His folder contains the following files:
1. 02490rxP802-15_SG3a-Channel-Modeling-Subcommittee-Report-Final.doc: THis is the final
report of the channel modeling sub-committee.
2. cmx_imr.csv (x=1, 2, 3, and 4) represent the files containing the actual 100 channel
realizations for CM1, CM2, CM3, and CM4. The columns are organized as (time, amp, time, amp,...)
3. cmx_imr_np.csv (x=1, 2, 3, and 4) represent the files containing the number of paths in
each of the 100 multipath realizations.
4. cmx_imr.mat (x=1, 2, 3, and 4) are the .mat files that can be loaded directly into
Matlab (TM).
5. *.m files are the Matlab (TM) files used to generate the various channel realizations.
His project was built and tested with WinAVR-20060125.
Make sure the MCU target define in the Makefiles corresponds to the AVR you are using!!
To build the code, just install WinAVR and run "make" from the console in echomaster and
echoslave subdirs.
"make program" will program the device if you have a AVRISP attached.
Remember to set the AVR device to at least 8MHz. The AVR may use the programmable clock
from MC1319x, just remember to check if the MC1319x and SPI communication is working FIRST!
Otherwise you wont get any clock signal to the AVR and then you can t program it or reset
the fuses!
The MC1319x has default clock output of 32kHz so you will have to set your programmer to
a very low frequency (<=32kHz/4) to be able to program it while it is running on that!
EXAMPLE SOURCE CODE FOR TASM FILTER
His filter accepts input through the standard input stream, converts it and outputs it to the standard output stream. The streams are linked
through pipes, such that the input stream is the output from the assembler
being invoked, and the output stream is connected to the message window of the IDE, ie.
His packet is a IS-95 baseband simulation for 1 data channel of 9.6 KBps rate.
The simulation is written for static channel and AWGN noise. The packet include:
1) Packet Builder (Viterbi Encoding, Interleaver, PN generation)
2) Modulator (RRC filter)
3) Demodulator (Matched Filter, RAKE receiver)
4) Receiver (HD or SD) (Deinterleaver, Viterbi Decoder).
You should run "Simulation.m" function that include all modules.
HDOJ 1047
One of the first users of BIT s new supercomputer was Chip Diller. He extended His exploration of powers of 3 to go from 0 to 333 and he explored taking various sums of those numbers.
``THis supercomputer is great, remarked Chip. ``I only wish Timothy were here to see these results. (Chip moved to a new apartment, once one became available on the third floor of the Lemon Sky apartments on Third Street.)