出了一種新型的低成本單相在線不間斷電源（UPS）。該系統包括具有功率因數校正（PFC）功能的整流/升壓轉換器和連接到DC-Link總線的兩橋臂逆變器，電池組通過一個非常簡單的系統可直接連接到DC-Link總線。采用6開關管的架構，相對于傳統的8開關管全橋拓撲結構的系統降低了成本。即使在非線性負載下，該系統仍具有功率密度高和高品質輸出電壓的特點。最后詳細描述了電路操作、分析以及模擬和實驗結果。
上傳時間： 2013-11-04
上傳用戶：雨出驚人love
The LTC®3562 quad output step-down regulator is designedfor multicore handheld microprocessor applications thatoperate from a single Li-Ion battery. Its four monolithic, higheffi ciency buck regulators support Intel’s mobile CPU P-Stateand C-State energy saving operating modes. The outputvoltages are independently controllable via I2C, and eachoutput can be independently started and shut down. Designerscan choose from power saving pulse-skipping mode orBurst Mode® operation, or select low noise LDO mode. Thespace-saving LTC3562 is available in a 3mm × 3mm QFNpackage and requires few external components.
上傳時間： 2013-10-07
上傳用戶：1583060504
Industrial remote monitoring systems and keep-alivecircuits spend most of their time in standby mode. Manyof these systems also depend on battery power, so powersupply effi ciency in standby state is very important tomaximize battery life. The LT®8410/-1 high effi ciencyboost converter is ideal for these systems, requiringonly 8.5μA of quiescent current in standby mode. Thedevice integrates high value (12.4M/0.4M) output feedbackresistors, signifi cantly reducing input current whenthe output is in regulation with no load. Other featuresinclude an integrated 40V switch and Schottky diode,output disconnect with current limit, built in soft-start,overvoltage protection and a wide input range, all in atiny 8-pin 2mm × 2mm DFN package.
上傳時間： 2013-11-23
上傳用戶：新手無憂
K10的GPIO庫函數之實現LED燈亮滅 T17D0 000:565 SEGGER J-Link V4.40c Log File (0001ms, 0563ms total)
上傳時間： 2013-10-08
上傳用戶：ls530720646
該應用報告描述了旋轉檢測器的實現，該旋轉檢測器使用一對可檢測磁場的巨磁阻GMR（Giant Magneto-Resistive,）傳感器。傳感器的分布使它們不使用正交信號序列，這提供了討論非正交情況如何配置SIF的機會。討論了調試SIF應用程序的技術，提供了一個設計非正交進程狀態機（processing state machines）的工具。
上傳時間： 2013-10-21
上傳用戶：sammi
便攜式信號采集在機器健康診斷系統中有較高的應用價值。機器健康診斷的信號特點是包括低頻信號。本文研究是為了實現簡易而且低成本的低頻便攜式信號采集。以Microchip公司單片機PIC18F1320為核心設計信號采集電路，實現了信號的采集和保存。系統采用串行電可擦除芯片24LC32A保存數據，經過有線通信，信號數據由串行口通過MAX232芯片輸送到微型計算機接收和保存，最后繪制出信號波形。 微型計算機程序采用Visual Basic編程。研究成功采樣頻率為3 kHz的復雜信號，證明該方案符合設計要求。 Abstract: Portable signal acquisition is useful in machine health monitoring systems. The signal characteristics of machine health monitoring includes low frequency signals. The goal of this study is to realize simple, inexpensive and portable low frequency signal sampling. This paper provides the project of signal acquisition system design based on PIC18F1320 microcontroller manufactured by the Microchip Technology Incorporation to achieve signal sampling and storage. The system adopted EEPROM 24LC32A to store the signal data. The microcomputer received data via wired link with the MAX232 IC through the serial port. The microcomputer program, programmed in Visual Basic, received the data, stored it and plotted the signal. The study successfully samples 3kHz complicated signals and thus meets the design requirement.
上傳時間： 2013-11-19
上傳用戶：moerwang
The CAT93C46 is a 1 kb Serial EEPROM memory device which isconfigured as either 64 registers of 16 bits (ORG pin at VCC) or 128registers of 8 bits (ORG pin at GND). Each register can be written (orread) serially by using the DI (or DO) pin. The CAT93C46 features aself−timed internal write with auto−clear. On−chip Power−On Resetcircuit protects the internal logic against powering up in the wrongstate.
上傳時間： 2013-11-20
上傳用戶：ynzfm
The SN65LBC170 and SN75LBC170 aremonolithic integrated circuits designed forbidirectional data communication on multipointbus-transmission lines. Potential applicationsinclude serial or parallel data transmission, cabledperipheral buses with twin axial, ribbon, ortwisted-pair cabling. These devices are suitablefor FAST-20 SCSI and can transmit or receivedata pulses as short as 25 ns, with skew lessthan 3 ns.These devices combine three 3-state differentialline drivers and three differential input linereceivers, all of which operate from a single 5-Vpower supply.The driver differential outputs and the receiverdifferential inputs are connected internally to formthree differential input/output (I/O) bus ports thatare designed to offer minimum loading to the buswhenever the driver is disabled or VCC = 0. Theseports feature a wide common-mode voltage rangemaking the device suitable for party-lineapplications over long cable runs.
上傳時間： 2013-10-13
上傳用戶：ytulpx
keil c51 v9.01此版不是漢化中文版，是英文版來的。ARM發布Keil μVision4集成開發環境(IDE)，用來在微控制器和智能卡設備上創建、仿真和調試嵌入式應用。 μVision4 IDE是為增強開發人員的工作效率設計的，有了它可以更快速、更高效地開發和檢驗程序。通過μVision4 IDE中引入的靈活的窗口管理系統，開發人員可以使用多臺監視器，在可視界面任何地方全面控制窗口放置。 新用戶界面可以更好地利用屏幕空間，更有效地組織多個窗口，為開發應用提供整齊高效的環境。 μVision4在μVision3的成功經驗的基礎上增加了：* System Viewer (系統查看程序)窗口，提供了設備外圍寄存器信息，這些信息可以在System Viewer窗口內部直接更改。* Debug Restore Views (調試恢復視圖)允許保存多個窗口布局，為程序分析迅速選擇最適合的調試視圖。* Multi-Project Workspace(多項目工作空間)為處理多個并存的項目提供了簡化的方法，如引導加載程序和應用程序。* 為基于ARM Cortex 處理器的MCU提供了Data and instruction trace(數據和指令追蹤)功能。* 擴展了Device Simulation(設備仿真)功能以支持許多新設備，如Luminary、NXP和東芝生產的基于ARM Cortex-M3處理器的MCU；Atmel SAM7/9；及新的8051衍生品，如Infineon XC88x和SiLABS 8051Fxx。* 支持許多debug adapter interfaces(調試適配器接口)，包括ADI miDAS Link、Atmel SAM-ICE、Infineon DAS和ST-Link。
上傳時間： 2013-10-31
上傳用戶：qingdou
NXP Semiconductor designed the LPC2400 microcontrollers around a 16-bit/32-bitARM7TDMI-S CPU core with real-time debug interfaces that include both JTAG andembedded Trace. The LPC2400 microcontrollers have 512 kB of on-chip high-speedFlash memory. This Flash memory includes a special 128-bit wide memory interface andaccelerator architecture that enables the CPU to execute sequential instructions fromFlash memory at the maximum 72 MHz system clock rate. This feature is available onlyon the LPC2000 ARM Microcontroller family of products. The LPC2400 can execute both32-bit ARM and 16-bit Thumb instructions. Support for the two Instruction Sets meansEngineers can choose to optimize their application for either performance or code size atthe sub-routine level. When the core executes instructions in Thumb state it can reducecode size by more than 30 % with only a small loss in performance while executinginstructions in ARM state maximizes core performance.
上傳時間： 2013-11-15
上傳用戶：zouxinwang
