<strike id="eysco"></strike>
<center id="eysco"></center>
無線傳感器網絡，粒子濾波，particle filter for sensor network
標簽： 無線傳感器網絡
上傳時間： 2016-11-14
上傳用戶：firstbyte
The TMS320C54x, TMS320LC54x, and TMS320VC54x fixed-point, digital signal processor (DSP) families (hereafter referred to as the ’54x unless otherwise specified) are based on an advanced modified Harvard architecture that has one program memory bus and three data memory buses. These processors also provide an arithmetic logic unit (ALU) that has a high degree of parallelism, application-specific hardware logic, on-chip memory, and additional on-chip peripherals. These DSP families also provide a highly specialized instruction set, which is the basis of the operational flexibility and speed of these DSPs.
標簽： TMS 320 fixed-point processor
上傳時間： 2013-12-27
上傳用戶：宋桃子
FatFs06.rar FatFs is a generic file system module to implement the FAT file system to small embedded systems. The FatFs is written in compliance with ANSI C, therefore it is independent of hardware architecture. It can be incorporated into cheap microcontrollers, such as 8051, PIC, AVR, SH, Z80, H8, ARM and etc..., without any change.
標簽： system FatFs file implement
上傳時間： 2016-11-17
上傳用戶：chenxichenyue
The System Management BIOS Reference Specification addresses how motherboard and system vendors present management information about their products in a standard format by extending the BIOS interface on Intel architecture systems. The information is intended to allow generic instrumentation to deliver this data to management applications that use CIM (the WBEM data model) or direct access and eliminates the need for error prone operations like probing system hardware for presence detection.
標簽： Specification motherboard Management Reference
上傳時間： 2013-12-10
上傳用戶：鳳臨西北
DDR SDRAM控制器的VHDL源代碼，含詳細設計文檔。 The DDR, DCM, and SelectI/O™ features in the Virtex™ -II architecture make it the perfect choice for implementing a controller of a Double Data Rate (DDR) SDRAM. The Digital Clock Manager (DCM) provides the required Delay Locked Loop (DLL), Digital Phase Shift (DPS), and Digital Frequency Synthesis (DFS) functions. This application note describes a controller design for a 16-bit DDR SDRAM. The application note and reference design are enhanced versions of XAPP200 targeted to the Virtex-II series of FPGAs. At a clock rate of 133 MHz, 16-bit data changes at both clock edges. The reference design is fully synthesizable and achieves 133 MHz performance with automatic place and route tools.
上傳時間： 2014-11-01
上傳用戶：l254587896
Batch version of the back-propagation algorithm. ％ Given a set of corresponding input-output pairs and an initial network ％ [W1,W2,critvec,iter]=batbp(NetDef,W1,W2,PHI,Y,trparms) trains the ％ network with backpropagation. ％ ％ The activation functions must be either linear or tanh. The network ％ architecture is defined by the matrix NetDef consisting of two ％ rows. The first row specifies the hidden layer while the second ％ specifies the output layer. ％
標簽： back-propagation corresponding input-output algorithm
上傳時間： 2016-12-27
上傳用戶：exxxds
％ Train a two layer neural network with the Levenberg-Marquardt ％ method. ％ ％ If desired, it is possible to use regularization by ％ weight decay. Also pruned (ie. not fully connected) networks can ％ be trained. ％ ％ Given a set of corresponding input-output pairs and an initial ％ network, ％ [W1,W2,critvec,iteration,lambda]=marq(NetDef,W1,W2,PHI,Y,trparms) ％ trains the network with the Levenberg-Marquardt method. ％ ％ The activation functions can be either linear or tanh. The ％ network architecture is defined by the matrix NetDef which ％ has two rows. The first row specifies the hidden layer and the ％ second row specifies the output layer.
標簽： Levenberg-Marquardt desired network neural
上傳時間： 2016-12-27
上傳用戶：jcljkh
Train a two layer neural network with a recursive prediction error ％ algorithm ("recursive Gauss-Newton"). Also pruned (i.e., not fully ％ connected) networks can be trained. ％ ％ The activation functions can either be linear or tanh. The network ％ architecture is defined by the matrix NetDef , which has of two ％ rows. The first row specifies the hidden layer while the second ％ specifies the output layer.
標簽： recursive prediction algorithm Gauss-Ne
上傳時間： 2016-12-27
上傳用戶：ljt101007
電信運營商收入保障系統設計與實現 本文研究領域涉及嵌入式系統開發流程和方法、嵌入式移動通信終端系統軟硬件框架、NOR Flash芯片體系結構、Flash芯片驅動軟件的自適應算法、Flash映像文件空間壓縮算法、霍爾傳感器(Hall Sensor）驅動軟件原理和實現、LCD驅動軟件設計、LCD顏色校正算法和實現、LCD抗靜電硬件保護與軟件恢復序列的實現。
上傳時間： 2013-12-13
上傳用戶：mikesering
A MATLAB GUI platform for realizing the radiation pattern of narrowband beamformer with random array geometry. User can specify the array geometry, directions of incoming signals, noise power, and the type of beamformer. Useful for gaining insight about collaborative beamforming in sensor networks and random arrays. You need both randomarray.fig and randomarray.m to work.
標簽： beamformer narrowband realizing radiation
上傳時間： 2014-01-06
上傳用戶：qb1993225
<center id="qsuky"></center>