The matlab program is effective to be used for fringe processing. It contours strain distribution using an interferogram.
標簽： distribution processing effective contours
上傳時間： 2017-09-23
上傳用戶：libenshu01
變量和相等問題的設計和實現將a、b、c、d、e、f這6個變量排成如圖所示的 三角形，這6個變量分別取 1——6的整數，且均不相同。求使三角形三條邊上的變量之和相等的全部解，如 3 6 2 1 4 5 為一個解。 程序引入變量a,b,c,d,e,f,并讓它們分別取1——6的整數，在它們互不相等的 條件下， 測試由它們排成如圖所示的三角形三條邊上的變量之和是否相等，如相等即為一種滿足要求的排列，把它們輸出。當這些變量取盡所有的組合后，程序就可得到全部可能的解。
上傳時間： 2015-11-04
上傳用戶：GavinNeko
Floyd-Warshall算法描述 1)適用范圍： a)APSP(All Pairs Shortest Paths) b)稠密圖效果最佳 c)邊權可正可負 2)算法描述： a)初始化：dis[u,v]=w[u,v] b)For k:=1 to n For i:=1 to n For j:=1 to n If dis[i,j]>dis[i,k]+dis[k,j] Then Dis[I,j]:=dis[I,k]+dis[k,j] c)算法結束：dis即為所有點對的最短路徑矩陣 3)算法小結：此算法簡單有效，由于三重循環結構緊湊，對于稠密圖，效率要高于執行|V|次Dijkstra算法。時間復雜度O(n^3)。 考慮下列變形：如(I,j)∈E則dis[I,j]初始為1,else初始為0，這樣的Floyd算法最后的最短路徑矩陣即成為一個判斷I,j是否有通路的矩陣。更簡單的，我們可以把dis設成boolean類型，則每次可以用“dis[I,j]:=dis[I,j]or(dis[I,k]and dis[k,j])”來代替算法描述中的藍色部分，可以更直觀地得到I,j的連通情況。
標簽： Floyd-Warshall Shortest Pairs Paths
上傳時間： 2013-12-01
上傳用戶：dyctj
All inputs of the C16x family have Schmitt-Trigger input characteristics. These Schmitt-Triggers are intended to always provide proper internal low and high levels, even if anundefined voltage level (between TTL-VIL and TTL-VIH) is externally applied to the pin.The hysteresis of these inputs, however, is very small, and can not be properly used in anapplication to suppress signal noise, and to shape slow rising/falling input transitions.Thus, it must be taken care that rising/falling input signals pass the undefined area of theTTL-specification between VIL and VIH with a sufficient rise/fall time, as generally usualand specified for TTL components (e.g. 74LS series: gates 1V/us, clock inputs 20V/us).The effect of the implemented Schmitt-Trigger is that even if the input signal remains inthe undefined area, well defined low/high levels are generated internally. Note that allinput signals are evaluated at specific sample points (depending on the input and theperipheral function connected to it), at that signal transitions are detected if twoconsecutive samples show different levels. Thus, only the current level of an input signalat these sample points is relevant, that means, the necessary rise/fall times of the inputsignal is only dependant on the sample rate, that is the distance in time between twoconsecutive evaluation time points. If an input signal, for instance, is sampled throughsoftware every 10us, it is irrelevant, which input level would be seen between thesamples. Thus, it would be allowable for the signal to take 10us to pass through theundefined area. Due to the sample rate of 10us, it is assured that only one sample canoccur while the signal is within the undefined area, and no incorrect transition will bedetected. For inputs which are connected to a peripheral function, e.g. capture inputs, thesample rate is determined by the clock cycle of the peripheral unit. In the case of theCAPCOM unit this means a sample rate of 400ns @ 20MHz CPU clock. This requiresinput signals to pass through the undefined area within these 400ns in order to avoidmultiple capture events.For input signals, which do not provide the required rise/fall times, external circuitry mustbe used to shape the signal transitions.In the attached diagram, the effect of the sample rate is shown. The numbers 1 to 5 in thediagram represent possible sample points. Waveform a) shows the result if the inputsignal transition time through the undefined TTL-level area is less than the time distancebetween the sample points (sampling at 1, 2, 3, and 4). Waveform b) can be the result ifthe sampling is performed more than once within the undefined area (sampling at 1, 2, 5,3, and 4).Sample points:1. Evaluation of the signal clearly results in a low level2. Either a low or a high level can be sampled here. If low is sampled, no transition willbe detected. If the sample results in a high level, a transition is detected, and anappropriate action (e.g. capture) might take place.3. Evaluation here clearly results in a high level. If the previous sample 2) had alreadydetected a high, there is no change. If the previous sample 2) showed a low, atransition from low to high is detected now.
上傳時間： 2013-10-23
上傳用戶：copu
The government of a small but important country has decided that the alphabet needs to be streamlined and reordered. Uppercase letters will be eliminated. They will issue a royal decree in the form of a String of B and A characters. The first character in the decree specifies whether a must come ( B )Before b in the new alphabet or ( A )After b . The second character determines the relative placement of b and c , etc. So, for example, "BAA" means that a must come Before b , b must come After c , and c must come After d . Any letters beyond these requirements are to be excluded, so if the decree specifies k comparisons then the new alphabet will contain the first k+1 lowercase letters of the current alphabet. Create a class Alphabet that contains the method choices that takes the decree as input and returns the number of possible new alphabets that conform to the decree. If more than 1,000,000,000 are possible, return -1. Definition
標簽： government streamline important alphabet
上傳時間： 2015-06-09
上傳用戶：weixiao99
this paper talks about ofdm synchronization for selective fading channels,hope it to be of help to evrybody
標簽： synchronization selective channels fading
上傳時間： 2014-01-18
上傳用戶：fanboynet
1. 下列說法正確的是 （ ） A. Java語言不區分大小寫 B. Java程序以類為基本單位 C. JVM為Java虛擬機JVM的英文縮寫 D. 運行Java程序需要先安裝JDK 2. 下列說法中錯誤的是 ( ) A. Java語言是編譯執行的 B. Java中使用了多進程技術 C. Java的單行注視以//開頭 D. Java語言具有很高的安全性 3. 下面不屬于Java語言特點的一項是( ) A. 安全性 B. 分布式 C. 移植性 D. 編譯執行 4. 下列語句中，正確的項是 ( ) A . int $e,a,b=10 B. char c,d=’a’ C. float e=0.0d D. double c=0.0f
上傳時間： 2017-01-04
上傳用戶：netwolf
ITU-T G.729 Annex C+ - Reference C code for floating point implementation of G.729 at 6.4/8/11.8 kbit/s with DTX functionality (integration of Annexes B, D and E)
標簽： implementation 729 Reference floating
上傳時間： 2017-04-10
上傳用戶：cccole0605
* 高斯列主元素消去法求解矩陣方程AX=B,其中A是N*N的矩陣,B是N*M矩陣 * 輸入: n----方陣A的行數 * a----矩陣A * m----矩陣B的列數 * b----矩陣B * 輸出: det----矩陣A的行列式值 * a----A消元后的上三角矩陣 * b----矩陣方程的解X
上傳時間： 2015-07-26
上傳用戶：xauthu
This section contains a brief introduction to the C language. It is intended as a tutorial on the language, and aims at getting a reader new to C started as quickly as possible. It is certainly not intended as a substitute for any of the numerous textbooks on C. 2. write a recursive function FIB (n) to find out the nth element in theFibanocci sequence number which is 1,1,2,3,5,8,13,21,34,55,…3. write the prefix and postfix form of the following infix expressiona + b – c / d + e * f – g * h / i ^ j4. write a function to count the number of nodes in a binary tr
標簽： introduction the contains intended
上傳時間： 2013-12-23
上傳用戶：liansi
