第一章 傳輸線理論一 傳輸線原理二 微帶傳輸線三 微帶傳輸線之不連續分析第二章 被動組件之電感設計與分析一 電感原理二 電感結構與分析三 電感設計與模擬四 電感分析與量測傳輸線理論與傳統電路學之最大不同，主要在于組件之尺寸與傳導電波之波長的比值。當組件尺寸遠小于傳輸線之電波波長時，傳統的電路學理論才可以使用，一般以傳輸波長（Guide wavelength）的二十分之ㄧ（λ/20）為最大尺寸，稱為集總組件（Lumped elements）；反之，若組件的尺寸接近傳輸波長，由于組件上不同位置之電壓或電流的大小與相位均可能不相同，因而稱為散布式組件（Distributed elements）。 由于通訊應用的頻率越來越高，相對的傳輸波長也越來越小，要使電路之設計完全由集總組件所構成變得越來越難以實現，因此，運用散布式組件設計電路也成為無法避免的選擇。 當然，科技的進步已經使得集總組件的制作變得越來越小，例如運用半導體制程、高介電材質之低溫共燒陶瓷（LTCC）、微機電（MicroElectroMechanical Systems, MEMS）等技術制作集總組件，然而，其中電路之分析與設計能不乏運用到散布式傳輸線的理論，如微帶線（Microstrip Lines）、夾心帶線（Strip Lines）等的理論。因此，本章以討論散布式傳輸線的理論開始，進而以微帶傳輸線為例介紹其理論與公式，并討論微帶傳輸線之各種不連續之電路，以作為后續章節之被動組件的運用。
標簽： 傳輸線
上傳時間： 2014-01-10
上傳用戶：sunshie
We provide complete power solutions with a full lineup of power managementproducts. This brochure provides an overview of our high performance DC/DC switching regulatorcontrollers for applications including datacom, telecom, industrial, automotive, medical, avionicsand control systems. We make power design easier with our industry-leading field applicationengineering support; a broad selection of demonstration boards with schematics, layout filesand parts lists; SwitcherCAD® software for simulation, application notes and comprehensivetechnical documentation.
上傳時間： 2013-10-15
上傳用戶：lz4v4
In industrial applications, high voltage power supply spikes with durations ranging from a few microseconds to hundreds of millisecondsare commonly encountered. The electronics in these systems must not only survive transient voltage spikes, but in many cases alsooperate reliably throughout the event.
上傳時間： 2013-11-07
上傳用戶：redmoons
Abstract: This application note illustrates an intermediate 8V switching power supply for an automotive radio and infotainment system.The design withstands the complete automotive input voltage range (including cold crank and load dump conditions), assuring a stable8V supply for common subsystems such as a CD driver, LCDs, and a radio module in modern infotainment systems. To avoiddisturbance in the AM and FM bands, the switching power supply runs at a fixed frequency of 2MHz, enabling an ideal solution forradio systems.
上傳時間： 2013-11-20
上傳用戶：feitian920
Abstract: Investment in smart meters and smart grid end equipment continues to grow worldwide as countriestry to make their electric delivery systems more efficient. However, as critical as the electric deliveryinfrastructure is, it is normally not secured and thus subject to attack. This article describes the concept oflife-cycle security—the idea that embedded equipment in the smart grid must have security designed into theentire life of the product, even back to the contract manufacturer. We also talk about how life-cycle securityapplies to embedded equipment in the smart grid. Potential threats are discussed, as are potential solutionsto mitigate the risks posed by those threats.
上傳時間： 2014-12-24
上傳用戶：熊少鋒
Sensing and/or controlling current flow is a fundamental requirement in many electronics systems, and the tech-niques to do so are as diverse as the applications them-selves.
標簽： 電流采樣
上傳時間： 2013-10-15
上傳用戶：daoyue
PCI ExpressTM is the third generation of PCI (PeripheralComponent Interconnect) technology used to connect I/Operhipheral devices in computer systems. It is intended asa general purpose I/O device interconnect that meets theneeds of a wide variety of computing platforms such asdesktop, mobile, server and communications. It alsospecifies the electrical and mechanical attributes of thebackplane, connectors and removable cards in thesesystems.
上傳時間： 2013-11-17
上傳用戶：squershop
Multiple-voltage electronics systems often requirecomplex supply voltage tracking or sequencing, whichif not met, can result in system faults or even permanentfailures in the fi eld. The design diffi culties in meetingthese requirements are often compounded in distributedpowerarchitectures where point-of-load (POL) DC/DCconverters or linear regulators are scattered across PCboard space, sometimes on different board planes. Theproblem is that power supply circuitry is often the lastcircuitry to be designed into the board, and it must beshoehorned into whatever little board real estate is left.Often, a simple, drop-in, fl exible solution is needed tomeet these requirements.
上傳時間： 2013-10-08
上傳用戶：15071087253
Although recent popular attention is focused on LithiumIon batteries, one must not forget that other batterychemistries, such as Nickel Cadmium (NiCd) and NickelMetal Hydride (NiMH) have advantages in rechargeablepower systems. Nickel-based batteries are robust, capableof high discharge rates, have good cycle life, do notrequire special protection circuitry and are less expensivethan Li-Ion. Among the two, NiMH batteries are rapidlyreplacing NiCd because of their higher capacity (40% to50% more) and the environmental concerns of the toxiccadmium contained in NiCd batteries.
上傳時間： 2013-11-04
上傳用戶：qq10538412
Easy-to-use and compact point-of-load power suppliesare necessary in systems with widely distributed, highcurrent, low voltage loads. The LTC®3415 provides acompact, simple and versatile solution. It includes a pairof integrated complementary power MOSFETs (32mΩtop and 25mΩ bottom) and requires no external senseresistor. A complete design requires an inductor andinput/output capacitors, and that’s it. The result is a fast,constant frequency, 7A current mode DC/DC switchingregulator.
上傳時間： 2013-10-18
上傳用戶：avensy
