This application note describes how to build a system that can be used for determining theoptimal phase shift for a Double Data Rate (DDR) memory feedback clock. In this system, theDDR memory is controlled by a controller that attaches to either the OPB or PLB and is used inan EMbedded microprocessor application. This reference system also uses a DCM that isconfigured so that the phase of its output clock can be changed while the system is running anda GPIO core that controls that phase shift. The GPIO output is controlled by a softwareapplication that can be run on a PowerPC® 405 or Microblaze™ microprocessor.
上傳時間： 2014-11-26
上傳用戶：erkuizhang
The introduction of Spartan-3™ devices has createdmultiple changes in the evolution of EMbedded controldesigns and pushed processing capabilities to the “almostfreestage.” With these new FPGAs falling under $20, involume, with over 1 million system gates, and under $5for 100K gate-level units, any design with programmablelogic has a readily available 8- or 16-bit processor costingless than 75 cents and 32-bit processor for less than $1.50.
上傳時間： 2013-10-21
上傳用戶：ligi201200
The Xilinx Zynq-7000 Extensible Processing Platform (EPP) redefines the possibilities for EMbedded systems, giving system and software architects and developers a flexible platform to launch their new solutions and traditional ASIC and ASSP users an alternative that aligns with today’s programmable imperative. The new class of product elegantly combines an industrystandard ARMprocessor-based system with Xilinx 28nm programmable logic—in a single device. The processor boots first, prior to configuration of the programmable logic. This, along with a streamlined workflow, saves time and effort and lets software developers and hardware designers start development simultaneously.
標簽： xilinx Zynq 7000 EPP
上傳時間： 2013-10-09
上傳用戶：evil
針對嵌入式機器視覺系統向獨立化、智能化發展的要求，介紹了一種嵌入式視覺系統--智能相機。基于對智能相機體系結構、組成模塊和圖像采集、傳輸和處理技術的分析，對國內外的幾款智能相機進行比較。綜合技術發展現狀，提出基于FPGA+DSP模式的硬件平臺，并提出智能相機的發展方向。分析結果表明，該系統設計可以實現脫離PC運行，完成圖像獲取與分析，并作出相應輸出。 Abstract: This paper introduced an EMbedded vision system-intelligent camera ，which was for EMbedded machine vision systems to an independent and intelligent development requirements. Intelligent camera architecture， component modules and image acquisition， transmission and processing technology were analyzed. After comparing integrated technology development of several intelligent cameras at home and abroad， the paper proposed the hardware platform based on FPGA+DSP models and made clear direction of development of intelligent cameras. On the analysis of the design， the results indicate that the system can run from the PC independently to complete the image acquisition and analysis and give a corresponding output.
標簽： FPGA DSP 模式 智能相機
上傳時間： 2013-11-14
上傳用戶：無聊來刷下
Prakash Rashinkar has over 15 years experience in system design and verificationof EMbedded systems for communication satellites, launch vehicles and spacecraftground systems, high-performance computing, switching, multimedia, and wirelessapplications. Prakash graduated with an MSEE from Regional Engineering College,Warangal, in India. He lead the team that was responsible for delivering themethodologies for SOC verification at Cadence Design Systems. Prakash is anactive member of the VSIA Functional Verification DWG. He is currently Architectin the Vertical Markets and Design Environments Group at Cadence.
上傳時間： 2013-11-19
上傳用戶：m62383408
SL811開發資料_包含源程序_電路圖_芯片資料:SL811HS EMbedded USB Host/Slave Controller.The SL811HS is an EMbedded USB Host/Slave Controller capable of communicate with either full-speed or low-speed USB peripherals. The SL811HS can interface to devices such as microprocessors, microcontrollers, DSPs, or directly to a variety of buses such as ISA, PCMCIA, and others. The SL811HS USB Host Controller conforms to USB Specification 1.1.The SL811HS USB Host/Slave Controller incorporates USB Serial Interface functionality along with internal full-/low-speed transceivers.The SL811HS supports and operates in USB full-speed mode at 12 Mbps, or at low-speed 1.5-Mbps mode.The SL811HS data port and microprocessor interface provide an 8-bit data path I/O or DMA bidirectional, with interrupt support to allow easy interface to standard microprocessors or microcontrollers such as Motorola or Intel CPUs and many others. Internally,the SL811HS contains a 256-byte RAM data buffer which is used for control registers and data buffer.The available package types offered are a 28-pin PLCC (SL811HS) and a 48-pin TQFP package (SL811HST-AC). Both packages operate at 3.3 VDC. The I/O interface logic is 5V-tolerant.
標簽： 811 SL 開發資料 源程序
上傳時間： 2013-12-22
上傳用戶：a82531317
CSL is a programming language with C syntax and comprehensive libraries. The compact scripting engine can also be EMbedded into your own applications as a powerful macro language. Windows Distribution utilities.
標簽： comprehensive programming libraries scripting
上傳時間： 2013-11-27
上傳用戶：xuanchangri
We intend to develop a wifi enabled p2p file sharing system on a linux platform using jxta and java. The purpose is to build a system that can be ported to an EMbedded device at a later stage and be used for p2p file sharing using the 802.11b standard. 我們旨在Linux平臺上使用jxta 和java來開發一個支持wifi的p2p文件共享系統。其目的是建造一個以后可以移植到嵌入式設備的系統，使用802.11b標準進行p2p文件共享。 來源: http://sourceforge.net/projects/linux-p2p-wifi/
標簽： platform develop enabled sharing
上傳時間： 2015-01-20
上傳用戶：Shaikh
JILRuntime A general purpose, register based virtual machine (VM) that supports object-oriented features, reference counting (auto destruction of data as soon as it is no longer used, no garbage collection), exceptions (handled in C/C++ or virtual machine code) and other debugging features. Objects and functions can be written in virtual machine code, as well as in C or C++, or any other language that can interface to C object code. The VM is written for maximum performance and thus is probably not suitable for EMbedded systems where a small memory footprint is required. Possible uses of the VM are in game development, scientific research, or to provide a stand-alone, general purpose programming environment.
標簽： object-oriented JILRuntime register supports
上傳時間： 2013-12-23
上傳用戶：cc1015285075
The JILRunOnly project is a simple command-line application written in ANSI-C that is intended to demonstrate in detail, how the JILRuntime/JewelScript library can be EMbedded into an application.
標簽： command-line application JILRunOnly intended
上傳時間： 2015-04-03
上傳用戶：ywqaxiwang
蟲蟲下載站版權所有 京ICP備2021023401號-1
