Lots useful AVR asm math routines (trigonometry, float point, intenger , vectors and etc)
標簽： trigonometry intenger routines vectors
上傳時間： 2017-09-08
上傳用戶：AbuGe
JMS是用于和面向消息的中間件相互通信的應用程序接口。它既支持點對點(point-to-point)的域，又支持發布/訂閱(publish/subscribe)類型的域，并且提供對下列類型的支持：經認可的消息傳遞,事務型消息的傳遞，一致性消息和具有持久性的訂閱者支持。JMS還提供了另一種方式來對您的應用與舊的后臺系統相集成。
標簽： point-to-point JMS 互通 應用程序
上傳時間： 2014-01-09
上傳用戶：1427796291
This book is about multipoint cooperative communication, a key technology to overcome the long-standing problem of limited transmission rate caused by inter- point interference. However, the multipoint cooperative communication is not an isolated technology. Instead, it covers a vast range of research areas such as the multiple-input multiple-outputsystem, the relay network, channel state information issues, inter-point radio resource management operations, coordinated or joint transmissions, etc. We suppose that any attempt trying to thoroughly analyze the multipoint cooperative communication technology might end up working on a cyclopedia for modern communication systems and easily get lost in discussing all kinds of cooperative communication schemes as well as the associated models and their variations.
標簽： Communication Multi-point Cooperative Systems
上傳時間： 2020-05-31
上傳用戶：shancjb
逆變器作為光伏陣列和電網接口的主要設備，它的性能決定著整個光伏發電系統的性能。為了將光伏陣列產生的電能最大限度地饋入電網，并提高其運行的穩定度、可靠性和精確度，必須對并網逆變器的主電路拓撲選擇、濾波器參數設計及其控制策略選取等進行深入研究。 論文首先分析了光伏發電的國內外發展現狀和應用前景，對光伏并網發電系統的種類、結構和并網標準進行了綜述。針對眾多適用于光伏并網的逆變器拓撲進行了詳細的比較分析，最終確定了一臺單相滿載功率1kW、并網電壓220V的逆變器拓撲及其主電路參數，對其輸出濾波器參數進行設計，并對其進行了幅頻特性分析。 其次，詳細分析和研究逆變器的并網控制策略，確定了在獨立工作模式下的瞬時電壓控制策略和在并網工作模式下的瞬時電流控制策略。根據選定的控制策略分別對其控制系統進行了建模和閉環參數設計，并利用Sabet軟件進行系統仿真，驗證了系統建模和設計的正確性。 接著，在分析光伏陣列特性的基礎上，總結和比較了常用的幾種MPPT（Maximum Power Point Tracking）控制方法，通過擾動觀測法對并網逆變器輸出電流的控制，實現了光伏陣列的MPPT，并給出了設計方案和實驗驗證。 最后，根據以上分析結果，研制了一臺基于DSP控制的光伏并網逆變器的試驗樣機，并詳述了其軟硬件的設計方案，給出了相關實驗結果。
上傳時間： 2013-04-24
上傳用戶：天天天天
·詳細說明：DTMF檢測程序。定點計算，可移植到DSP上。 Usage: dtmf filename -DTMF examination procedure. The fixed point calculation, may transplant to DSP on. Usage: Dtmf filename 文件列表: alaw.cpp alaw.h &nb
上傳時間： 2013-06-25
上傳用戶：sowhat
Many CAD users dismiss schematic capture as a necessary evil in the process of creating\r\nPCB layout but we have always disputed this point of view. With PCB layout now offering\r\nautomation of both component placement and track routing, getting the des
標簽： schematic necessary creating dismiss
上傳時間： 2013-09-25
上傳用戶：baiom
Abstract: IC switches and multiplexers are proliferating, thanks to near-continual progress in lowering the supply voltage,incorporating fault-protected inputs, clamping the output voltage, and reducing the switch resistances. The latest of these advancesis the inclusion of precision resistors to allow two-point calibration of gain and offset in precision data-acquisition systems.
上傳時間： 2013-11-12
上傳用戶：acwme
This paper presents a space vector modulation(SVM)-based switching strategy for a three-level neutral point clamped (NPC) converter that is adapted as a STATCOM.
上傳時間： 2013-10-20
上傳用戶：zyt
The MAX2691 low-noise amplifier (LNA) is designed forGPS L2 applications. Designed in Maxim’s advancedSiGe process, the device achieves high gain andlow noise figure while maximizing the input-referred 1dBcompression point and the 3rd-order intercept point. TheMAX2691 provides a high gain of 17.5dB and sub 1dBnoise figure.
標簽： Amplifier Low-Noise 2691 Band
上傳時間： 2014-12-04
上傳用戶：zaocan888
Sensors for pressure, load, temperature, acceleration andmany other physical quantities often take the form of aWheatstone bridge. These sensors can be extremely linearand stable over time and temperature. However, mostthings in nature are only linear if you don’t bend them toomuch. In the case of a load cell, Hooke’s law states that thestrain in a material is proportional to the applied stress—as long as the stress is nowhere near the material’s yieldpoint (the “point of no return” where the material ispermanently deformed).
上傳時間： 2013-11-13
上傳用戶：墻角有棵樹
