This application note describes a reference system which illustrates how to build an embeddedPowerPC® system using the Xilinx 1-Gigabit Ethernet Media Access Controller processor core.This system has the PLB_Gemac configured to use Scatter/Gather Direct Memory Access andthe Serializer/Deserializer (SerDes) interface. This application note describes how to set up thespecific clocking structure required for the SerDes interface and the constraints to be added tothe UCF file. This reference system is complete with a standalone software application to testsome of the main features of this core, including access to registers, DMA capabilities, transmitand receive in loopback mode. This reference system is targeted for the ML300 evaluationboard.
上傳時間: 2013-11-01
上傳用戶:truth12
待機電流只有1.5µA,電源電壓為2.5V~3.6V,I2C總線電壓為1.7V~5V
上傳時間: 2013-11-13
上傳用戶:baba
The NCV7356 is a physical layer device for a single wire data linkcapable of operating with various Carrier Sense Multiple Accesswith Collision Resolution (CSMA/CR) protocols such as the BoschController Area Network (CAN) version 2.0. This serial data linknetwork is intended for use in applications where high data rate is notrequired and a lower data rate can achieve cost reductions in both thephysical media components and in the microprocessor and/ordedicated logic devices which use the network.The network shall be able to operate in either the normal data ratemode or a high-speed data download mode for assembly line andservice data transfer operations. The high-speed mode is onlyintended to be operational when the bus is attached to an off-boardservice node. This node shall provide temporary bus electrical loadswhich facilitate higher speed operation. Such temporary loads shouldbe removed when not performing download operations.The bit rate for normal communications is typically 33 kbit/s, forhigh-speed transmissions like described above a typical bit rate of83 kbit/s is recommended. The NCV7356 features undervoltagelockout, timeout for faulty blocked input signals, output blankingtime in case of bus ringing and a very low sleep mode current.
上傳時間: 2013-10-24
上傳用戶:s藍莓汁
1.增加的設備支持: Atmel AT91SAM9Rxx Cirrus Logic CS7401xx-IQZ Luminary Micro LM3S576x, LM3S5752, LM3S5747, LM3S573x, LM3S5662, LM3S5652, LM3S5632, LM3S3759, LM3S3749, and LM3S3739 NXP LPC32XX and LPC2460 STMicroelectronics STR912FAZ4X, STR912FAW4X, STR911FAW4X, STR911FAM4X, STR910FAW32, and STR910FAZ32 2.修改了NXP LPC23XX/24XX的頭文件庫 3.增加了ST-LINK II的調試支持 4.增加了對Cortex-M3 內核芯片的RTX Event Viewer 的支持 5.增加了MCBSTM32: STM32 FLASH OPTION BYTES PROGRAMMING 6.增加了ULINK2對Cortex-M3的SWV功能的調試 7.增強了使用GNU在MDK下調試M1,M3,ARM7,ARM9的調試功能( Using μVision with CodeSourcery GNU ARM Toolchain.) 8.增加了大量經典開發板例程 Boards目錄列表: ├─Embest 深圳市英蓓特公司開發板例程 │ ├─AT91EB40X-40008 │ ├─S3CEB2410 │ ├─ATEBSAM7S │ ├─LPC22EB06-I │ ├─LPCEB2000-A │ ├─LPCEB2000-B │ ├─LPCEB2000-S │ ├─str710 │ ├─str711 │ ├─str730 │ ├─str750 │ ├─STR912 │ ├─STM32V100 │ ├─STM32R100 │ ├─ATEB9200 ├─ADI ADI半導體的芯片例程 │ ├─ADuC702X │ └─ADuC712x ├─Atmel Atmel半導體的芯片例程 │ ├─AT91RM9200-EK │ ├─AT91SAM7A3-EK │ ├─AT91SAM7S-EK │ ├─AT91SAM7SE-EK │ ├─AT91SAM7X-EK │ ├─AT91SAM9260-EK │ ├─AT91SAM9261-EK │ ├─AT91SAM9263-EK ├─Keil Keil公司的開發板例程 │ ├─MCB2100 │ ├─MCB2103 │ ├─MCB2130 │ ├─MCB2140 │ ├─MCB2300 │ ├─MCB2400 │ ├─MCB2900 │ ├─MCBLM3S │ ├─MCBSTM32 │ ├─MCBSTR7 │ ├─MCBSTR730 │ ├─MCBSTR750 │ └─MCBSTR9 ├─Luminary Luminary半導體公司的芯片例程 │ ├─ek-lm3s1968 │ ├─ek-lm3s3748 │ ├─ek-lm3s3768 │ ├─dk-lm3s101 │ ├─dk-lm3s102 │ ├─dk-lm3s301 │ ├─dk-lm3s801 │ ├─dk-lm3s811 │ ├─dk-lm3s815 │ ├─dk-lm3s817 │ ├─dk-lm3s818 │ ├─dk-lm3s828 │ ├─ek-lm3s2965 │ ├─ek-lm3s6965 │ ├─ek-lm3s811 │ └─ek-lm3s8962 ├─NXP NXP半導體公司的芯片例程 │ ├─LH79524 │ ├─LH7A404 │ └─SJA2510 ├─OKI OKI半導體公司的芯片例程 │ ├─ML674000 │ ├─ML67Q4003 │ ├─ML67Q4051 │ ├─ML67Q4061 │ ├─ML67Q5003 │ └─ML69Q6203 ├─Samsung Samsung半導體公司的芯片例程 │ ├─S3C2440 │ ├─S3C44001 │ └─S3F4A0K ├─ST ST半導體公司的芯片例程 │ ├─CQ-STARM2 │ ├─EK-STM32F │ ├─STM32F10X_EVAL │ ├─STR710 │ ├─STR730 │ ├─STR750 │ ├─STR910 │ └─STR9_DONGLE ├─TI TI半導體公司的芯片例程 │ ├─TMS470R1A256 │ └─TMS470R1B1M ├─Winbond Winbond半導體公司的芯片例程 │ └─W90P710 └─ ...
上傳時間: 2013-10-13
上傳用戶:zhangliming420
The main objective of this book is to present all the relevant informationrequired for RF and micro-wave power amplifier design includingwell-known and novel theoretical approaches and practical design techniquesas well as to suggest optimum design approaches effectively combininganalytical calculations and computer-aided design. This bookcan also be very useful for lecturing to promote the analytical way ofthinking with practical verification by making a bridge between theoryand practice of RF and microwave engineering. As it often happens, anew result is the well-forgotten old one. Therefore, the demonstrationof not only new results based on new technologies or circuit schematicsis given, but some sufficiently old ideas or approaches are also introduced,that could be very useful in modern practice or could contributeto appearance of new ideas or schematic techniques.
標簽: Amplifier Microwave Design Power
上傳時間: 2013-12-22
上傳用戶:vodssv
The NXP LPC314x combine a 270 MHz ARM926EJ-S CPU core, High-speed USB 2.0OTG, 192 KB SRAM, NAND flash controller, flexible external bus interface, three channel10-bit A/D, and a myriad of serial and parallel interfaces in a single chip targeted atconsumer, industrial, medical, and communication markets. To optimize system powerconsumption, the LPC314x have multiple power domains and a very flexible ClockGeneration Unit (CGU) that provides dynamic clock gating and scaling.
上傳時間: 2013-10-11
上傳用戶:yuchunhai1990
The LPC1850/30/20/10 are ARM Cortex-M3 based microcontrollers for embeddedapplications. The ARM Cortex-M3 is a next generation core that offers systemenhancements such as low power consumption, enhanced debug features, and a highlevel of support block integration.The LPC1850/30/20/10 operate at CPU frequencies of up to 150 MHz. The ARMCortex-M3 CPU incorporates a 3-stage pipeline and uses a Harvard architecture withseparate local instruction and data buses as well as a third bus for peripherals. The ARMCortex-M3 CPU also includes an internal prefetch unit that supports speculativebranching.The LPC1850/30/20/10 include up to 200 kB of on-chip SRAM data memory, a quad SPIFlash Interface (SPIFI), a State Configuration Timer (SCT) subsystem, two High-speedUSB controllers, Ethernet, LCD, an external memory controller, and multiple digital andanalog peripherals.
標簽: Cortex-M 1850 LPC 內核微控制器
上傳時間: 2014-12-31
上傳用戶:zhuoying119
The LPC4350/30/20/10 are ARM Cortex-M4 based microcontrollers for embeddedapplications. The ARM Cortex-M4 is a next generation core that offers systemenhancements such as low power consumption, enhanced debug features, and a highlevel of support block integration.The LPC4350/30/20/10 operate at CPU frequencies of up to 150 MHz. The ARMCortex-M4 CPU incorporates a 3-stage pipeline, uses a Harvard architecture withseparate local instruction and data buses as well as a third bus for peripherals, andincludes an internal prefetch unit that supports speculative branching. The ARMCortex-M4 supports single-cycle digital signal processing and SIMD instructions. Ahardware floating-point processor is integrated in the core.The LPC4350/30/20/10 include an ARM Cortex-M0 coprocessor, up to 264 kB of datamemory, advanced configurable peripherals such as the State Configurable Timer (SCT)and the Serial General Purpose I/O (SGPIO) interface, two High-speed USB controllers,Ethernet, LCD, an external memory controller, and multiple digital and analog peripherals
上傳時間: 2013-10-28
上傳用戶:15501536189
The NXP LPC315x combine an 180 MHz ARM926EJ-S CPU core, High-speed USB 2.0OTG, 192 KB SRAM, NAND flash controller, flexible external bus interface, an integratedaudio codec, Li-ion charger, Real-Time Clock (RTC), and a myriad of serial and parallelinterfaces in a single chip targeted at consumer, industrial, medical, and communicationmarkets. To optimize system power consumption, the LPC315x have multiple powerdomains and a very flexible Clock Generation Unit (CGU) that provides dynamic clockgating and scaling.The LPC315x is implemented as multi-chip module with two side-by-side dies, one fordigital fuctions and one for analog functions, which include a Power Supply Unit (PSU),audio codec, RTC, and Li-ion battery charger.
上傳時間: 2014-01-17
上傳用戶:Altman
《西門子系列PLC原理及應用》共有8章,第1章介紹了PLC的基本組成與工作原理;第2章介紹了西門子S7-200系列PLC的構成、性能及其工作方式;第3章詳細地介紹了S7-200系列PLC專用編程軟件STEP 7-Micro/WIN的主要功能與使用方法;第4~5章,結合實例介紹S7-200系列PLC的基本命令與功能命令;第6章講述了S7-200系列PLC的網絡通信知識與命令;第7章講述了PLC控制系統的總體設計方法,并由淺入深地介紹了8個控制系統設計實例;第8章介紹了西門子S7-200系列PLC的安裝與維護。
上傳時間: 2013-12-31
上傳用戶:stampede
蟲蟲下載站版權所有 京ICP備2021023401號-1