C# BigInteger class. BigInteger.cs is a csharp program. It is the BIgInteger class. It has methods: abs() , FermatLittleTest(int confidence) ,gcd(BigInteger bi) , genCoPrime(int bits, Random rand) , genPseudoPrime(int bits, int confidence, Random rand) , genRandomBits(int bits, Random rand) , isProbablePrime(int confidence) , isProbablePrime() , Jacobi(BigInteger a, BigInteger b) , LucasSequence(BigInteger P, BigInteger Q, BigInteger k, BigInteger n) ,max(BigInteger bi) , min(BigInteger bi) , modInverse(BigInteger modulus) , RabinMillerTest(int confidence) ,
標簽： BigInteger class BIgInteger program
上傳時間： 2013-12-23
上傳用戶：ynzfm
給定n個整數a , a , ,an 1 2 組成的序列。序列中元素i a 的符號定義為： ï î ï í ì - < = > = 1 0 0 0 1 0 sgn( ) i i i i a a a a 符號平衡問題要求給定序列的最長符號平衡段的長度L，即： þ ý ü î í ì = + - = å = £ £ £ max 1| sgn( ) 0 1 j k i i j n k L j i a 。 例如，當n=10，相應序列為：1，1，-1，-2，0，1，3，-1，2，-1 時，L=9。
上傳時間： 2015-10-28
上傳用戶：xaijhqx
16位A/D轉換程序，使用MAX+PLUS2做的，用狀態機做的，但不夠完善，望大家見諒
上傳時間： 2016-07-23
上傳用戶：趙云興
The Inter IC bus or I2C bus is a simple bidirectional two wire bus designed primarily for general control and data transfer communication between ICs. Some of the features of the I2C bus are: • Two signal lines, a serial data line (SDA) and a serial clock line (SCL), and ground are required. A 12V supply line (500mA max.) for powering the peripherals often may be present. • Each device connected to the bus is software addressable by a unique address and simple master/ slave relationships exist at all times masters can operate as master-transmitters or as master-receivers. • The I2C bus is a true multi-master bus including collision detection and arbitration to prevent data corruption if two or more masters simultaneously initiate data transfer systems. • Serial, 8-bit oriented, bidirectional data transfers can be made at up to 100 KBit/s in the standard mode or up to 400 KBit/s in the fast mode.
標簽： bus bidirectional primarily designed
上傳時間： 2013-12-11
上傳用戶：jeffery
//奇異值分解法求廣義逆 //本函數返回值小于0表示在奇異值分解過程, //中迭代值超過了60次還未滿足精度要求. //返回值大于0表示正常返回。 //a-長度為m*n的數組，返回時其對角線依次給出奇異值，其余元素為0 //m-矩陣的行數 //n-矩陣的列數 //aa-長度為n*m的數組，返回式存放A的廣義逆 //eps-精度要求 //u-長度為m*m的數組，返回時存放奇異值分解的左奇異量U //v-長度為n*n的數組，返回時存放奇異值分解的左奇異量V //ka-整型變量，其值為max(n,m)+1 //調用函數：dluav()
上傳時間： 2016-12-15
上傳用戶：康郎
計算全息close all clc clear A=zeros(64) A(15:20,20:40)=1 A(15:50,20:25)=1 A(45:50,20:40)=1 A(30:34,20:35)=1 ％ ppp=exp(rand(64)*pi*2*i) A=A.*ppp ％ Author s email: zjliu2001@163.com figure imshow(abs(A),[]) Fa=fft2(fftshift(A)) Fs=fftshift(Fa) Am=abs(Fs) ％ amplitude Ph=angle(Fs) ％ phase s=11 ％ 這表示邊長嗎？ cgh=zeros(64*s) th=max(max(abs(Fs)))
上傳時間： 2014-10-13
上傳用戶：wweqas
Video-DVM is a very cheap DVM that shows how an output as complex as a videocomposite signal can be generated entirely in software: two I/O pins and three resistors are all the hardware required. Connected to any TV set it displays voltages, included max and min peaks, using both giant digits and an analog bar-display . A serial data output for computer data logging is provided, too.
標簽： videocomposite Video-DVM complex output
上傳時間： 2014-12-09
上傳用戶：xuan‘nian
This routine calls the glpk library to solve a LP/MIP problem. A typical LP problem has following structure: [min|max] C x s.t. Ax ["="|"<="|">="] b {x <= UB} {x >= LB} The calling syntax is: [XMIN,FMIN,STATUS,EXTRA]=glpkmex(SENSE,C,A,B,CTYPE,LB,UB,... VARTYPE,PARAM,LPSOLVER,SAVE)
標簽： problem following routine library
上傳時間： 2014-12-01
上傳用戶：changeboy
A badic controller for the UART. It incorporates a -- transmit and receive FIFO (from Max+Plus II s MegaWizard -- plug-in manager). Note that no checking is done to see -- whether the FIFOs are overflowing or not. This strictly -- handles the transmitting and receiving of the data.
標簽： incorporates controller transmit receive
上傳時間： 2017-09-05
上傳用戶：13681659100
MAX+PLUSⅡ應用入門
上傳時間： 2013-06-04
上傳用戶：eeworm
