亚洲欧美第一页_禁久久精品乱码_粉嫩av一区二区三区免费野_久草精品视频

蟲蟲首頁| 資源下載| 資源專輯| 精品軟件
登錄| 注冊

experimental

  • 高精度雙向DC電源電流采樣電路設計

    為適應雙向DC/DC功率變換的電流采樣需求,一種高精度高邊電流采樣電路被提出。其基本思想是在功率電路的高邊串入采樣電阻,借助電流鏡原理并引入偏置電流電路,將雙向電流均轉換為正向電壓輸出。通過理論分析與仿真結合的方法對電流鏡采樣原理及4種不同的偏置電流電路方案進行對比,最后通過實驗數據驗證了高精度高邊電流采樣電路的有效性。實驗數據表明,該采樣電路可在-25~75℃的溫度工作范圍內,針對-10~+10 A范圍內的電流采樣實現優于5%的采樣精度。Current sensing plays an important role in controlling,monitoring or protection functions of power systems.To meet the current sensing requirement of bidirectional DC/DC converters,a high-accuracy bidirectional current sensing circuit is proposed.The proposed current sensing circuit inserts a resistor in the path of the current to be sensed,while the current mirror and biased current circuit are introduced.Therefore,the bidirectional current can be expressed by positive voltage.By theoretical analysis and simulation,the sampling theory is analyzed and four biased current circuits are compared.At last,experimental results verified the proposed method.It is demonstrated that the proposed current sensing circuit can achi...

    標簽: 雙向DC電源 電流采樣

    上傳時間: 2022-04-22

    上傳用戶:

  • 基于無跡卡爾曼濾波算法的鋰電池SOC估計

    應用無跡卡爾曼濾波算法(UKF)進行鋰電池的SOC估計,采用Thevenin二階RC等效電路模型,對HPPC電池脈沖充放電實驗數據進行Matlab處理,得到較為準確的模型.通過在Matlab中編寫算法程序,對不同工況的估計值與實際值進行誤差估算及對比分析,通過此算法進行SOC估計,得到該算法可有效降低系統誤差并糾正SOC的初值偏差.The non trace Calman filter (UKF) is applied to the SOC estimation of lithium battery. The Thevenin two order RC equivalent circuit model is used to process the HPPC battery pulse charge discharge experimental data by Matlab processing, and a more accurate model is obtained. By writing algorithm program in Matlab, the error estimation and comparison analysis of the estimated value and actual value of different states are carried out, and the SOC estimation is carried out by this algorithm. The algorithm can effectively reduce the system error and correct the initial value deviation of the SOC.

    標簽: 卡爾曼濾波

    上傳時間: 2022-05-03

    上傳用戶:默默

  • 基于DSP28335+IR2110芯片的移相全橋驅動電路設計

    為解決移相全橋電路驅動及相角控制問題,設計了一種數字控制的移相全橋驅動電路.以TPL521為光耦隔離、IR2110為柵極驅動芯片.由DSP產生PWM信號,經過光耦隔離和邏輯電路后送至IR2110進行相角控制.文章對IR2110驅動電路原理進行分析及參數進行設計,對TMS320F28335進行設置并給出部分代碼.實驗結果表明:通過TMS320F28335可產生的不同相角的PWM波形,滿足了移相全橋對不同相角控制的要求.In order to solve the problem of phase-shifted full-bridge circuit driving and phase angle control,a digitally controlled phaseshifted full-bridge driving circuit was designed. TPL521 optocoupler isolation,IR2110 gate driver chip. PWM signals are generated by the DSP and sent to the IR2110 for phase angle control after optocoupler isolation and logic circuits. This text carries on the analysis to the principle of IR2110 drive circuit and parameter design,set up and give out some code to TMS320F28335. The experimental results show that the PWM waveforms with different phase angles generated by TMS320F28335 can meet the requirements of phase-shifted full-bridge control for different phase angles.

    標簽: dsp28335 ir2110 芯片

    上傳時間: 2022-05-03

    上傳用戶:zhanglei193

  • 基于PSIM仿真的開關電源Boost電路的設計

    基于PSIM仿真軟件,分析了Boost電路拓撲結構,設定了參數要求進行電路仿真設計,通過電路仿真軟件PSIM對Boost電路工作在CCM模式下,合理設置占空比參數。實驗結果表明理論分析與仿真的一致性和參數設計的正確性,輸出電壓和電流參數穩定,Boost電路輸出效率高。This design is based on PSIM simulation software,analyzes the topology of Boost circuit,sets the parameter re- quirements for circuit simulation design,and reasonably sets the duty cycle parameters for Boost circuit working in CCM mode through PSIM simulation software.The experimental results show that the theoretical analysis and simulation are consis- tent and the parameter design is correct,the output voltage and current parameters are stable.

    標簽: psim 開關電源 boost

    上傳時間: 2022-05-04

    上傳用戶:

主站蜘蛛池模板: 城固县| 青铜峡市| 蒙阴县| 城市| 房产| 台安县| 乌鲁木齐县| 泾阳县| 青冈县| 巴塘县| 阜新市| 莎车县| 府谷县| 阿拉尔市| 洛川县| 红安县| 三亚市| 社会| 浠水县| 岳阳市| 吉林市| 绵阳市| 河西区| 桦南县| 惠东县| 黄平县| 广南县| 普格县| 惠东县| 浙江省| 香港 | 安新县| 栖霞市| 克拉玛依市| 隆林| 义马市| 太仓市| 甘南县| 祁连县| 安庆市| 西安市|