, SDRAM controller, 8255 PPI etc. Based on the analysis of the standard Intel8086 microprocessor and AMBA Specification,the Computer-on-a-chip system based on 8086 CPU which uses AMBA bus instead of traditional three-bus structure of 8086 CPU is constructed, and the FPGA hardware emulation is fulfilled.Key words: Microprocessor; SoC; Computer-on-a-chip; AMBA Specification
上傳時間： 2013-12-27
上傳用戶：kernor
多功能高集成外圍器件6. 1 多功能高集成外圍器件82371PCI的英文名稱：Peripheral Component Interconnect （外圍部件互聯PCI總線）；82371是PCI總線組件。ISA是：Industry standard Architecture（工業標準體系結構）IDE是 （Integrated Device Electronics）集成電路設備簡稱PIIX4PIIX4器件（芯片）的特點1、是一種支持Pentium和PentiumII微處理器的部件。2、82371對ISA橋來說，是一種多功能PCI總線。3、對可移動性和桌面深綠色環境均提供支持。4、電源管理邏輯。5、被集成化的IDE控制器。6、增強了性能的DMA控制器。 （7）基于兩個82C59的中斷控制器。（8）基于82C54芯片的定時器。（9）USB（Universal Serial Bus）通用串行總線。（10）SMBus系統管理總線。（11）實時時鐘（12）順應Microsoft Win95所需的功能其芯片的邏輯框圖如圖6-1所示。 PIIX4芯片邏輯框圖6.1.1 概述PIIX4芯片是一個多功能的PCI器件，圖6-2 是82371在系統中扮演的角色。（續上圖）1. PCI與EIO之間的橋（PIIX4芯片）橋是不對程的，是各類不同標準總線與PCI總線連接，82371AB橋也可理解為一種總線轉換譯碼器和控制器，橋內包含復雜的協議總線信號和緩沖器。(1).在PCI系統內，當PIIX4操作時，它總是作為系統內各種模塊的主控設備，如USB和DMA控制器、IDE總線和分布式DMA的主控設備等，而且總是以ISA主控設備的名義出現。(2). 在向ISA總線或IDE總線進行傳送操作的傳送周期期間作為從屬設備使用，并對內部寄存器譯碼。PIIX4芯片（橋）的配置(1).可以把PIIX4芯片配置成整個ISA總線，或ISA總線的子集，也可擴展成EIO總線。在使用EIO總線時，可以把未使用的信號配置成通用的輸入和輸出。(2).PIIX4可直接驅動5個ISA插槽；(3).能提供字節-交換邏輯、I/O的恢復支持、等待狀態的生成以及SYSCLK的生成。(4).提供X-BUS鍵盤控制器芯片、BIOS芯片、實時時鐘芯片、二級微程序器等的選擇。2. IDE接口（總線主控設備的權利和同步DMA方式）IDE接口為4個IDE的設備提供支持，比如IDE接口的硬盤和CD-ROM等。注意：目前硬盤接口有5類：IDE、SCSI、Fibre Channel、IEEE1394和USB等。IDE口幾乎在PC機最多，因為便宜。SCSI多用于服務器和集群機。IDE的PIO IDE速率：14MB/s；而總線主控設備IDE的速率：33MB/s在PIIX4芯片的IDE系統內，配有兩個各次獨立的IDE信號通道。3. 具有兼容性的模塊—DMA、定時器/計數器、中斷控制器等（1）在PIIX4內的兩各82C37 DMA控制器經邏輯的組合，產生7個獨立的可編程通道。通道[0：3]是通過與8個二進位的硬件連線實現的。通過以字節為單位的計數進行傳送。而通道[5：7]是通過16個二進位的連線實現的，以字為單位的計數進行傳送。（2）DMA控制器還能通過PCI總線，處理舊的DMA的兩個不同的方法提供支持。（3）計數/定時器模塊在功能上與82C54等價。（4）中斷控制器與ISA兼容，其功能是兩個82C59的功能之和。
上傳時間： 2013-11-19
上傳用戶：3到15
The Infineon TriCore provides an Interrupt System with a high safety standard. Thisdocument contains some instructions on how to initiate an Interrupt from an externaldevice. First it will show you how to trigger an Interrupt Service Request by an impulseon Port 0 or Port 1. Then in the second part of the document you can find hints how todebounce impulses to enable the use of a simple switch as input device.Authors: Thomas Bliem, CQ Nguyen / Infineon SMI MD Apps
上傳時間： 2013-11-05
上傳用戶：uuuuuuu
The P90CL301 is a highly integrated 16/32 bit micro-controller especially suitable for applications requiring lowvoltage and low power consumption. It is fully software compatible with the 68000. Furthermore, it provides bothstandard as well as advanced peripheral functions on-chip.One of these peripheral functions is the I2C bus. This report describes worked-out driver software (written in C) toprogram the P90CL301 I2C interface. It also contains interface software routines offering the user a quick start inwriting a complete I2C system application.
上傳時間： 2014-01-06
上傳用戶：氣溫達上千萬的
The 87C576 includes two separate methods of programming theEPROM array, the traditional modified Quick-Pulse method, and anew On-Board Programming technique (OBP).Quick Pulse programming is a method using a number of devicepins in parallel (see Figure 1) and is the traditional way in which87C51 family members have been programmed. The Quick-Pulsemethod supports the following programming functions:– program USER EPROM– verify USER EPROM– program KEY EPROM– program security bits– verify security bits– read signature bytesThe Quick-Pulse method is quite easily suited to standardprogramming equipment as evidenced by the numerous vendors of87C51 compatible programmers on the market today. Onedisadvantage is that this method is not well suited to programming inthe embedded application because of the large number of signallines that must be isolated from the application. In addition, parallelsignals from a programmer would need to be cabled to theapplication’s circuit board, or the application circuit board wouldneed to have logic built-in to perform the programming functions.These requirements have generally made in-circuit programmingusing the modified Quick Pulse method impractical in almost all87C51 family applications.
上傳時間： 2013-10-21
上傳用戶：xiaozhiqban
winCE msdn講座 XP Embedded Now and the future Windows XP Embedded Developmentand Deployment Model OverviewWindows XP Embedded Component ModelWindows XP Embedded Studio Tools Microsoft WindowsXP Embedded Product Highlights Componentized version of Windows XP Professional~ 12,000 components and updates as of Service Pack 2Flexible localizationSame binaries and API as Windows XP ProfessionalHotfixes and service packsEmbedded Enabling FeaturesRuns on standard PC hardwareSupports boot on hard drives, compact flash, DiskOnChipand read-only mediaSupport for remote install and remote bootHeadless device and remote management supportIntegration with Microsoft management tools
上傳時間： 2013-10-31
上傳用戶：jrsoft
<strike id="gegie"></strike>
<li id="gegie"></li>