亚洲欧美第一页_禁久久精品乱码_粉嫩av一区二区三区免费野_久草精品视频

蟲蟲首頁| 資源下載| 資源專輯| 精品軟件
登錄| 注冊

CHip

CHip”技術作為生命科學的最新技術近些年來發展迅速,被廣泛的應用于各個生命科學領域,包括疾病預測與診斷、基因突變檢測、遺傳學產前診斷等臨床應用中。芯片技術包括最常見的DNA芯片(基因芯片)、蛋白芯片、microRNA芯片及最新開放的新型芯片等。
  • 單片機原理及應用實驗教學大綱(課典)

    一、課程簡介及要求: 課程名稱(中英文)單片機原理及應用      Principle of CHip Microcomputer     課程編碼           241016 學分               2 學時(含實驗:  )46 (8) 開課單位          信息學院實驗中心 課程內容          掌握 MCS51 匯編軟語言程序設計和調試方法、掌握 MCS51 單片機原理及其應用方法                                    選課對象          本科 相關理論課程         微機原理與應用;計算機控制技術;   測控電路;單片機原理及接口技術等 參考教材          單片機原理及應用 考試方式及評分標準

    標簽: 單片機原理 實驗 教學大綱

    上傳時間: 2014-12-27

    上傳用戶:HGH77P99

  • lpc2478完全使用手冊

    NXP Semiconductor designed the LPC2400 microcontrollers around a 16-bit/32-bitARM7TDMI-S CPU core with real-time debug interfaces that include both JTAG andembedded Trace. The LPC2400 microcontrollers have 512 kB of on-CHip high-speedFlash memory. This Flash memory includes a special 128-bit wide memory interface andaccelerator architecture that enables the CPU to execute sequential instructions fromFlash memory at the maximum 72 MHz system clock rate. This feature is available onlyon the LPC2000 ARM Microcontroller family of products. The LPC2400 can execute both32-bit ARM and 16-bit Thumb instructions. Support for the two Instruction Sets meansEngineers can choose to optimize their application for either performance or code size atthe sub-routine level. When the core executes instructions in Thumb state it can reducecode size by more than 30 % with only a small loss in performance while executinginstructions in ARM state maximizes core performance.

    標簽: 2478 lpc 使用手冊

    上傳時間: 2013-11-15

    上傳用戶:zouxinwang

  • 基于AT89C52單片機的步進電機控制系統設計

    基于AT89C52單片機的步進電機控制系統設計 摘 要: 提出了一個由AT89C52單片機控制步進電機的實例。可以通過鍵盤輸入相關數據, 并根據需要, 實時對步進電機工作方式進行設置, 具有實時性和交互性的特點。該系統可應用于步進電機控制的大多數場合。實踐表明, 系統性能優于傳統的步進電機控制器。 關鍵詞: 單片機; 步進電動機; 直流固態繼電器; 實時控制 ABSTRACT: A stepp ing motor control system based on AT89C52 CHip microcomputer was described.The data can be inputwith keyboard, and stepp ingmotorwas controlled by these data. According to the demand, users can set the workingmodel of stepp ingmotor in real2time. This system can be widely used in stepp ing motor controlling. The p ractice showed that the performance of this system outdid the tradi-tional stepp ing motor controller.

    標簽: 89C C52 AT 89

    上傳時間: 2013-11-22

    上傳用戶:vodssv

  • 單片機入門知識手冊

    單片機入門知識手冊 說到單片機,首先想到的是中央處理器(CPU),學過微型計算機的人都知道,CPU是計算機最核心的部分,它可以完成算術運算和邏輯運算,CPU再配上外部存儲器,輸入輸出單元就構成一臺微型計算機。其實單片機可以看成一臺微型計算機,它具有CPU的功能,并且自身帶有存儲器,帶有輸入輸出接口(如串行UART、AD轉化、PWM控制),單片機配上一些簡單的外圍電路,就可以完成智能控制或數據采集等。所以,單片機的英文名叫MCU(Micro CHip Uint),翻譯成中文是微控制單元。 單片機能干什么?通俗一點講,單片機只有兩個功能:一個是數據采集,另一個是控制。其實都很好理解,數據采集實際上是從外間輸入,如從AD(模數轉化)口讀入一個電壓值,從串口接收一個數據等等。控制實際上是輸出,51單片機有32個IO口,每個IO口可以驅高或驅低,單片機以此來實現對外間的控制。一個單片機系統都可以用下面這個框圖來說明:

    標簽: 單片機 入門知識

    上傳時間: 2013-10-26

    上傳用戶:zhaoman32

  • NEC 16位MCU參考手冊

    NEC 16位MCU參考手冊 The 78K0R/IC3 is a 16-bit single-CHip microcontroller that uses a 78K0R CPU core and incorporates peripheral functions, such as ROM/RAM, a multi-function timer, a multi-function serial interface, an A/D converter, a programmable gain amplifier (PGA), a comparator, a real-time counter, and a watchdog timer.

    標簽: NEC MCU 參考手冊

    上傳時間: 2013-11-02

    上傳用戶:努力努力再努力

  • CAT28LV64-64Kb CMOS并行EEPROM數據手

    The CAT28LV64 is a low voltage, low power, CMOS Parallel EEPROM organized as 8K x 8−bits. It requires a simple interface for in−system programming. On−CHip address and data latches, self−timed write cycle with auto−clear and VCC power up/down write protection eliminate additional timing and protection hardware. DATA Polling and Toggle status bit signal the start and end of the self−timed write cycle. Additionally, the CAT28LV64 features hardware and software write protection.

    標簽: EEPROM 64 CMOS CAT

    上傳時間: 2013-11-16

    上傳用戶:浩子GG

  • CAT25128-128Kb的SPI串行CMOS EEPRO

    The CAT25128 is a 128−Kb Serial CMOS EEPROM device internally organized as 16Kx8 bits. This features a 64−byte page write buffer and supports the Serial Peripheral Interface (SPI) protocol. The device is enabled through a CHip Select (CS) input. In addition, the required bus signals are clock input (SCK), data input (SI) and data output (SO) lines. The HOLD input may be used to pause any serial communication with the CAT25128 device. The device featuressoftware and hardware write protection, including partial as well as full array protection.

    標簽: 25128 EEPRO CMOS CAT

    上傳時間: 2013-11-15

    上傳用戶:fklinran

  • A Single-CHip Pulsoximeter Des

    This application report discusses the design of non-invasive optical plethysmographyalso called as pulsoximeter using the MSP430FG437 Microcontroller (MCU). Thepulsoximeter consists of a peripheral probe combined with the MCU displaying theoxygen saturation and pulse rate on a LCD glass. The same sensor is used for bothheart-rate detection and pulsoximetering in this application. The probe is placed on aperipheral point of the body such as a finger tip, ear lobe or the nose. The probeincludes two light emitting diodes (LEDs), one in the visible red spectrum (660nm) andthe other in the infrared spectrum (940nm). The percentage of oxygen in the body isworked by measuring the intensity from each frequency of light after it transmitsthrough the body and then calculating the ratio between these two intensities.

    標簽: Pulsoximeter Single-CHip Des

    上傳時間: 2013-10-27

    上傳用戶:黑漆漆

  • 數字時鐘應用資料

    數字時鐘應用資料 單片計算機即單片微型計算機。(Single-CHip Microcomputer ),是 集CPU ,RAM ,ROM ,定時,計數和多種接口于一體的微控制器。他體積小,成本低,功能強,廣泛應用于智能產品和工業自動化上。而51 單片機是各單片機中最為典型和最有代表性的一種。這次畢業設計通過對它的學習,應用,從而達到學習、設計、開發軟、硬的能力。

    標簽: 數字時鐘 應用資料

    上傳時間: 2013-10-13

    上傳用戶:zhqzal1014

  • FSL08系列單片機開發及C語言編程簡介

    以典型的9S08 系列為例,當你選擇了一個MCU 型號后,在圖1-4 右側會顯示出所有針對該型號芯片可用的項目調試場景。其中:Full CHip Simulator”是芯片全功能模擬仿真,即無需任何目標系統的硬件資源,直接在你的PC 機上模擬運行單片機的程序,在模擬運行過程中可以觀察調試程序的各項控制和運行流程,分析代碼運行的時間,觀察各種變量,等等。CW 提供了功能強大的模擬激勵功能,可以在模擬運行時模擬一些外部事件的輸入,配合程序調試;P&E Multilink/Cyclone Pro”是基于P&E 公司的硬件調試工具實現實時在線硬件調試。實際就是我們經常說的BDM 調試。BDM 調試是基于芯片本身內含的在線調試功能,可實現程序下載,單步/全速運行,可以設若干個斷點,可以觀察和修改任意寄存器或RAM 內存空間。BDM 幾乎是開發飛思卡爾8 位(9S08 和RS08 系列)、16 位(9S12 系列)和32 位(Coldfire V1 系列)單片機的標準調試模式,運用最為廣泛;SofTec HCS08”是另外一家SofTec 公司提供的硬件調試工具,國內使用較少;HCS08 Serial Monitor”是基于芯片串口的監控調試開發模式。由于開發效率較低,現在幾乎無人使用。

    標簽: FSL 08 C語言編程 單片機開發

    上傳時間: 2013-10-10

    上傳用戶:alex wang

主站蜘蛛池模板: 和平县| 博爱县| 宽甸| 徐水县| 麦盖提县| 荔浦县| 定南县| 田林县| 东港市| 建瓯市| 巴青县| 武平县| 贵阳市| 凉山| 宜春市| 延长县| 星子县| 宝应县| 阿巴嘎旗| 博客| 栾城县| 靖边县| 德格县| 武夷山市| 伊吾县| 渝中区| 且末县| 固安县| 亚东县| 兴仁县| 山东省| 香港| 钦州市| 广河县| 富裕县| 景泰县| 丰顺县| 桑日县| 九寨沟县| 平陆县| 高阳县|