16 relay output channels and 16 isolated digital input channels
LED indicators to show activated relays
Jumper selectable Form A/Form B-type relay output channel
Output status read-back
Keep relay output values when hot system reset
High-voltage isolation on input channels(2,500 VDC)
Hi ESD protection(2,00VDC)
High over-voltage protection(70VDC)
Wide input range(10~50VDC)
Interrupt handling capability
High-density DB-62 connector
Board ID
AutoBoot is a generic boot loader that automatically locates, loads, and
executes object files from multiple types of media. AutoBoot provides a simple,
fast, and functional means of loading an OS image while maintaining a small
Flash memory footprint. This binary release contains a stand-alone version of
AutoBoot for the DbAu1200 development board, designed to replace the YAMON boot
loader.
This demonstration shows how a ZigBee coordinator can be set up. This demo allows
the Demonstration Board (PICDEM Z or Explorer 16) to act as either a "Switching Load
Controller" (e.g. a light) or a "Switching Remote Control" (e.g. a switch) as defined by
the Home Controls, Lighting profile. It is designed to interact with a second Demonstration
board programmed with the Demo RFD project
The Lite Evaluation/Demonstration Kit is intended to illustrate use of the
AN3042. The AN3042 is compliant to the PCI 2.1 Local Bus specification.
Included in the kit is a PCI add-in card, Windows drivers, demonstration
applications, and documentation of the hardware and software provided. The
microprocessor used on the PCI add-in card is the Motorola MPC860. The
applications themselves serve as documentation on how to interface with the
drivers, and also may be used to test the AN3042 on the user s prototype board.
This will sample all 8 A/D-channels by the continous mode.
Each end of conversion will call an interrupt routine,
where the AD-channel is put to Port4[2..0]
and the upper nibble of the result is put to Port4[7..4].
Port 4 is connected to the user LEDs of the FlashCan100P Evaluation-Board
usb bulk 傳輸例程。
* The bulkusb driver is a generic function driver, based on the Windows Driver Model (WDM).
* Supports Plug and Play(PnP), Power Management(PM), Windows Management Instrumentation (WMI) and the Selective Suspend (SS) features.
* This sample is based off the selSusp DDK sample. Please refer the selSusp sample and the DDK docs to understand the handling of PnP, PM, WMI and SS features and implementations.
*
The USB device used for this sample is a generic Intel I82930 USB evaluation board programmed with a simple loopback test using a 64 KB circular buffer. None of the code in the sample is specific to this controller chip.
富士通單片機MB902420系列
extINT Project:
All external Interrupt-Pins INT0 .. INT7 will be enabled.
A falling edge on INTx will toggle PDR4_P4x
in order to toggle the LEDx of the Flash-CAN-100P Board
e.g. falling edge on INT3 will result in LED D3 will toggleP47..P40 (UserLEDs of FlashCan100P)
and will send out again as byte-packages to ID#2
Receive-Buffer #1 : basic can
Transmit-Buffer #6 : full-can ID #2
