This user’s manual describes SAMSUNG s S3C2440A 16/32-bit RISC microprocessor. SAMSUNG’s S3C2440A is
designed to provide hand-held devices and general applications with low-power, and high-performance microcontroller
solution in small die size. To reduce total system cost, the S3C2440A includes the following components.
This user’s manual describes SAMSUNG s S3C2440A 16/32-bit RISC microprocessor. SAMSUNG’s S3C2440A is
designed to provide hand-held devices and general applications with low-power, and high-performance microcontroller
solution in small die size. To reduce total system cost, the S3C2440A includes the following components.
SAMSUNG’s S3C2440A is
designed to provide hand-held devices and general applications with low-power, and high-performance microcontroller
solution in small die size. To reduce total system cost, the S3C2440A includes the following components.
This a simple bootloader for AT91SAM7{S,X}{64,128,256} processors. It
permits you to download new code to the device over USB. This bootrom is
installed at address 0x00000000 in the ARM, which means that it is the
first piece of code to execute after reset. At startup, it waits for
a few seconds to see if the downloader is trying to connect. If not,
then the bootloader gives up control and jumps to your program. If the
downloader is trying to connect, then the bootloader receives the new
program over USB and writes it into flash.
Hey. This some pid code for the atmega88 that I once used to control a heater. It s purpose
is pretty specific, and I only wrote it to work on the mega88, so the code itself won t be too useful. It is
a good place to start if you re trying to use or figure out pid though.